Használati útmutató Samsung DV42H5000G

Samsung mosógép DV42H5000G

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Samsung DV42H5000G (36 oldal) a mosógép kategóriában. Ezt az útmutatót 3 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/36
1
CLOTHES DRYER
Technical Information
CAUTION
All safety information must be followed as provided in Service Manual of DV45H*, DV42H*.
WARNING
To avoid risk of electrical shock, personal injury or death; disconnect power to dryer
before servicing, unless testing requires power.
Code No. : DC68-03382A_EN
IMPORTANT SAFETY NOTICE – “For Technicians only” This service data sheet is intended for
use by persons having electrical, electronic, and mechanical experience and knowledge at a level
generally considered acceptable in the appliance repair trade. Any attempt to repair a major
appliance may result in personal injury and property damage. The manufacturer or seller cannot
be responsible, nor assume any liability for injury or damage of any kind arising from the use of
this data sheet.
• Due to possibility of personal injury or property damage, always contact an authorized
technician for servicing or repair of this unit.
• Refer to Service Manual (DV45H*, DV42H*) for detailed installation, operating, testing,
troubleshooting, and disassembly instructions.
Technical_information-03382A_EN_131209.indd 1 2013-12-09 �� 5:37:30
2
ERROR ITEMS AND DIAGNOSTIC CODES
An occurrence of an Error will make a sound of error melody for 5sec and continuously show one
of the Error Displays from the following errors.
Error Display Trigger Action Taken
tE The Thermistor resistance is very low or
high.
Check for:
- Clogged lint screen.
- Restricted vent system.
- Check Thermistor resistance.
dE Running the dryer with door open
Check for:
- Close the door, and run the dryer.
- Loose or open wire terminals in Door
Sense circuit.
dF Invalid Door Switch
Check for:
- Loose or open wire terminals in Door
Sense circuit.
bE2 Invalid state of key. Check for:
- Display PCB key circuit short or not.
FE Invalid power source Frequency
Check for:
- Not using regular power source
frequency
- Invalid power frequency sense circuit
9E1 Electronic Control Problem
(Over Voltage Error)
Check for:
- Check PCB and Wire harness.
- Check Power supply.
AE Electronic Control Problem
(Communication Error)
Check for:
- Check PCB and Wire harness.
- Replace PCB.
EEE Invalid state of Eeprom communication Check for :
- PCB with Eeprom circuit.
HE Invalid heating Temp in running the dryer Call customer service
ALIGNMENT AND ADJUSTMENTS
WARNING
To avoid risk of electrical shock, personal injury or death; disconnect power to dryer before
servicing, unless testing requires power.
Technical_information-03382A_EN_131209.indd 2 2013-12-09 �� 5:37:30
3
TEST MODE
Data Display Mode
How to Enter:
- Drylevel In normal mode, press Time Temp in less than 2 seconds to enter the Time
display mode.
- To change the mode, use the cycle selector dial.
Definition of Data Display Mode:
- Display Mode 1 : Main micom version
- Display Mode 2 : display micom version
- Display Mode 3 : touch module version
- Display Mode 4 : option value
- Display Mode 5 : Temperature data
- Display Mode 6 : Average temperature data for 1 minute
- Display Mode 7 : Temperature data for detecting vent clog up
- Display Mode 8 : Average touch sensor data for 1 minute
- Display Mode 9 : cycle count
Smart Install
This allows service personnel to check if the dryer is installed properly.
To enter this mode
Turn on the product, and press and hold the key for 7 seconds.Adjust Time Up + Temp
A message of “SC” appears on the display.
1. Checking the touch sensor
Enter the Smart Install mode, and open the door. The state of the touch sensor appears on the
display.
0 : Touch sensor open
1 : Touch sensor short
Put a wet cloth on the touch sensor to display " ". Releasing it displays " ".1 0
2. Checking the motor and the heater
After checking the touch sensor is complete, press the Start button to enter the checking
mode. When the checking is complete, the results appear on the display.
OK : Both motor and heater work normally
HE : Motor or heater doesn't work normally
To exit the Smart Install mode, turn off the product.
Error Recall Mode
The Error Recall mode reminds users of the latest error that appeared.
Press and hold both the keys for more than 7 seconds to enter this mode.Wrinkle prevent + Dry Level
In the Error Recall mode, the most recent error that occurred is displayed. If there is no recent error,
nothing is displayed.
ALIGNMENT AND ADJUSTMENTS
WARNING
To avoid risk of electrical shock, personal injury or death; disconnect power to dryer before
servicing, unless testing requires power.
Technical_information-03382A_EN_131209.indd 3 2013-12-09 �� 5:37:31

Termékspecifikációk

Márka: Samsung
Kategória: mosógép
Modell: DV42H5000G

Szüksége van segítségre?

Ha segítségre van szüksége Samsung DV42H5000G, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók mosógép Samsung

Samsung

Samsung WA51DG5505AW Útmutató

2 Április 2025
Samsung

Samsung SW70B1IW Útmutató

28 Március 2025
Samsung

Samsung B1075TS Útmutató

28 Március 2025
Samsung

Samsung P1205J Útmutató

27 Március 2025
Samsung

Samsung h 1255 ags titanium Útmutató

21 Március 2025
Samsung

Samsung WD10T634DBN Útmutató

16 Március 2025
Samsung

Samsung WW60J3280HS Útmutató

16 Március 2025
Samsung

Samsung P1453S Útmutató

16 Január 2025
Samsung

Samsung J1255 Útmutató

16 Január 2025
Samsung

Samsung p 1453 gw Útmutató

16 Január 2025

Útmutatók mosógép

Legújabb útmutatók mosógép

Whirlpool

Whirlpool awm 8143 Útmutató

2 Április 2025
Bauknecht

Bauknecht wa 1209 stuttgart Útmutató

2 Április 2025
Whirlpool

Whirlpool awe 8722 Útmutató

2 Április 2025
Indesit

Indesit iwdc 6145 s Útmutató

2 Április 2025
Balay

Balay 3TS864B Útmutató

2 Április 2025
Novamatic

Novamatic WT1207 Útmutató

2 Április 2025
Whirlpool

Whirlpool awoe 7749 carisma Útmutató

2 Április 2025
Hotpoint Ariston

Hotpoint Ariston artxd 149 Útmutató

2 Április 2025
Foron

Foron WK1293 Vitatop Útmutató

2 Április 2025
EBD

EBD A2580F A2586F A2588F Classic Útmutató

2 Április 2025