Használati útmutató Emos P4518

Emos Zseblámpa P4518

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Emos P4518 (20 oldal) a Zseblámpa kategóriában. Ezt az útmutatót 2 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF

Oldal 1/20

1450000180_31-P4518_00_01 148 × 210 mm

www.emos.eu/download

P4518|E709A-COB3W+6

GB LED Work Light

CZ LED pracovní svítilna

SK LED pracovné svietidlo

PL Lampa warsztatowa LED

HU LED-es munkalámpa

SI Delovna LED svetilka

RS|HR|BA|ME LED radna svjetiljka

DE LED-Arbeitsleuchte

UA Світлодіодний робочий ліхтарик

RO|MD Lampă LED de lucru

LT Darbinis šviesos diodų žibintas

LV LED lukturis darbam

EE LED-töötuli

BG LED pаботна лампа

5. 6.

6× LED 20 lm 24 h 27 m

COB LED 200 lm 7 h 19 m

380 lm 3,5 h 26 m

GB | LED Work Light

Specications

The rechargeable lamp is resistant to rough conditions (dust, dirt) and is therefore suitable for technicians, handymen and

cottagers, as well as for use in the car. The lamp has a magnet and a hook for hanging. The reector of the lamp can be rotated

– the top part horizontally by 360° and vertically by 180° to either side, the bottom part (handle) with a magnet horizontally by

360°. The lamp can be charged, or recharged, from a 100–240 V AC, 50/60 Hz network or from a 12/24 V DC car socket.

Description

1. Hook

2. Switch

3. Rotating handle with a magnet

4. Recharging LED indicator, connector for power supply

5. COB source

6. 6 LED source

Specications:

Light source: COB LED + 6× LED

Accumulator pack: Li-Ion 18650–3.7 V DC/2 500 mAh

Electric grid charging power source: type SD-G0501000D

input 100–240 V AC, 50/60 Hz,

output 5 V DC/1 000 mA

Recharging from car: 12/24 V DC

Power source for car adapter: input: 12/24 V DC; output: 5 V DC/1 000 mA

Recharging the Accumulator

Before the rst use or if the lamp does not light up or ashes (which indicates a weak battery) the accumulator has to be

recharged. Charging the accumulator pack when it is completely at takes about 3 hours (depending on the degree to which

the accumulator has been discharged). Recharge the lamp in dry indoor areas.

1. Connect the network power adapter (type SD-G0501000D) to a 100–240 V AC, 50/60 Hz network.

2. Turn the switch on the lamp to the o position.

3. Connect the network power adapter into the lamp’s power connector – a red light will turn on on the lamp. When the lamp

(accumulator) is fully recharged, the LED will turn green.

4. After recharging, disconnect the adapter from the lamp.

The accumulator can be recharged intermittently – it has no memory eect.

The lamp can also be recharged in a car – through the 12/24 V DC lighter socket. Procedure for plugging in and recharging is

similar as when using a network adapter. After recharging, disconnect the car adapter. The lamp can be recharged using a car

adapter only when the vehicle is stationary and the engine is turned o. Do not under any circumstances charge the lamp when

the car engine is running or the car is in motion.

The LED light sources have a 50 000 hour service life and therefore need not be recharged. After exhausting, the entire lamp

can disposed of.

Changing the Accumulator:

The accumulator should only be changed by a skilled user, ideally with qualications in electrical engineering.

1. When changing the accumulator, turn the lamp switch to the o position.

2. Carefully remove the screws from the rear cover of the lamp and take the lamp apart.

3. Remove the accumulator pack and replace with a new one with same dimensions and electrical parameters. The new

accumulator must be purchased only from the manufacturer. Never use non-original components. Make sure to observe

the correct polarity when changing the accumulator.

4. Reassemble the lamp by reversing the procedure for disassembly.

WARNING

• When new, the lamp must rst be charged before use.

• The lamp’s accumulator must be kept charged to prevent the voltage from dropping below the threshold level. Therefore,

it is recommended to recharge the lamp at least once every 3 months even when it is not being used.

• If the lamp does not shine or the light is weak or ashes, immediately recharge the accumulator.

