Használati útmutató Chief SLM281

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Chief SLM281 (1 oldal) a Projektor tartozék kategóriában. Ezt az útmutatót 6 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/1
I N S T A L L A T I O N I N S T R U C T I O N S
Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes
no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a products division of Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 F:877.894.6918 / 952.894.6918
8802-002080 Rev00
©2010 Milestone AV Technologies,
a Duchossois Group Company
12/10
SLB-281 and SLM-281 Interface Brackets
SLB-281 and SLM-281 Interface Brackets are designed for use with Chie Series Projector Mounts. See the specific installation instructions
provided with the mount for additional installation information.
Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
Installation Instructions
WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT over tighten screws when installing interface brackets.
NOTE: Step 1 is only required when installing an SLB interface bracket. If an SLM bracket is being installed, proceed to step 2.
1. Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.
2. Turn projector upside down on a flat surface.
3. Place the interface bracket onto the bottom of the projector, aligning the mounting holes in the bracket with the threaded inserts in the
bottom of the projector and ensuring that triangle in bracket points towards front of projector.
4. Position M5 x 20mm mounting screws with M5 flat washers into the threaded inserts and four bracket side tabs. Tighten all fasteners at
this time, securing the bracket to the projector.
NOTE: Security screws can be substituted when mounting Interface bracket to projector by using the parts and installation instructions in the
All-Points Security Kit.
Chie is a registered trademark of Milestone AV Technologies. All rights reserved.
(1) Interface Bracket (4) Screw, Phillips Pan Head, Machine, M5 x 20mm
(6) 10-24 Thumb Nuts ** (4) Washer, M5
(1) All-Points Security Kit (1) 5/32" Security Hex Key
**Only used when installing SLB interface brackets.
SLB-281 SLM-281
Towards front
of projector
Towards front
of projector

Termékspecifikációk

Márka: Chief
Kategória: Projektor tartozék
Modell: SLM281

Szüksége van segítségre?

Ha segítségre van szüksége Chief SLM281, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók Projektor tartozék Chief

Chief

Chief RPMC198 Útmutató

1 Január 2025
Chief

Chief RPMA360 Útmutató

1 Január 2025
Chief

Chief RSMA342 Útmutató

1 Január 2025
Chief

Chief RSMA360 Útmutató

1 Január 2025
Chief

Chief RPMC266 Útmutató

1 Január 2025
Chief

Chief RSMC360 Útmutató

1 Január 2025
Chief

Chief RPMA303 Útmutató

1 Január 2025
Chief

Chief RPMC246 Útmutató

1 Január 2025
Chief

Chief RSA000S Útmutató

1 Január 2025
Chief

Chief RSA360 Útmutató

1 Január 2025

Útmutatók Projektor tartozék

Legújabb útmutatók Projektor tartozék