Használati útmutató Genelec F Two

Genelec mélynyomó F Two

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Genelec F Two (14 oldal) a mélynyomó kategóriában. Ezt az útmutatót 2 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/14
F Two Operating Manual
操作手册
F Two Active Subwoofer
General description
The Genelec F Two is a very compact
active subwoofer designed to comple-
ment up to ve Genelec G One or G Two
active loudspeakers as a .1 / LFE channel
subwoofer in a 5.1 system or a pair of the
slightly bigger G Threes. Linked together
two F Two’s can also be used with G Fours.
The F Two extends the system’s bass
response down to 27 Hz and integrates
perfectly with the main loudspeakers in
any environment. The playback level for the
whole system is conveniently controlled by
the wireless volume control provided with
the subwoofer. A wired volume control is
available as an option.
The F Two has integrated bass manage-
ment for the two output channels which
directs frequencies below 85 Hz to the
subwoofer and higher frequencies through
the output connectors to the main loud-
speakers. When using the subwoofer
for the .1/LFE channel of a multichannel
system, we recommend that bass manage-
ment is done in the processor or receiver
and only the LFE channel is connected to
the subwoofer.
Installation
Before connecting the audio signals, ensure
that all equipment is switched off.
As the F Two contains its own amplier, no
separate power amplier is needed. Never
connect the F Two to the loudspeaker out-
puts of a power amplier, integrated ampli-
er or receiver.
Please follow the steps listed below for a
succesful setting up of the subwoofer:
1. Check the contents of the shipment.
in addition to the subwoofer, there is a
wireless remote control, a mains cable,
an IR extension cable and a Quick Setup
Guide.
2. Pull out the battery insulating strip from
the underside of the remote control as
shown in gure 1. This strip insulates the
battery from the contacts on the remote
control during shipping and the remote
control does not function before it is
removed.
3. Place the subwoofer in its position.
4. Connect audio cables from your signal
source(s). You can connect up to two
digital audio sources and two analog
audio sources.
5. Connect the main loudspeakers to
the output connectors of the subwoofer.
You can use either balanced XLR or
unbalanced RCA connectors.
6. Set the “LEVEL +10” and “-10 dB”
switches on the subwoofer and main
loudspeakers according to Table 2 on this
manual.
7. Adjust the phase of the subwoofer as
instructed in this manual and the Quick
Setup Guide.
8. Use test recordings and familiar music
pieces to judge the sound balance. Use
the “SUBWOOFER LEVEL” rotary control
and the “BASS ROLL-OFF” dip switches
to ne-tune the balance. If this fails,
consider relocating the subwoofer.
Operating Environment
The F Two subwoofer is designed for
indoor use only. The ambient temperature
should be 15-35 °C (50-95 °F) and the rela-
tive humidity 20-80 %. Condensation is not
allowed. If it has been stored or transported
in a cool environment, the product must be
allowed to warm up in its packing to the
ambient temperature before connecting
mains power.
Connectors
The F Two is equipped with both analog
and digital signal input connectors, that
can be used simultaneously to connect
up to four audio sources (two analog, two
digital). Switching between sources is done
with the Select button on the connector
panel or with the “<” and “>” buttons on
the remote control. The colour of the LED
light on the subwoofer enclosure indicates
which source is selected.
Analog Input Connectors
The F Two has two stereo inputs (3.5 mm
jack and L/R RCA connectors) and an LFE/
LINK RCA connector. The stereo inputs
are parallel, so you can connect two audio
sources at the same time, just play only
one of them at a time. The Select function
does not work between these two inputs.
The LFE/LINK input is used for the LFE
Figure 1. Removing the battery insulating strip
from the remote control
Figure 2. Connectors and controls of the F Two.
(.1) signal in a 2.1 or 5.1 channel sound
system or as the signal input in a multiple
subwoofer system (see chapter Using Mul-
tiple Subwoofers). The LFE/LINK input has
a 120 Hz low pass lter, so it is not suitable
for full frequency range signals.
Digital Input Connectors
The F Two has two digital signal input con-
nectors, one coaxial and one optical, that
accept stereo PCM format digital signal.
You can connect two digital sources and
switch between them using the Select
function.
Analog Output Connectors
The F Two has two pairs of analog stereo
L/R output connectors, one with RCA con-
nectors and the other with balanced XLR
male connectors. Connect signal cables
from these connectors to the main speak-
ers. Both connector pairs carry the same
SYSTEM
VOLUME
CONT ROL
RIGHTLEFT
LFE/LINK
PHASE
270°
OUT
L R
L R LINK
SELECT
OPTICALCOAXIAL
IN
90°
180°
LINK
+10 dB
10 dB
LEVEL
I R IN
MAINS INPUT
50 / 60 Hz 150 W
100 240 V~
ST EREO
MAX MIN
DIGITAL AUDIO IN
SUBW LEVEL
6 d B
4 dB
2 dB
ROLL OFF
HT MODE
ISS SENSIT I VIT Y LOW
ISS
LED OFF
ON
OFF
ON
OFF
DIP SWITCH GROUP 1:
HT MODE
ISS SENSITIVITY LOW
ISS
LED OFF
AUDIO OUTPUT CONNECTORS:
XLR L AND R
RCA L AND R
RCA LINK
DIGITAL AUDIO INPUTS:
RCA COAXIAL
TOSLINK OPTICAL
MAINS INPUT
POWER BUTTON
IR IN CONNECTOR
SELECT BUTTON
SYSTEM VOLUME
CONTROL CONNECTOR
SUBWOOFER LEVEL
ROTARY ADJUSTMENT
DIP SWITCH GROUP 2:
ROLL OFF
PHASE
LINK
LEVEL
ANALOG AUDIO INPUTS:
RCA L AND R
3.5 MM STEREO JACK
LF LINKE /
Figure 3. Audio cabling
SYSTEM
VOLUME
CONTROL
RIGHTLEFT
LFE/LINK
PHASE
270°
OUT
L R
L R LINK
SELECT
OPTICALCOAXIAL
IN
90°
180°
LINK
+10 dB
10 dB
LEVEL
IR IN
MAINS INPUT
50 / 60 Hz 150 W
100 240 V~
STEREO
MAX MIN
DIGI L AUDITA O IN
SUBW LEVEL
6 dB
4 dB
2 dB
ROLL OFF
HT MODE
IS S S ENSITIVITY LO
W
ISS
LED OFF
ON
OFF
ON
OFF
DIGITAL SIGNAL SOURCES:
TV, STREAMER, SOUND CARD ETC.
ANALOG SIGNAL SOURCES:
PHONE, COMPUTER, AV REVEIVER ETC.
Tuner87.5 MHz
GIZM O
POSSIBLE ADDITIONAL SUBWOOFER.
USE THE LFE/LINK INPUT AND SET THE
”LINK” DIP SWITCH ”ON”.TO

