Használati útmutató Chief SLM190
Chief
Projektor tartozék
SLM190
Olvassa el alább 📖 a magyar nyelvű használati útmutatót Chief SLM190 (1 oldal) a Projektor tartozék kategóriában. Ezt az útmutatót 5 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra
Oldal 1/1
I N S T A L L A T I O N I N S T R U C T I O N S
Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes
no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a products division of Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8802-000259 Rev01
©2009 Milestone AV Technologies,
a Duchossois Group Company
05/09
SSB-190, SSM-190, SLB-190 and SLM-190 Interface Brackets
SSB-190, SSM-190, SLB-190 and SLM-190 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the specific
installation instructions provided with the mount for additional installation information.
Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
Installation Instructions
WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUPIMENT! DO NOT over tighten screws when installing interface brackets.
NOTE: Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.
1. Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.
2. Turn projector upside down on a flat surface.
3. Place the optional felt pads on the mount surface (as seen above) to protect projector paint.
4. Slide the front of the projector through the rear or the mount forward and align the 1/4" mounting hole in the projector with the 1/4" mounting
hole in the mount.
5. Place the 1/4" nylon spacer on the lamp door of the projector and slide it in between the projector and the 1/4" mounting hole in the mount.
6. Using the 1/4" - 20 x 5/8" long button head screw and 1/4" flat washer, place screw and washer through the bracket hole and nylon spacer,
and secure all using 5/32" hex key. Tighten all fasteners at this time, securing the bracket to the projector.
NOTE: Security screws can be substituted when mounting interface bracket to projector by using the parts and installation
instructions in the All-Points Security Kit.
Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
(1) Interface Bracket (1) Screw, Button Head Cap, 1/4-20 x 5/8"
(4) 10-24 Thumb Nuts ** (2) Washer, Flat, 1/4"
(1) All-Points Security Kit (1) Spacer, Nylon, .320 x 1/2" x 1/4"
(4) Pad, Felt
**Only used when installing SLB/SSB interface brackets.
NOTE: Specific to SSB-style and SSM-style interface bracket installation, all appropriate screws come pre-installed as reflected in the
encircled locations above. DO NOT attempt to substitute and USE ONLY this pre-installed hardware for SSB-style and SSM-style
interface bracket installation.
SLB-190 SLM-190
Lamp Opening
Lamp Opening
Felt Pad Location
Felt Pad Location
Towards front of
projector
Towards front of
projector
(Note: SSM-style interface bracket connection
s
a
r
e
e
n
c
i
r
c
l
e
d
)
(Note: SSB-style interface bracket connections
a
r
e
e
n
c
i
r
c
l
e
d
)
Termékspecifikációk
| Márka: | Chief |
| Kategória: | Projektor tartozék |
| Modell: | SLM190 |
Szüksége van segítségre?
Ha segítségre van szüksége Chief SLM190, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek
Útmutatók Projektor tartozék Chief
1 Január 2025
1 Január 2025
1 Január 2025
1 Január 2025
1 Január 2025
1 Január 2025
1 Január 2025
1 Január 2025
1 Január 2025
1 Január 2025
Útmutatók Projektor tartozék
- Projektor tartozék Sony
- Projektor tartozék Nedis
- Projektor tartozék Panasonic
- Projektor tartozék Casio
- Projektor tartozék BenQ
- Projektor tartozék My Wall
- Projektor tartozék V7
- Projektor tartozék Kanto
- Projektor tartozék Roadinger
- Projektor tartozék Optoma
- Projektor tartozék Omnitronic
- Projektor tartozék Viewsonic
- Projektor tartozék Konig & Meyer
- Projektor tartozék Sanus
- Projektor tartozék Manhattan
- Projektor tartozék Peerless-AV
- Projektor tartozék Chipolino
- Projektor tartozék Sanyo
- Projektor tartozék Lindy
- Projektor tartozék Barco
- Projektor tartozék NEC
- Projektor tartozék Projecta
- Projektor tartozék Gabor
- Projektor tartozék Speaka
- Projektor tartozék Newstar
- Projektor tartozék Vogel's
- Projektor tartozék Vision
- Projektor tartozék Da-Lite
- Projektor tartozék AV:link
- Projektor tartozék InFocus
- Projektor tartozék Metronic
- Projektor tartozék Peerless
- Projektor tartozék Tempest
- Projektor tartozék Premier Mounts
- Projektor tartozék Elite Screens
- Projektor tartozék Kingpin Screens
- Projektor tartozék Christie
- Projektor tartozék Unicol
- Projektor tartozék Smart Media
- Projektor tartozék NeoMounts
- Projektor tartozék SMK-Link
Legújabb útmutatók Projektor tartozék
27 Március 2025
27 Március 2025
14 Január 2025
10 Január 2025
7 Január 2025
27 December 2024
27 December 2024
23 December 2024
23 December 2024
23 December 2024