Használati útmutató Axton ATB120QBA

Axton mélynyomó ATB120QBA

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Axton ATB120QBA (12 oldal) a mélynyomó kategóriában. Ezt az útmutatót 2 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/12
INSTALLATION & OPERATION MANUAL
EINBAU & BEDIENUNGSANLEITUNG
8"/ 20 CM ACTIVE SUBWOOFER
ATB120QBA
– 2 –
Dear Customer
Thank you and congratulations on your purchase of the AXTON ATB120QBA. This active
subwoofer system exclusively uses very high quality parts and components. As with all
high-quality car audio components, professional installation is highly recommended.
If you plan on installing this active subwoofer by yourself, please read the following
installation guide carefully, before you attempt the installation. You should retain this manual,
the packaging and the purchasing receipt for future reference. For any further additional
information about mounting, connecting or adjusting this subwoofer system, please contact
your AXTON dealer.
UNPACKING THE SYSTEM
Carefully remove all parts from the giftbox and check whether they are in good undamaged
condition, and match with the set contents listed below:
nATB120QBA active subwoofer
nConnector
nOwner‘s manual
Please contact your authorized AXTON dealer, if the content of this set is incomplete,
or parts of it show signs of transport damage.
SPECIFICATIONS
n 8" / 20 cm active subwoofer
n Frequency response: 60 – 200 Hz
n 100 W rms x 1 @ 4 ohms (< 1.0 % THD / 14.4V)
n Variablelowpasslter:50–150Hz/12dB/oct.
n Bass-Boost: 0 dB - 12 dB
n RCA,adjustableinputsensitivity:150mV–5V
n High-Level, adjustable input sensitivity: 1.0 V – 16 V
n Signal to noise ratio: > 90 dB
n Dimensions H x W x D: 185x365x265mm
n Net Weight: 7.3 kg
– 4 –
SAFETY INSTRUCTIONS
1. This unit is designed to be used in a vehicle with a 12V battery and negative ground.
2. Before any wiring, always remove the negative terminal of the battery to prevent short-
circuiting. This is also the last lead to be (re-)connected.
3. Do not disassemble or alter the unit in any way, because that will void your warranty. Do
not attempt to repair or to service the unit yourself, but contact an authorized AXTON
dealer instead.
4. Use only original accessories which are designed and manufactured for the unit,
otherwise you will risk damage. Install the unit according to the mounting manual and
use only the supplied mounting accessories. The forces of acceleration for accidents are
sometimes huge. Heavy objects may pose a risk for the driver and the passengers of the
car, during an accident.
 5.Protecttheunitfromwaterandotherliquids,whichcanenterthecasing.Ashortcircuit
or even fire could be the result.
6. Before you replace a defective fuse, try to find the cause for the short circuit. Please
pay attention to the cables of the power supply! If the short circuit doesn‘t result from a
failure of the power supply or wiring, you can replace the defective fuse with a new one
of identical value. If the short-circuit still exists, please contact an authorized AXTON
dealer.
7. Be careful not to drain the car battery while using the unit when the car engine is turned
off. Because the unit uses a considerable amount of energy and the battery will be
charged only while the engine is running, it might happen that the battery will discharge
to a point where it‘s not longer possible to start the engine.
8. If your car is parked in direct sunlight and there is a considerable rise in temperature
inside the car, allow the unit to cool off before operation.
9. The amplifier module employs a protection circuit to protect the transistors and the
woofer if the amplifier malfunctions. The amplifier’s protection circuitry will shut-off the
amplifier in case of short-circuit, overload or DC offset at the speaker outputs or in case
of overheat. In case the cause for protection shut-off has been eliminated, the amplifier
will operate normally again (green LED ON/ Red LED OFF). Otherwise the amplifier will
continue to remain in protection mode.
10. Do not use the unit with a weak or old battery as its optimum performance depends on
a normal battery supply voltage.
11. Please pay attention to the music playback volume inside your vehicle, because you are
obliged to notice exterior sounds like a police siren or you might face penalties in case
of an accident or even loose your insurance cover.
12. Do not operate the unit in no other way than described in this manual. Failure to follow
the instructions within this manual will void your warranty.

Termékspecifikációk

Márka: Axton
Kategória: mélynyomó
Modell: ATB120QBA

Szüksége van segítségre?

Ha segítségre van szüksége Axton ATB120QBA, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók mélynyomó Axton

Axton

Axton ATB120 Útmutató

29 December 2024
Axton

Axton ATB220 Útmutató

4 Szeptember 2024
Axton

Axton ATB20A Útmutató

26 Augusztus 2024
Axton

Axton ATB216 Útmutató

17 Augusztus 2024
Axton

Axton ATB20STP Útmutató

16 Augusztus 2024
Axton

Axton AXB20A Útmutató

15 Augusztus 2024
Axton

Axton ATW20 Útmutató

15 Augusztus 2024
Axton

Axton AXB25A Útmutató

7 Július 2024
Axton

Axton ATB20RXF Útmutató

7 Július 2024
Axton

Axton ATB120QBA Útmutató

7 Július 2024

Útmutatók mélynyomó

Legújabb útmutatók mélynyomó

Wet Sounds

Wet Sounds ZERO 10 S4 XZ-W Útmutató

2 Április 2025
SoundTube

SoundTube CM1001D Útmutató

2 Április 2025
JL Audio

JL Audio FS108-W5 Útmutató

31 Március 2025
Phase Technology

Phase Technology PL-12p Útmutató

30 Március 2025
ETON

ETON Graphit 8-2 Útmutató

19 Március 2025
ETON

ETON Graphit 8-4 Útmutató

19 Március 2025
ETON

ETON Graphit 10-4 Útmutató

19 Március 2025
ETON

ETON MW 10 FLAT Útmutató

19 Március 2025
ETON

ETON PW 8 Útmutató

19 Március 2025
ETON

ETON USB 6 AR Útmutató

19 Március 2025