Használati útmutató Celestron NexImage 5

Celestron kamera NexImage 5

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Celestron NexImage 5 (12 oldal) a kamera kategóriában. Ezt az útmutatót 4 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/12
USERS MANUAL
Model #93711
English
Congratulations on your purchase of the Celestron NexImage 5 Solar System imaging camera.
Your NexImage camera comes with the following:
+ NexImage 5 Camera
+ 1.25” nose piece
+ CD including NexImage iCap and RegiStax processing software
+ USB Cable
Recommended Minimum System requirements:
+ Pentium IV, 2.0 GHz, 1GB RAM
+ Graphics card with 24 or 32 bit
+ Windows XP, Windows Vista, Windows 7 (32 & 64 bit)
+ DirectX 9.0c or higher
1.25”
Nose Piece USB CableNexImage 5 Camera
NexImage iCap and
Registax processing
software
Fig 1
1
Quick start
1. Place the CD into your computer’s CD rom drive.
2. Install both the NexImage iCap and RegiStax software
onto your computer.
3. Thread the 1.25” nose piece into the body of the
NexImage camera. see Fig 2.
4. Slide the 1.25” nose piece of the camera into the eyepiece barrel of your telescope. .see Fig 3
5. Plug the small end of the USB cable into the port on the back of the camera.
6. Plug camera into the USB port of your computer. Once connected, the Found New Hardware
message will appear. Follow the Installation Wizard until the device has been successfully installed.
2
Fig 2
Fig 3

Termékspecifikációk

Márka: Celestron
Kategória: kamera
Modell: NexImage 5

Szüksége van segítségre?

Ha segítségre van szüksége Celestron NexImage 5, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók kamera Celestron

Útmutatók kamera

Legújabb útmutatók kamera