Használati útmutató De Dietrich DHG397XP1

De Dietrich Páraelszívó DHG397XP1

Olvassa el alább 📖 a magyar nyelvű használati útmutatót De Dietrich DHG397XP1 (6 oldal) a Páraelszívó kategóriában. Ezt az útmutatót 3 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/6
INSTRUCTIONS FOR INSTALLATION AND USE
MONTAGE- UND GEBRAUCHSANWEISUNG
INSTRUCTIONS POUR L'INSTALLATION ET L’UTILISATION
ISTRUZIONI PER L'INSTALLAZIONE E L’USO
INSTRUCCIONES PARA INSTALACIÓN Y USO
INSTRUÇÕES DE INSTALAÇÃO Y UTILIZAÇÃO
AANWIJZING VOOR GEBRUIK EN INSTALLATIE
DHG397
ENGLISH
WARNING
The distance between the supporting surface for the cooking worktop on the hob and the lower part of the hood
must be at least 65 cm. If the instructions for installation for the hob specify a greater distance, this has to be
taken into account.
The air collected must not be conveyed into a duct used to blow off smokes from appliances fed with an energy
other than electricity (central heating systems, thermosiphons, water-heaters, etc.).
Comply with the official instructions provided by the competent authorities in merit when installing the disposal
duct. In addition, exhaust air should not be discharged into a wall cavity, unless the cavity is designed for that
purpose.
The room must be well ventilated in case a hood and some other heat equipment fed with an energy other than
electricity (gas, oil, coal heaters, etc) operate at the same time.
The intake hood could create a vacuum indeed by extracting the air out the room. The vacuum should not exceed
0,04mbar. This prevents the head source to generate in-drawghts of gas that must be extracted out.
Check the data label inside the appliance; if the symbol ( ) is printed, read the following: this appliance
has such technical particularities that it belongs to class II insulation, therefore it must not be earthed.
The following warning is valid in the United Kingdom only: in case your cable is not furnished with a plug, read
the following instructions; as the colours of the wires in the mains lead of this appliance may not correspond with
the coloured markings identifying the terminals in your plug, proceed as follows: – the wire which is coloured blue
must be connected to the terminal which is marked with the letter N or coloured black; – the wire which is
coloured brown must be connected to the terminal which is marked with the letter L or coloured red. – terminal
of a three-pin plug.
Check the data label inside the appliance; if the symbol ( ) is NOT printed, read the following:
ATTENTION: This appliance must be earthed. When making the electrical connections, check that the current
socket has a ground connection.
The following warning is valid in the United Kingdom only: in case your cable is not furnished with a plug, read
the following instructions; as the colours of the wires in the mains lead of this appliance may not correspond with
the coloured markings identifying the terminals in your plug, proceed as follows:
– the wire which is coloured green and yellow must be connected to the terminal in the plug which is marked
with the letter E or by the earth symbol [ ], or coloured green or green and yellow; – the wire which is coloured
blue must be connected to the terminal which is marked with the letter N or coloured black; – the wire which is
coloured brown must be connected to the terminal which is marked with the letter L or coloured red.
When making the electrical connections, check that the voltage values correspond to those indicated on the data
plate inside the appliance itself. In case your appliance is not furnished with a non separating flexible cable and
has no plug, or has not got any other device ensuring omnipolar disconnection from the electricity main, with a
contact opening distance of at least 3 mm, such separating device ensuring disconnection from the main must
be included in the fixed installation. If your unit features a power lead and plug, position this so the plug is
accessible.
Always switch off the electricity supply before carrying out any cleaning or servicing operations on the appliance.
USE
Avoid using materials which could cause spurts of flame (flambées) near the appliance.
When frying, take particular care to prevent oil and grease from catching fire. Already used oil is especially
dangerous in this respect. Do not use uncovered electric grates.
To avoid possible risks of fire always comply with the indicated instructions when cleaning anti-grease filters and
when removing grease deposits from the appliance.
MAINTENANCE
Thorough servicing guarantees correct and long-lasting operation.
Any fat deposits should be removed from the appliance periodically depending on amount of use (at least every
2 months). Avoid using abrasive or corrosive products. To clean painted appliances on the outside, use a cloth
dipped in lukewarm water and neutral detergent. To clean steel, copper or brass appliances on the outside, it
is always best to use specific products, following the instructions on the products themselves. To clean the inside
of the appliance, use a cloth (or brush) dipped in denatured ethyl alcohol.
DESCRIPTION
The hood may be installed in the ducting version. Ducting version (Fig. 1): The hood aspirates the kitchen air
saturated with fumes and odours, passes it through the grease filters and expels it to the outside through an outlet
pipe. With this version the charcoal filters are not required.
The 2-motor version hood is only available for ducting version installation.
INSTALLATION
ATTENTION: 2 people are required for proper installation; the unit should be installed by a qualified
operator.
INSTALLATION IN DUCTING VERSION:
1. Before fixing, the disposal duct for air evacuation to the outside must be installed. Use an disposal duct with:
– minimum indispensable length; – minimum possible bends (maximum angle of bend: 90°); – certified material
(according to the State); – an as smooth as possible inside. It is also advisable to avoid any drastic changes in pipe
cross-section. We recommend using a 200 mm diameter pipe. For air evacuation to the outside, follow all the other
instructions given on the “Warnings” sheet.
2. You have purchased the 2-motor version (model shown in Fig. 2); you must fit the plastic flange using 4
screws (the screws are provided and are the 4 shortest ones).
3. Prepare a suitable power supply. For the electrical connection, follow all the other instructions on the
“Warnings” sheet.
4. Check to see the grease filters have been removed; if necessary, remove these by moving the catch (B)
and turning these outwards (Fig. 3).
5. Make a hole for housing the appliance (Fig. 4) in the bottom of the wall unit. The bottom of the wall unit must
have a thickness of between 15 and 20 mm.
6. Take 4 retention screws from the accessories bag. Fit the appliance in the hole made on the wall unit, first
positioning the rear part, so the flap on the back rests on the wall unit; next, slightly slide the appliance back, towards
the wall (Fig. 5).
Without leaving the appliance, secure this to the wall unit by means of the 4 screws (Fig. 6).
7. Proceed with final fitting, using the 4 screws (the longest ones); See Fig. 7.
8. Connect the disposal duct to the air evacuation pipe of the hood. Use a flexible pipe and lock it to the air
evacuation pipe of the hood with a metal hose clamp (pipe and clamp are not provided). Make the electrical
connections.
9. Refit the grease filters.
OPERATION
Controls (Fig. 8):
Button A: turns the lights on/off; every 30 hours of operation the corresponding pilot lamp (S) comes on to indicate
that the grease filters must be cleaned; every 120 hours of operation the corresponding pilot lamp (S) flashes to
indicate that the grease filters must be cleaned. To restart the hour counter (RESET), hold the button A pressed down
for about 1” (while the pilot lamp S is on).
Button B: drives the motor in first speed (the corresponding pilot lamp comes on); when holding it down for about 1”,
the motor cuts out; when pressing the button a second time (while the pilot lamp is on) , the TIMER is activated and
thus the motor stops after 5’ (the pilot lamp flashes).
Button C: drives the motor in second speed (the corresponding pilot lamp comes on); when pressing the button a
second time (while the pilot lamp is on) , the TIMER is activated and thus the motor stops after 5’ (the pilot lamp
flashes).
Button D: drives the motor in third speed (the corresponding pilot lamp comes on); when pressing the button a second
time (while the pilot lamp is on) , the TIMER is activated and thus the motor stops after 5’ (the pilot lamp flashes).
Button E: drives the motor in fourth speed (the corresponding pilot lamp comes on); when pressing the button a
second time (while the pilot lamp is on) , the TIMER is activated and thus the motor stops after 5’ (the pilot lamp
flashes).
Pay special attention to the grease filters: the grease filters must be cleaned approximately once every 30 hours
of operation (when the light button lamp comes on) - Fig. 8S). Wash out the filter using a neutral soap. Once the
cleaned filters are reinstalled, to reset the counter hold the light button pressed down for about 1” (Fig. 8A) while the
corresponding pilot lamp (S) is on.
Removing the grease filters: Remove the grease filters by moving fastener B and turning the filter outwards
(Fig. 3).
Lighting: to remove the halogen lamps, turn the locknut counter-clockwise (Fig. 9). Replace with the same type
of lamp. CAUTION: Do not handle glass bulb with bare hands.
DEUTSCH
HINWEIS
Der Mindestabstand zwischen der Topf-Trägerfläche auf der Kochmulde und dem unteren Teil der Abzughaube
muss 65 cm betragen. Geben die Installationsanleitungen der Kochmulde einen höheren Abstand an, so ist
dieser einzuhalten.
Ein Anschluss der Abluftleitungen an Verbrennung-sabgaskamine (zum Beispiel Zentralheizung, Heizgeräte,
Badezimmeröfen usw.) ist nicht gestattet.
In jedem Fall sind bei der Ableitung der Abluft die behördlichen Vorschriften zu beachten. Desweiteren darf die

