Használati útmutató CaterChef 680.015

CaterChef sütő 680.015

Olvassa el alább 📖 a magyar nyelvű használati útmutatót CaterChef 680.015 (7 oldal) a sütő kategóriában. Ezt az útmutatót 9 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/7
680015 G20EF 1
USERS MANUAL
MANUEL DUTILISATION
P Srofe s sio nal upplies
CONVECTION OVEN
FOUR À AIR PULSÉ
Modelnr.: *680.015
ENGLISHFRANÇAIS
INSTRUCTION FOR THE INSTALLER
GB
Before connecting and operating the unit for the first time read this manual carefully and follow its
instructions.
Installation ,servicing, starting of the appliance and electrical connections must be done by
qualified personnel according to the legal requirements.
INSTALLATION
Positioning: the appliance shall be installed in well ventilated space and it can be positioned next to
the walls with a good heat resistance; if not possible please observe a distance from wall of at least
10 cm. all around the unit.
Remove the protection foil completely from the entire unit, before connecting and operating the
unit.
TECHNICAL DATA
The data plate is on the back of the fryer and lists all the data deeded for connecting up to the
mains.
ELECTRICAL CONNECTION
The rated voltage is 230V. Kw.3.4 for model FC4/M and V.400/2+N Kw.5.2 for model FC4/T, but
check that voltage provided corresponds to oven requirements.
If you want a direct connection to an electrical line it is necessary to have an onnipolar switch with
a contact opening of at least 3 mm., according to the load and to legal requirements.
The yellow/green earth wire must not be cut off.
The supply wire must not come into contact with places exceeding by more than 50°C .
Before carrying out the electrical connection, make sure that:
1) the fuses and the system are suitable for the power requirements of the appliance (see data
label).
2) The electric system has a right plate complying with the regulations in force.
3) It must be easy to access to the plug or the omnipolar switch when the appliance is installed.
Before using the oven ,we suggest to heat the oven to the max. temperature for about 30
minutes so as to eliminate any residual factory grease that might impart unpleasant smells
to the meals being cooked.
Our company declines any liability in case the anti-accident regulation will not be observed.
CONNECTION TO WATER SUPPLY
To use humidifier you must connect valve located on the back of the oven to water supply with a
3/4 G fitting.
MANTEINANCE
As a safety measure, before you start using the oven, be sure to disconnect it from the electric
system.
No special maintenance is required: you only need to check the condition of the electric wires,
control panel as well as the heating elements.
680015 G20EF 2
ENGLISH
ENGLISH
To replace some parts of the units, please follow these instructions:
Oven Lamp: just unscrew the glass protection and make sure that the new lamp has identical
specifications.
Heating element: replace the unit towards, unscrew the screws that are fixing on the back panel
and then accede to the parts to be replaced.
Oven fan: Once you have taken off the back panel, take off the fan protection from the inside
,unscrewing the two screws.
INSTRUCTION FOR USE
To get work the oven, just turn the knob to the wished position like:
0 unit OFF
oven light
fan ON
100 heating elements switched on under thermostatic control
safety thermostat
ATTENTION: On the bottom side of the control panel there is a manually resettable safety
thermostat that causes the oven to be switched Off in case of further failures.
To restore unscrew the red cap and press button.
END OF COOKING TIMER
The timer works on the whole oven circuit, breaking any function when the time set is over.
The time of max programming is about 120’. Switch on the oven and select the required time.
When time is spent the unit will switch off automatically and a buzzer sound.
IMPORTANT: with the timer in position “0” no one operation is possible.
ASSEMBLY AND ACCESSORIES
Oven is equipped with 2 grids
Assembly and disassembly Oven door : To facilitate cleaning of Oven the door can be take off
doing as follow :
- open the door and insert into the holes two screws M3 or two similar pieces that keep
disconnected springs of the hinges ;
- half-open the door and with two hands pull the door and at the same time unthread upwards.
- To assembly the door again repeat the operation on the contrary taking care at the right
introduction of hinges in their own position, and keep off the screws.
680015 G20EF 3
ENGLISH
ENGLISH

Termékspecifikációk

Márka: CaterChef
Kategória: sütő
Modell: 680.015

Szüksége van segítségre?

Ha segítségre van szüksége CaterChef 680.015, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók sütő CaterChef

Útmutatók sütő

Legújabb útmutatók sütő