Használati útmutató Whirlpool WH3ID10BS7SA0

Whirlpool mosogatógép WH3ID10BS7SA0

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Whirlpool WH3ID10BS7SA0 (32 oldal) a mosogatógép kategóriában. Ezt az útmutatót 3 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/32
1
ENQuick Guide
CONTROL PANEL
FILLING THE SALT RESERVOIR
The use of salt prevents the formation of LIMESCALE on the dishes and on
the machine’s functional components.
• It is mandatory that the salt reservoir never be empty.
• It is important to set the water hardness.
The salt reservoir is located in the lower part of the dishwasher and must be
lled when the SALT REFILL indicator light in the control panel is lit.
1. Remove the lower rack and unscrew the reservoir cap
(anticlockwise).
2. Position the funnel and ll the salt reservoir (see gure)
right up to its edge (approximately 1 kg); it is not unu-
sual for a little water to leak out.
3. Only the rst time you do this: ll the salt reservoir
with water.
4. Remove the funnel and wipe any salt residue away from the opening.
Make sure the cap is screwed on tightly, so that no detergent can get into
the container during the wash program (this could damage the water
softener beyond repair).
Whenever you need to add salt, it is mandatory to complete the proce-
dure before the beginning of the washing cycle to avoid corrosion.
WATER SOFTENING SYSTEM
Water softener automatically reduces water hardness, consequently pre-
venting scale buildup on heater, contributing also to better cleaning e-
ciency. This system regenerates itself with salt, therefore it is required
to rell salt container when empty.
Frequency of regeneration depends on water hardness level setting - regen-
eration takes place once per 6 Eco cycles with water hardness level set to 3.
Regeneration process starts in nal rinse and nishes in drying phase, be-
fore cycle ends.
• Single regeneration consumes: ~3.5L of water;
• Takes up to 5 additional minutes for the cycle;
• Consumes below 0.005kWh of energy.
FILLING THE RINSE AID DISPENSER
Rinse aid makes dish DRYING easier. The rinse aid
dispenser A should be lled when the RINSE AID
REFILL indicator light in the control panel is lit.
NEVER pour the rinse aid directly into the
appliance tub.
FILLING THE DETERGENT DISPENSER
To open the detergent dispenser use the opening device . Introduce the C
detergent into the dry dispenser only. Place the amount of detergent for D
pre-washing directly inside the tub.
If all-in-one detergents are used, we recommend using the TABLET button,
because it adjusts the program so that the best washing and drying results
are always achieved.
Usage of detergent not designed for dishwashers may cause
malfunction or damage to the appliance.
A
C
D
1 2 3 4 5 6 7 8 9 10 11
1. ON-OFF/Reset button with indicator light
2. Program selection button
3. Salt rell indicator light
4. Rinse Aid rell indicator light
5. Program number and delay time indicator
6. Tablet indicator light
7. Display
8. Power Clean® indicator light
9. Power Clean® button
10. Delay button
11. START/Pause button with indicator light /
Tablet (Tab)
THANK YOU FOR BUYING A WHIRLPOOL PRODUCT.
In order to receive a more complete assistance, please
register your appliance on: www.whirlpool.eu/register
PLEASE SCAN THE
QR CODE ON YOUR
APPLIANCE IN
ORDER TO HAVE
MORE DETAILED
INFORMATION
Before using the appliance carefully read Safety and Installation Instructions.
After installation, please remember to remove all transport protection parts from
the dishwasher.
Program
Programs description
Drying
phase
Natural
Dry
Available
options *)
Duration
of wash
program
(h:min)
**)
Water
consumption
(litres/cycle)
Energy
consumption
(kWh/cycle)
1.
Eco 50°- Program is suitable to clean normally soiled tableware, that for
this use, it is the most ecient programme in terms of its combined ener-
gy and water consumption, and that it is used to assess compliance with
the EU Ecodesign legislation.
3:40 8.7 0.67
2. Intensive 65° - Program recommended for heavily soiled crockery, espe-
cially suitable for pans and saucepans. 2:45 17.5 1.60
3.
6th Sense® 50-60°- For normally soiled dishes with dried food residues.
Senses the level of soiling on the dishes and adjusts the program accord-
ingly. 1:20 - 3:00 7.0 - 14.0 0.70 - 1.10
4. Fast Wash&Dry 50°
- Normally soiled crockery. Everyday cycle, that ensures
optimal cleaning and drying performance in shorter time.
1:25 11.5 1.10
5. Half Load - 55° Ideal for washing a half load of lightly or normally soiled
crockery. 1:20 11.0 1.00
6. Rapid 30’ - 45° Program to be used for half load of lightly-soiled dishes
with no dried food residues. Without drying. - 0:30 9.0 0.50
7.
Silent
50° - Suitable for night-time operation of the appliance. With the
lowest noise. 3:30 16.0 1.15
8. Sanitizing - 65° Normally or heavily soiled crockery, with additional anti-
bacterial wash. Can be used to perform maintenance of the dishwasher. - 1:50 12.0 1.30
9. Prewash - Use to refresh crockery planned to be washed later.
No detergent to be used with this program. - - 0:10 4.5 0.01
PROGRAMS TABLE
FIRST TIME USE More information in the Daily Reference Guide on website.
2
Quick Guide
EN
CLEANING AND MAINTENANCE More information in the Daily Reference Guide on website.
