Használati útmutató Bogen MPS1

Bogen hangszóró MPS1

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Bogen MPS1 (4 oldal) a hangszóró kategóriában. Ezt az útmutatót 6 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/4
© 2010 Bogen Communications, Inc.
All rights reserved.
Specifications subject to change without notice.
54-2194-01A 1010
MPS1
Mini Pendant Speaker
Models MPS1B /MPS1W
Installation and Use Manual
Power Tap Selection
16-ohm or 70V
The Power Tap selector switch is used to set the
appropriate power level or impedance for your
system. Rotate the switch until the power level
you require lines up with arrow.
IMPORTANT: When connecting to a 70V amplifier,
make sure that the MPS1 Tap Selector switch
IS NOT set in the “16Ω” position.
Speaker Connection and Polarity
Speaker wiring is terminated at a snap-lock input
connector, with a positive and negative terminal.
All wiring should be done prior to installation and
then plugged into the rear of the MPS1. Wire all
speaker polarities the same way.
70V System Configurations
When designing a 70V system, the total of all power tap settings of all the connected
speakers CANNOT EXCEED the output power of the 70V amplifier (amplifier power
can exceed the sum of the speaker loads).
Low-Impedance System Configurations
When wiring together multiple MPS1 speakers that are set to 16 ohms, it is important to
calculate (using Ohmʼs Law) the total load that these speakers present to the amplifier.
The total load impedance of the interconnected speakers cannot be lower than the
minimum load impedance rating of the low-impedance amplifier. Also, care must be
taken to ensure the amplifier cannot overdrive the speakerʼs maximum power rating.
POWER TAP
SELECTOR SWITCH
SNAP-LOCK
WIRING TERMINAL
MPS1
(Top View)
EXAMPLE: 16 + 32 + 8 + 8 + 16 = 80 Watts minimum amplifier output rating.
EXAMPLE: Four 16 -ohm speakers in parallel = 4 ohms. Also in this example,
the maximum amplifier output power rating should not exceed 200W (4 X 50W,
the MPS1 max. power is 50W).
_
_
_
__ +
IMPORTANT:
The MPS1 Mini Pendant is not an outdoor speaker. DO NOT expose the
speaker to rain or moisture. The MPS1 should be installed by qualified personnel.
ALONG WITH THE MAIN DROP CABLE, YOU MUST ALSO USE A
SAFETY CABLE WHEN SUSPENDING AN MPS1 PENDANT SPEAKER.
BE SURE TO SECURE
ALL RIGGING POINTS AND FOLLOW ALL
THE CABLE MANUFACTURER’S
MATERIAL RECOMMENDATIONS
& INSTALLATION INSTRUCTIONS. FAILURE TO DO SO MAY RESULT
IN PROPERTY DAMAGE, INJURY
OR DEATH, AND LEGAL LIABILITY
FOR YOU AND/OR YOUR COM
PANY.
Attach the main drop cable to the MPS1 Main Drop Cable hole in the Suspension
Attachment located on the top of the speaker. This Main Drop Cable will be the primary
connection that will hold all the suspended speakerʼs weight to the anchor point.
Likewise, attach the Safety Cable to the Safety Cable hole in the Suspension Attachment.
This Safety Cable is meant to be a safeguard only, so when attaching to an anchor point
allow for a small amount of slack in the wire, as the Safety Cable should not bear any of
the speakerʼs direct supension weight to keep the speaker hanging level.
MPS1 Speaker Cable Connections
and Suspension Instructions
In addition to the Main suspension Drop Cable,
a backup Safety Cable is required for proper
installation. Use wire rope or other drop line rated
for at least 100 lbs. to ensure a safety
margin.
The attachment point on the structure from which
the speaker is to be anchored also must be able
to handle 100 lbs.
NOTE:
If using suspension cables with a cladding,
be sure to strip away coating where any clamping
device is being used so that bare wire cores of the
cable are being clamped.
MAIN DROP
CABLE HOLE
MPS1
MINI PENDANT
SPEAKER
MPS1 SUSPENSION
ATTACHMENT
SAFETY
CABLE HOLE
MAIN
DROP
CABLE
SAFETY
CABLE
TO SPEAKER
ANCHOR
POINT

Termékspecifikációk

Márka: Bogen
Kategória: hangszóró
Modell: MPS1

Szüksége van segítségre?

Ha segítségre van szüksége Bogen MPS1, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók hangszóró Bogen

Bogen

Bogen WMT1AS Útmutató

11 December 2024
Bogen

Bogen AE-2s2 Útmutató

29 Szeptember 2024
Bogen

Bogen NEAR S5T Útmutató

23 Szeptember 2024
Bogen

Bogen G8G Útmutató

20 Szeptember 2024
Bogen

Bogen R8 Útmutató

18 Szeptember 2024
Bogen

Bogen MPS1 Útmutató

18 Szeptember 2024
Bogen

Bogen OCS1 Útmutató

18 Szeptember 2024
Bogen

Bogen AFI-8 Útmutató

14 Szeptember 2024
Bogen

Bogen NQ-SMS1810-SCG Útmutató

30 Augusztus 2024
Bogen

Bogen CSD1X2 Útmutató

26 Augusztus 2024

Útmutatók hangszóró

Legújabb útmutatók hangszóró

Phonic

Phonic AURRAS 8A Útmutató

11 December 2024
Phonic

Phonic ACUMEN 8A Útmutató

11 December 2024
Phonic

Phonic ACUMEN 6A Útmutató

11 December 2024
Phonic

Phonic AURRAS 6A Útmutató

11 December 2024
MB

MB PESSPROVS61A Útmutató

11 December 2024
Ruark Audio

Ruark Audio Sabre-R Útmutató

11 December 2024
Antelope

Antelope R4S Útmutató

11 December 2024
Antelope

Antelope Atlas i8 Útmutató

11 December 2024
MB

MB PESSPROVS62A Útmutató

11 December 2024
MB

MB PESSPROVS32A Útmutató

11 December 2024