Használati útmutató Indesit sixl 145

Indesit mosógép sixl 145

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Indesit sixl 145 (16 oldal) a mosógép kategóriában. Ezt az útmutatót 2 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/16
GB
GB
1
English,1
Contents
Installation, 2-3-4-5
Unpacking and levelling
Connecting the electricity and water supplies
Technical details
Description of the machine, 6-7
Self-cleaning detergent dispenser drawer
Control panel
Load balancing system
Running a wash cycle, 8
Wash programmes, 9
Detergents and laundry, 10
Preparing the laundry
Washing recommendations
Precautions and advice, 11
General safety
Disposal
Saving energy and respecting the environment
Drip-tray system
Care and maintenance, 12
Cutting off the water or electricity supply
Cleaning the machine
Cleaning the detergent dispenser drawer
Caring for the door and drum of your appliance
Cleaning the pump
Checking the water inlet hose
Troubleshooting, 13
Service and Guarantee, 14-15-16
Before calling for Assistance
Guarantee
WASHING MACHINE
SIXL 145
Instructions for use
GB
2
GB
Installation
Keep this instruction manual in a safe place for
future reference. Should the appliance be sold,
transferred or moved, make sure the instruction
manual accompanies the washing machine to inform
the new owner as to its operation and features.
Read these instructions carefully: they contain vital
information on installation, use and safety.
Unpacking and levelling
Unpacking
1. Unpack the washing machine.
2. Check whether the washing machine has been
damaged during transport. If this is the case, do not
install it and contact your retailer.
3. Remove the 4
protective screws and
the rubber bush with
the respective spacer,
situated on the rear of
the appliance (see also
the installation leaflet).
NB: The plastic spacers
may fall down inside the
machine once the bolt
has been removed, and will not interfere with the
operation of the machine.
4. Seal the gaps using the plastic plugs provided.
5. Keep all the parts: you will need them again if the
washing machine needs to be moved to another
location.
Packaging materials are not children's toys.
Levelling
Your machine may make a considerable amount of noise
if the two front feet have not been adjusted correctly.
1. Install the washing machine on a flat sturdy floor,
without resting it up against walls, furniture cabinets
or other.
2. If the floor is not
perfectly level, compen-
sate for any unevenness
by tightening or
loosening the adjustable
front feet (see figure);
the angle of inclination,
measured according to
the worktop, must not
exceed 2°.
Levelling your appliance correctly will provide it with
stability and avoid any vibrations, noise and shifting
during operation. If it is placed on a fitted or loose
carpet, adjust the feet in such a way as to allow
enough room for ventilation beneath the washing
machine.
Electric and water connections
Connecting the water inlet hose
1. Insert seal A into the
end of the inlet hose
and screw the latter
onto a cold water tap
with a 3/4 gas threaded
mouth (see figure).
Before making the
connection, allow the
water to run freely until
it is perfectly clear.
2. Connect the other end
of the water inlet hose to
the washing machine,
screwing it onto the
appliance's cold water
inlet, situated on the top
right-hand side on the
rear of the appliance
(see figure).
3. Make sure there are no kinks or bends in the
hose.
The water pressure at the tap must be within the
values indicated in the Technical details table
(on the next page).
If the water inlet hose is not long enough, contact
a specialist store or an authorised serviceman.
Ensure that the supply taps are allowing water
through. Old taps may seize in the closed position
and thus prevent water reaching the machine.
A
GB
GB
3
Connecting the drain hose
Connect the drain hose,
without bending it, to a
draining duct or a wall
drain situated between
65 and 100 cm from
the floor;
The drain hose may be
connected to an
under-sink trap. Before
connecting the drain
hose from the machine
ensure that any blanks
or removable ends
have been taken off
the spigot.
If it is place over the
edge of a basin or sink
be sure the free end of
the hose should not be
underwater.
We advise against the use of hose extensions; in
case of absolute need, the extension must have the
same diameter as the original hose and must not
exceed 150 cm in length.
Ensure that if the drain hose is pushed into a
standpipe, that the end does not go down more
than 15cms (6 inches). If the hose is pushed down
too far, this may cause the machine to self -syphon
ie. continuously empty as it is filling.
Electric connection
Before plugging the appliance into the mains
socket, make sure that:
the socket is earthed and in compliance with the
applicable law;
the socket is able to sustain the appliance's
maximum power load indicated in the Technical
details table (see page 5);
the supply voltage is included within the values i
ndicated on the Technical details table
(see page 5);
the socket is compatible with the washing
machine's plug. If this is not the case, replace
the socket or the plug.
Your appliance is now supplied with a 13 amp fused
plug it can be plugged into a 13 amp socket for
immediate use. Before using the appliance please
read the instructions below.
WARNING - THIS APPLIANCE MUST BE EARTHED.
THE FOLLOWING OPERATIONS SHOULD BE
CARRIED OUT BY A QUALIFIED ELECTRICIAN.
Replacing the fuse:
When replacing a faulty fuse, a 13 amp ASTA
approved fuse to BS 1362 should always be used,
and the fuse cover re-fitted. If the fuse cover is lost,
the plug must not be used until a replacement is
obtained.
Replacement fuse covers:
If a replacement fuse cover is fitted, it must be of
the correct colour as indicated by the coloured
marking or the colour that is embossed in words on
the base of the plug. Replacements can be obtained
directly from your nearest Service Depot.
Removing the plug:
If your appliance has a non-rewireable moulded plug
and you should wish to re-route the mains cable
through partitions, units etc., please ensure that
either:
the plug is replaced by a fused 13 ampere re-
wearable plug bearing the BSI mark of approval.
or:
the mains cable is wired directly into a 13 amp cable
outlet, controlled by a switch, (in compliance with
BS 5733) which is accessible without moving the
appliance.
Disposing of the plug:
Ensure that before disposing of the plug itself, you
make the pins unusable so that it cannot be
accidentally inserted into a socket.
Instructions for connecting cable to an alternative plug:
Important: the wires in the mains lead are coloured
in accordance with the following code:
Green & Yellow Earth
Blue Neutral
Brown Live
65 - 100 cm