Termékspecifikációk

Márka: Genelec
Kategória: mélynyomó
Modell: F Two

Szüksége van segítségre?

Ha segítségre van szüksége Genelec F Two, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók mélynyomó Genelec

Genelec

Genelec 7050 CPM Útmutató

30 Július 2024
Genelec

Genelec 7382A Útmutató

27 Július 2024
Genelec

Genelec 7071A Útmutató

20 Július 2024
Genelec

Genelec 7040A Útmutató

19 Július 2024
Genelec

Genelec 7370APM Útmutató

17 Július 2024
Genelec

Genelec 5050A Útmutató

14 Július 2024
Genelec

Genelec F One Útmutató

13 Július 2024
Genelec

Genelec 5041A Útmutató

13 Július 2024
Genelec

Genelec 7360APM Útmutató

9 Július 2024
Genelec

Genelec F Two Útmutató

8 Július 2024

Útmutatók mélynyomó

Legújabb útmutatók mélynyomó

Phase Technology

Phase Technology IW200-II Útmutató

4 Április 2025
Wet Sounds

Wet Sounds ZERO 10 S4 XZ-W Útmutató

2 Április 2025
SoundTube

SoundTube CM1001D Útmutató

2 Április 2025
JL Audio

JL Audio FS108-W5 Útmutató

31 Március 2025
Phase Technology

Phase Technology PL-12p Útmutató

30 Március 2025
ETON

ETON Graphit 8-2 Útmutató

19 Március 2025
ETON

ETON Graphit 8-4 Útmutató

19 Március 2025
ETON

ETON Graphit 10-4 Útmutató

19 Március 2025
ETON

ETON MW 10 FLAT Útmutató

19 Március 2025
ETON

ETON PW 8 Útmutató

19 Március 2025