Használati útmutató Indesit Maxi PWE 8128 W (EU)

Indesit mosógép Maxi PWE 8128 W (EU)

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Indesit Maxi PWE 8128 W (EU) (48 oldal) a mosógép kategóriában. Ezt az útmutatót 3 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/48
1
GB
English,1
GB
WASHING MACHINE
Contents
Installation, 2-3
Unpacking and levelling
Connecting the electricity and water supplies
The first wash cycle
Technical data
Description of the washing machine, 4-5
Control panel
Display
Running a wash cycle, 6
Wash cycles and options, 7
Table of programmes and wash cycles
Wash options
Detergents and laundry, 8
Detergent dispenser drawer
Preparing the laundry
Special wash cycles
Precautions and advice, 9
General safety
Disposal
Opening the porthole door manually
Care and maintenance, 10
Cutting off the water and electricity supplies
Cleaning the washing machine
Cleaning the detergent dispenser drawer
Cleaning the pump
Checking the water inlet hose
Troubleshooting, 11
Service, 12
PWE 8128 W
Instructions for use
ÅËËÇÍÉÊÁ,13
GR
Español,25
ES
PT
Português,37
2
GB
Installation
This instruction manual should be kept in a safe place
for future reference. If the washing machine is sold,
transferred or moved, make sure that the instruction
manual remains with the machine so that the new
owner is able to familiarise himself/herself with its
operation and features.
Read these instructions carefully: they contain vital
information relating to the safe installation and operation
of the appliance.
Unpacking and levelling
Unpacking
1. Remove the washing machine from its packaging.
2. Make sure that the washing machine has not been
damaged during the transportation process. If it has
been damaged, contact the retailer and do not proceed
any further with the installation process.
3. Remove the 4
protective screws (used
during transportation) and
the rubber washer with
the corresponding spacer,
located on the rear part of
the appliance (see figure).
4. Close off the holes using the plastic plugs provided.
5. Keep all the parts in a safe place: you will need them
again if the washing machine needs to be moved to
another location.
Packaging materials should not be used as toys for
children.
Levelling
1. Install the washing machine on a flat sturdy floor,
without resting it up against walls, furniture cabinets or
anything else.
2. If the floor is not
perfectly level,
compensate for any
unevenness by tightening
or loosening the adjustable
front feet (see figure); the
angle of inclination,
measured in relation to the
worktop, must not exceed
2°.
Levelling the machine correctly will provide it with
stability, help to avoid vibrations and excessive noise and
prevent it from shifting while it is operating. If it is placed
on carpet or a rug, adjust the feet in such a way as to
allow a sufficient ventilation space underneath the
washing machine.
Connecting the electricity and water
supplies
Connecting the water inlet hose
1. Connect the inlet hose
by screwing it to a cold
water tab using a 3/4 gas
threaded connection (see
figure).
Before performing the
connection, allow the
water to run freely until it is
perfectly clear.
2. Connect the inlet hose
to the washing machine
by screwing it onto the
corresponding water inlet
of the appliance, which is
situated on the top right-
hand side of the rear part
of the appliance (see
figure).
3. Make sure that the hose is not folded over or bent.
The water pressure at the tap must fall within the
range of values indicated in the Technical data table (see
next page).
If the inlet hose is not long enough, contact a
specialised shop or an authorised technician.
Never use second-hand hoses.
Use the ones supplied with the machine.
3
GB
Connecting the drain hose
Connect the drain hose,
without bending it, to a
drain duct or a wall drain
situated between 65 and
100 cm from the floor;
alternatively, place it
over the edge of a
basin, sink or tub,
fastening the duct
supplied to the tap (see
figure). The free end of
the hose should not be
underwater.
We advise against the use of hose extensions; if it is
absolutely necessary, the extension must have the
same diameter as the original hose and must not
exceed 150 cm in length.
Electrical connections
Before plugging the appliance into the electricity
socket, make sure that:
the socket is earthed and complies with all
applicable laws;
the socket is able to withstand the maximum
power load of the appliance as indicated in the
Technical data table (see opposite);
the power supply voltage falls within the values
indicated in the Technical data table (see opposite);
the socket is compatible with the plug of the
washing machine. If this is not the case, replace the
socket or the plug.
The washing machine must not be installed
outdoors, even in covered areas. It is extremely
dangerous to leave the appliance exposed to rain,
storms and other weather conditions.
When the washing machine has been installed, the
electricity socket must remain within easy reach.
Do not use extension cords or multiple sockets.
65 - 100 cm
The cable should not be bent or compressed.
The power supply cable must only be replaced by
authorised technicians.
Warning! The company shall not be held responsible
in the event that these standards are not observed.
The first wash cycle
Once the appliance has been installed, and before you
use it for the first time, run a wash cycle with
detergent and no laundry, using wash cycle number 2.
Technical data
Model PWE 8128 W
Dimensions
width 59.5 cm
height 85 cm
depth 62 cm
Capacity between 1 and 8 kg
Electrical
connections
please refer to the technical data
plate applied to the machine
Water connections
maximum pressure 1 MPa (10 bar
)
minimum pressure 0.05 MPa
(0.5 bar)
drum capacity 62 litres
Spin speed up to 1200 rpm
Test wash cycles
in compliance with
regulation
EN 60456
wash cycle 2; temperature 60°C;
performed with a 8 kg load.
This appliance conforms to the
following European Community
directives:
- 89/336/EEC dated 03.05.89
(Electromagnetic Compatibility)
and subsequent amendments
- 2006/95/EC – 2006/95/EC (Low
Voltage)

Termékspecifikációk

Márka: Indesit
Kategória: mosógép
Modell: Maxi PWE 8128 W (EU)

Szüksége van segítségre?

Ha segítségre van szüksége Indesit Maxi PWE 8128 W (EU), tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók mosógép Indesit

Indesit

Indesit iwdc 6145 s Útmutató

2 Április 2025
Indesit

Indesit IM 760 MY TIME IT Útmutató

27 Március 2025
Indesit

Indesit iwc 7105 Útmutató

21 Március 2025
Indesit

Indesit PWE 81271 W Útmutató

16 Január 2025
Indesit

Indesit widxxl 106 eu Útmutató

16 Január 2025
Indesit

Indesit sixl 145 Útmutató

16 Január 2025
Indesit

Indesit WIN 101 Útmutató

16 Január 2025
Indesit

Indesit iwd 7125 fr Útmutató

16 Január 2025
Indesit

Indesit w 165 Útmutató

16 Január 2025
Indesit

Indesit WN480XWI Útmutató

16 Január 2025

Útmutatók mosógép

Legújabb útmutatók mosógép

Whirlpool

Whirlpool awm 8143 Útmutató

2 Április 2025
Bauknecht

Bauknecht wa 1209 stuttgart Útmutató

2 Április 2025
Whirlpool

Whirlpool awe 8722 Útmutató

2 Április 2025
Balay

Balay 3TS864B Útmutató

2 Április 2025
Novamatic

Novamatic WT1207 Útmutató

2 Április 2025
Whirlpool

Whirlpool awoe 7749 carisma Útmutató

2 Április 2025
Hotpoint Ariston

Hotpoint Ariston artxd 149 Útmutató

2 Április 2025
Foron

Foron WK1293 Vitatop Útmutató

2 Április 2025
Samsung

Samsung WA51DG5505AW Útmutató

2 Április 2025
EBD

EBD A2580F A2586F A2588F Classic Útmutató

2 Április 2025