Termékspecifikációk

Márka: Indesit
Kategória: mosógép
Modell: sixl 145

Szüksége van segítségre?

Ha segítségre van szüksége Indesit sixl 145, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók mosógép Indesit

Indesit

Indesit PWE 81271 W Útmutató

16 Január 2025
Indesit

Indesit widxxl 106 eu Útmutató

16 Január 2025
Indesit

Indesit sixl 145 Útmutató

16 Január 2025
Indesit

Indesit WIN 101 Útmutató

16 Január 2025
Indesit

Indesit iwd 7125 fr Útmutató

16 Január 2025
Indesit

Indesit w 165 Útmutató

16 Január 2025
Indesit

Indesit WN480XWI Útmutató

16 Január 2025
Indesit

Indesit lna 1000 Útmutató

15 Január 2025
Indesit

Indesit wia 600 Útmutató

15 Január 2025
Indesit

Indesit wite 127 Útmutató

14 Január 2025

Útmutatók mosógép

Legújabb útmutatók mosógép

Beko

Beko WMB 71443 PTENC Útmutató

16 Január 2025
Whirlpool

Whirlpool AWE 5125 Útmutató

16 Január 2025
Whirlpool

Whirlpool AWO 7648 Útmutató

16 Január 2025
Bauknecht

Bauknecht Excellence 4580 Útmutató

16 Január 2025
Ariston

Ariston AV61 Útmutató

16 Január 2025
Whirlpool

Whirlpool awm 5090 Útmutató

16 Január 2025
AEG-Electrolux

AEG-Electrolux L98485FL Útmutató

16 Január 2025
Whirlpool

Whirlpool awm 4100 Útmutató

16 Január 2025
Bauknecht

Bauknecht WA 745 S Útmutató

16 Január 2025
Bauknecht

Bauknecht WAT CARE 30SD Útmutató

16 Január 2025