Használati útmutató Sanyo LNS-T02E

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Sanyo LNS-T02E (4 oldal) a Projektor tartozék kategóriában. Ezt az útmutatót 4 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/4
PARTS LIST
Following parts are contained in the packing.
· LENS
· LENS MOUNTING SCREWS
· DRIVER
· LIGHT-BLOCK SHEET
· LENS COVER (UPPER · LOWER )
NOTES ON LENS INSTALLATION
LCD PROJECTOR LENS
MODEL NO. LNS-W02/T02
LNS-W02K/T02K Series
Lens installation should be performed by the qualified service personnel.
It should be followed by this procedure precisely.
Before attempt to install the lens, confirm the model number (both the LCD
projector and the lens) and use the proper lens.
If you have any questions, contact to the dealers.
Following checks and confirmations should be taken for safety.
Check the following things by the time of the cabinet assembly after the
lens installation.
1. Confirm the lens is securely fixed by 4 screws.
2. Wiring must not be tangled in the gear of the lens motor or the other
mechanical part.
3. There is no missing part, or no loosing mounting part.
1AA6P1P2289-- (ICSC)
1 piece
6 screws (2 for spare)
1 piece
1 sheet
1 set
LENS REPLACEMENT AND
INSTALLATION PROCEDURE
LENS REPLACEMENT AND INSTALLATION PROCEDURE
Remove screws A (2 screws).
Pull down the lower lens cover while pushing
the part D, then remove it.
Remove screws B (2 screws).
Remove screws C (2 screws) and remove
upper lens cover.
1 5Perform the steps for lens replacement and installation.to
1
1.
2.
A
Fig-1
Fig-3
IN CASE OF MODEL WITHOUT LENS
Remove 2 screws and pull down the plate.
2
3.
4.
UPPER LENS COVER
LOWER LENS COVER
C
B
D
D
COVER PLATE
REMOVE THE LENS COVER.
(At the step , insert the light-block sheet in the same
position as the removed cover plate has been placed.
Two screws are not used.)
Use the light-block sheet included with lens.
5
REMOVE THE COVER PLATE OF THE LENS COVER. (See figure-3)
Set the light-block
sheet, so that the
large rounder side
is set over the lens.
SCREWS
LIGHT-BLOCK SHEET
Fig-2
LENS COVER
Remove 4 screws of the lens cover and
remove the lens cover.
First, set the lens at the center position with
lens shift button.
First check the shape of cabinet.
In case figure-1 cabinet.
In case figure-2 cabinet.
LENS MOTOR LEAD
CONNECTOR K16B
(D)
(D)(D)
(D)
C
LENS MOTOR
Figure shown inside of the cabinet.
REMOVE THE LENS. (See figure-4)
1. Remove the connector “K16B” of the
circuit board.
2. Loosen the A, B, C wire holder and
remove the lens motor lead.
3. Remove screws D (4 screws) which
fastens the lens and remove the lens.
IN CASE OF MODEL WITH LENS
B
ATTACHED DRIVER
Fig-5
LENS MOUNTING BRACKET
LENS MOTOR LEAD
CONNECTOR K16B
(D)
(D)(D)
(D)
B
A
LENS MOTOR
Fig-4
This part wiring should
not be tightened.
C
A
INSTALL THE LENS. (See figure-4,5)
3
1. Remove protective caps (front
and back ) on the lens.
2. Mount the lens at the lens
mounting bracket with screws
(4 screws) included with the
lens. Use the driver included
with the lens to fasten the
screws . (After using, save it for
latter use.) (See figure-5)
3. Connect the lens motor lead to
the connector “K16B” of the
circuit board. (See figure-4)
4. Fasten the lens motor lead at
the A, B, C points with wire
holder.
(See figure-4)

Termékspecifikációk

Márka: Sanyo
Kategória: Projektor tartozék
Modell: LNS-T02E

Szüksége van segítségre?

Ha segítségre van szüksége Sanyo LNS-T02E, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók Projektor tartozék Sanyo

Sanyo

Sanyo LNS-M02 Útmutató

25 Július 2024
Sanyo

Sanyo LNS-T02E Útmutató

24 Július 2024
Sanyo

Sanyo LNS-S04 Útmutató

20 Július 2024
Sanyo

Sanyo POA-FIL131 Útmutató

17 Július 2024

Útmutatók Projektor tartozék

Legújabb útmutatók Projektor tartozék

Metronic

Metronic 451073 Útmutató

27 Március 2025
Vogel's

Vogel's PPC 1585 Útmutató

27 Március 2025
Barco

Barco R9853370 Útmutató

14 Január 2025
Vogel's

Vogel's PPA 904 Útmutató

10 Január 2025
Chief

Chief RPMC198 Útmutató

1 Január 2025
Chief

Chief RPMA360 Útmutató

1 Január 2025
Chief

Chief RSMA342 Útmutató

1 Január 2025
Chief

Chief RSMA360 Útmutató

1 Január 2025
Chief

Chief RPMC266 Útmutató

1 Január 2025