Használati útmutató GPX TM35B=

Olvassa el alább 📖 a magyar nyelvű használati útmutatót GPX TM35B= (4 oldal) a Lapos panel támogatás kategóriában. Ezt az útmutatót 6 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/4
TilTing FlaT Panel TV MounT For 40-65” TeleVisions
Users Guide for Model No. TM35 v1381-01
STEP 1
Horizontal Base Plate
• AssembledHorizontalBasePlate.
NotemountingpointswhichwillbeusedforStep2.
Front Towards TV
Rear Towards Wall
Wall Mounting Points
• Concrete/Brickwallshown.Drillsixholesforsolidwallapplication.
• Usea3/8”or10mmdrillbit.
• Cutawayofdrywallwithstudsshownbehind.Drillfourholesforstud
application.UseastudndertolocateandONLY DRILL INTO STUDS!!
• Usea5/32”drillbit.
STEP 2
Pre-drill Holes for Base Plate
• DrillholesfortheBasePlatetoattachtothewall,usingexact
measurementsbasedonwhereyouwanttomounttheHorizontalBase
Plate.Onlydrillintoasolidwall,orstuds(behinddrywall).DO NOT
DRILL AND HANG THE BASE PLATE ON DRYWALL OR SHEETROCK.
ItisnotstrongenoughtosupportaTVandwillcausedamage.
WARNINGS
• ThewallmountedpartsoftheTVmountmustbermlyattachedtoa
concrete/brick/solidwoodwall,orwallstudsbehinddrywall.
• Tightenscrewssothatthewallplateisrmlyattached,butdonot
overtighten.Overtighteningcandamagethescrewsandincreasethe
chancesoffailure.
• Donotremoveorloosenanyscrewsuntiltheyarenolongerengaged
withthemount.Doingsomaycausethescreentofall.
• Itishighlyrecommendedtohavethismountprofessionallyinstalled.
• Supports VESA up to 600 x 400mm.
• This mount is designed to hold a maximum of 132 lbs (60 kg).
TOOLS
Thefollowingtoolsarerecommendedforthisinstallation:
• Drill
• 5/32drillbitfordrywall
• 3/8”or10mmdrillbitforconcrete
• Studnder
• Phillipsscrewdriver
PARTS
A x4
M8x15
x4B M6x15
x4C M5x15
x4D Ø5
x4E Ø6
x4F Ø8
Ø15xØ8x4.5 x4G
x1H
x2M
x2O M6x38
L x6
Ø10x50
x6K M6x50
x2I M6x10
x1J Mag Level
x2N M6x15
Horizontal Base Plate x1
x2I M6x10
x1H
Horizontal Base Plate x1
• Thehorizontalbaseplateisalreadypartiallyassembledfromthefactory.
Screwtheremainingverticalbarintothecentersectionofthebaseplate
asshown.Noteorientationofparts.
Note: Parts A-G are used to attach
your TV to the brackets in Step 4,
but you will not need all of them.
Find and use the set that best ts
your specic TV.
H
I
TilTing FlaT Panel TV MounT For 40-65” TeleVisions
Users Guide for Model No. TM35 v1381-01
STEP 4
Attach Brackets to Television
STEP 5
Attach Television to Wall
STEP 3
Attach Base Plate to Wall
• Tightenthetwosafetyscrewsonthebottomofthebracketuntilthey
are againstbaseplate.ThesescrewssecuretheTVtothebaseplateFIRM
andensureitwillnotmoveorshiftafterinstallation.
• AttachtheHorizontalBasePlatetothewallusingtheholesdrilledinStep
2.UsetheincludedleveltoensuretheHorizontalBasePlateiscorrectly
alignedandsquare.
• Ifattachingtoasolidwall,useallsixofPartsKandLtomount.If
attachingtostuds,usefour.
• InsertwallanchorsintotheholesdrilledinStep2,thenscrewthebase
platermlytothewallwiththesuppliedscrews.
x6K M6x50
x2M
x1J Mag Level
x2O M6x38
x2N M6x15
PARTS A G
L x6
Ø10x50
• Attachthetwobracketstotherearofyourtelevision,makingsurethe
clawofthebracketisintheupperposition.
• Usetheincludedscrewsandwashers(PartsA-F)tosecurethebracketto
yourTV.FindthesetthattsyourTVanddiscardtherest.
• Therubberwashers(PartG)canbeusedasaspacerbetween the TV
body and the mounting brackets, ifthemountingholesontheTVare
tooshallowfortheincludedscrews.
• AttachtheTV/bracketstotheHorizontalBasePlateonthewall,making
suretocatchthetopclawofthebracketontherimoftheupperbase
plate.Usethetwolongsafetyscrewstotightenthebracketstothebase.
• ItishighlyrecommendedtouseatleasttwopeopletohangtheTV.
I
!
!
!H
G
J
I
Screw & Washer
OPTIONAL
SPACER O
AF

Termékspecifikációk

Márka: GPX
Kategória: Lapos panel támogatás
Modell: TM35B=

Szüksége van segítségre?

Ha segítségre van szüksége GPX TM35B=, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók Lapos panel támogatás GPX

GPX

GPX TM15 Útmutató

31 Augusztus 2024
GPX

GPX TM35B= Útmutató

31 Augusztus 2024

Útmutatók Lapos panel támogatás

Legújabb útmutatók Lapos panel támogatás