Termékspecifikációk

Márka: De Dietrich
Kategória: Páraelszívó
Modell: DHG397XP1

Szüksége van segítségre?

Ha segítségre van szüksége De Dietrich DHG397XP1, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók Páraelszívó De Dietrich

De Dietrich

De Dietrich DHB7952G Útmutató

12 Január 2025
De Dietrich

De Dietrich DHD 375X Útmutató

13 Szeptember 2024
De Dietrich

De Dietrich DHG397XP1 Útmutató

13 Szeptember 2024
De Dietrich

De Dietrich DHD120XE1 Útmutató

6 Augusztus 2024
De Dietrich

De Dietrich DHB7952A Útmutató

5 Augusztus 2024
De Dietrich

De Dietrich DHT316XE1 Útmutató

27 Július 2024
De Dietrich

De Dietrich DHG 377 XP Útmutató

24 Július 2024
De Dietrich

De Dietrich DHG377XP1 Útmutató

17 Július 2024
De Dietrich

De Dietrich DHT1119X Útmutató

14 Július 2024
De Dietrich

De Dietrich DHD793GW Útmutató

13 Július 2024

Útmutatók Páraelszívó

Legújabb útmutatók Páraelszívó

Elica

Elica Horizonte EDS IX VT/A/90 Útmutató

12 Január 2025
Falmec

Falmec Iride Útmutató

12 Január 2025
Gorenje

Gorenje IDR5536W Útmutató

12 Január 2025
Franke

Franke FIM 2 900 W XS Útmutató

12 Január 2025
Broan

Broan BCSEK136WW Útmutató

12 Január 2025
Continental Edison

Continental Edison CEHP60B Útmutató

12 Január 2025
Neff

Neff D61MAC1X0B Útmutató

12 Január 2025
Klarstein

Klarstein 10033709 Útmutató

12 Január 2025
Halifax

Halifax FTHI740K Útmutató

12 Január 2025
Hoover

Hoover HDTI6500/1X Útmutató

12 Január 2025