Használati útmutató Yamaha DT-50K

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Yamaha DT-50K (30 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 2 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/30
1
Drum Trigger Module
Setup Manual for DT50S/DT50K
This manual describes how to correctly connect drum triggers (DT50S/DT50K) to your drum trig-
ger module and set parameters on your module to use the triggers. Refer to the Owners Manual
that came with your DT50S/DT50K for details on how to use drum triggers and mount them on
acoustic drums.
Select your drum trigger module.
DTX502 DTX700Page2 Page12
DTX900M/DTX900/DTXTREME III
Page17 DTX-MULTI 12 Page24
EN
2
DTX502
Depending on the version of the firmware, you may need to update it. Before you connect the module
to your DT50S/DT50K triggers, be sure to check the version of your module’s firmware.
1. While holding down the [SHIFT] button, turn on the drum trigger module.
2. Confirm the version displayed on-screen.
After you confirm the version, select the appropriate setup method.
If Version 1.30 or later Quick Setup (recommended)
Advanced Setup
If Version less than 1.30 Update before Using (recommended)
Use without Updating
Checking the Firmware Version
Selecting a Setup Method
Quick Setup (recommended)
3
DTX502
This section describes the basic setup for connecting your DT50S/DT50K triggers to your module,
and how to automatically set parameters by using Trigger Setup. With this method, you do not need
to select voices individually. You can play snare, tom, or kick drum sounds simply by selecting a Pre-
set kit.
1. Connecting to the Drum Trigger Module
Connect your drum triggers to the jacks on your DTX502 indicated below by using the stereo audio cables that came with the
triggers. Refer to the Owner’s Manual that came with your DT50S/DT50K for details on how to use the drum triggers and
mount them on acoustic drums.
NOTE
The following jacks on the DTX502 each comprise a pair of mono inputs (L: trigger, R: trigger): [wTOM1/!0], [eTOM2/!1], [rTOM3/!2], and
[ KICK/ ]u i . In this basic setup, the snare drum (DT50S) is connected to the [u iKICK/ ] jack and the bass drum (DT50K) to the [qSNARE]
jack in order to produce two sounds on the snare drum, one for a head shot and one for a rim shot. Note that in this case the connected drums
will not match the jack names.
If you wish to produce a sound for tom rim shots as well, refer to Advanced Setup.
Quick Setup (recommended)
To m1
(DT50S)
To m2 (DT50S)
Floor tom (DT50S)
Snare drum
(DT50S)
Bass drum (DT50K)
stereo audio cables that
came with DT50S/DT50K
Basic Setup

Termékspecifikációk

Márka: Yamaha
Kategória: nincs kategorizálva
Modell: DT-50K

Szüksége van segítségre?

Ha segítségre van szüksége Yamaha DT-50K, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók nincs kategorizálva Yamaha

Útmutatók nincs kategorizálva

Legújabb útmutatók nincs kategorizálva