• If the accumulator is damaged or destroyed due to non-observance of the above rules, complaints led within the warranty

period regarding the lamp (accumulator) will not be recognized.

• Use the network adapter type SD-G0501000D only for recharging the lamp; do not recharge any batteries designed for

other purposes.

• The network adapter and car adapter must be used in dry indoor areas.

• When replacing the accumulator, make sure to observe the correct polarity.

• Do not throw the accumulator into a re and do not disassemble or short-circuit it.

• After depletion, the accumulator becomes hazardous waste. After depletion, do not dispose of the accumulator in municipal

waste. Turn the accumulator in at take-back sites such as the shop where the lamp was purchased.

• Upon completion of the lamp’s life cycle, dispose of the lamp in an environmentally-friendly way.

• If water enters the interior of the lamp, remove the accumulator and dry the interior of the lamp thoroughly. Do not under

any circumstances use the lamp.

• The lamp is not intended for use by persons whose physical, sensory or mental disability or lack of experience and expertise

prevents its safe use, unless they are supervised or instructed in the use of the appliance by a person responsible for their

safety. Children should not be allowed to play with the lamp.

Do not dispose with domestic waste. Use special collection points for sorted waste. Contact local authorities for informa-

tion about collection points. If the electronic devices would be disposed on landll, dangerous substanoes may reach

groundwater and subsequently food chain, where it could aect human health.

Delivery List:

Lamp

Electric grid charging power source, type SD-G0501000D

Car adapter 12/24 V DC

Recharge cable

Manual

CZ | LED pracovní svítilna

Specikace

Nabíjecí svítilna je odolná proti nešetrnému zacházení (prach, špína), proto je vhodná pro techniky, kutily, chataře a také do

auta. Svítilna má magnet a hák na zavěšení. Reektor svítilny je možné natáčet - horní část horizontálně o 360° a současně také

do stran vertikálně o 180°, dolní část (rukojeť) smagnetem horizontálně lze otáčet o 360°. Svítilnu lze nabíjet, případně dobíjet

ze sítě 100–240 V AC, 50/60Hz, nebo z automobilové zásuvky 12/24 V DC.

Popis

1. Hák

2. Vypínač

3. Otočná rukojeť s magnetem

4. LED indikace nabíjení, konektor pro připojení napájecího zdroje.

5. COB zdroj

6. 6 LED zdroj

Technická specikace:

Zdroj světla: COB LED + 6× LED

Akumulátorový pack: Li-Ion 18650–3,7 V DC/2 500 mAh

Síťový napájecí zdroj: typ SD-G0501000D;

vstup 100–240 V AC, 50/60 Hz

výstup 5 V DC/1 000 mA

Nabíjení z automobilu: 12/24 V DC

Napájecí zdroj do automobilu: adaptér do auta, vstup: 12/24 V DC; výstup: 5 V DC/1 000 mA

Termékspecifikációk

Márka:	Emos
Kategória:	Zseblámpa
Modell:	P4518

Szüksége van segítségre?

Ha segítségre van szüksége Emos P4518, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek

Az Ön neve*

Az Ön e-mail címe*

Írja ide kérdését

Útmutatók Zseblámpa Emos

14 December 2024

14 December 2024

14 December 2024

3 Szeptember 2024

30 Augusztus 2024

30 Augusztus 2024

14 Augusztus 2024

8 Augusztus 2024

8 Augusztus 2024

Útmutatók Zseblámpa

Legújabb útmutatók Zseblámpa

Brennenstuhl TL 400 AFS Útmutató

15 December 2024

Ledlenser i4R Útmutató

14 December 2024

Ledlenser H4 Útmutató

14 December 2024

Ledlenser MT10 Útmutató

14 December 2024

Blackburn Countdown 1600 Útmutató

13 December 2024

Underwater Kinetics UK 2AA eLED ES Útmutató

12 December 2024

Eisemann HSE 7 LED Útmutató

11 December 2024

NEO Tools 99-072 Útmutató

10 December 2024

AccuLux JobLux PowerLED Focus Útmutató

9 December 2024

Livarno Lux IAN 288152 Útmutató

8 December 2024