CLEANING THE FILTER ASSEMBLY CLEANING THE SPRAY ARMS
1
A
2
A
B
3
C
In case you nd foreign objects (such as broken glass, porcelain, bones, fruit seeds
etc.) please remove them carefully.
NEVER REMOVE the wash-cycle pump protection (black detail) (Fig 4).
To remove the upper spray arm,
turn the plastic locking ring in a
clockwise direction.
The lower spray arm may
be removed by pulling it
upwards.
POWER CLEAN®
Power Clean®
uses the special
water jets in the
rear of cavity to
wash more in-
tensively the
high dirty items. The lower rack has
a Space Zone, a special pull-out
support in the rear of the rack that
can be used to support frying pans
or baking pans in upright position,
thus taking up less space.
Placing the pots/casseroles faced
to the Power Clean® component
please activate the POWER CLEAN®
on the panel.
UPPER RACK
(loading example for
the upper rack)
Load delicate and light
dishes: glasses, cups,
saucers, low salad
bowls.
LOWER RACK
(loading example for the lower
rack)
For pots, lids, plates, salad
bowls, cutlery etc.. Large plates
and lids should ideally be pla-
ced at the sides to avoid inter-
ferences with the spray arm.
The lower rack has tip-up sup-
ports which can be used in a
vertical position when arrang-
ing plates or in a horizontal po-
sition (lower) to load pans and
salad bowls easily.
FOLDABLE
FLAPS
WITH AD-
JUSTABLE
POSITION
CUTLERY BASKET
The basket is
equipped with
top
grilles for
improved cutle-
ry arrangement.
The cutlery ba-
sket should be
positioned only
at the front of
the lower rack.
Knives and other utensils with sharp
edges must be placed in the cutlery
basket with the points facing down-
wards or they must be positioned
horizontally in the tip-up compart-
ments on the upper rack.
LOADING THE RACKS CAPACITY: 10 standard place-settings
ECO program data is measured under laboratory conditions according to European Standard EN 60436:2020.
Note for Test Laboratories: For information on
comparative EN testing conditions, please send an email to the following address:
dw_test_support@europeanappliances.com
Pre-treatment of the dishes is not needed before any of the programs.
*) Not all options can be used simultaneously.
**) Values given for programs other than the program Eco are indicative only. The actual time may vary depending on many factors such as temperature and
pressure of the incoming water, room temperature, amount of detergent, quantity and type of load, load balancing, additional selected options and sensor cali-
bration. The sensor calibration can increase program duration up to 20 min.
OPTIONS can be selected directly by pressing the corresponding button (see CONTROL PANEL). If an option is not compatible with the selected
program (see PROGRAMS TABLE), the corresponding LED ashes rapidly 3 times and beeps will sound. The option will not be enabled.
DELAY - The start time of the program may be delayed for a period of
time between and hours.1 12
The DELAY function cannot be set once a wash cycle has been started.
POWER CLEAN® - Thanks to the additional power jets this option
provides a more intensive and powerful wash in the lower rack, in the
specic area. This option is recommended for washing pots and casseroles.
TABLET (Tab)- If you use powder or liquid detergent, this option
should be o.
OPTIONS AND FUNCTIONS Please scan on your product in order to have more detailed information.the QR code
NaturalDry is a convection drying system which automatically opens the
door during/after drying phase to ensure exceptional drying performance
every day. Door opens at the temperature that is safe to your kitchen fur-
niture.
3
ENQuick Guide
PROBLEMS POSSIBLE CAUSES SOLUTIONS
The dishwasher does
not ll the water.
Display shows: H,
6 and On/O LED is
blinking rapidly
No water in the water supply or the tap is
closed. Make sure there is water in the water supply or the tap running.
The inlet hose is bent. Make sure the inlet hose is not bent (see INSTALLATION) reprogram the dishwa-
sher and reboot.
The sieve in the water inlet hose is clogged;
it is necessary to clean it
After having carried out the verication and cleaning, turn o and turn on the
dishwasher and restart a new program.
Dishwasher nishes
the cycle prematurely.
Display shows: 15
and
On/O LED is blinking
rapidly
Drain hose positioned too low or siphoning
into home sewage system.
Check if end of drain hose is placed at correct height (see INSTALLATION).Check
for siphoning into home sewage system, install air admittance valve if necessary.
Air in water supply. Check water supply for leaks or other issues letting air inside.
Detergent leaks. Depends on the liquid detergent used and
can be emphasized in case of delay option
is activated.
Small leaks will not cause machine malfunction and can be avoided by changing
liquid detergent type or using tablets.
In case your dishwasher doesn’t work properly, check if the problem can be solved by going through the following list. For other errors or issues
please contact authorized After-sales Service which contact details can be found in the warranty booklet. Spare parts will be available for a period
of either up to 7 or up to 10 years, according to the specic Regulation requirements.
TROUBLESHOOTING
Please scan the on your product in order to have more detailed information. QR code
Policies, standard documentation, ordering of spare parts and additional product information can be found by:
• Using QR code on your product.
• Visiting our website anddocs.whirlpool.eu/docs parts-selfservice.europeanappliances.com
• Alternatively, (See phone number in the warranty booklet). contact our After-sales Service
When contacting our After-sales Service, please state the codes provided on your product’s identication plate.
The model information can be retrieved using the QR-Code reported in the energy label.
The label also includes the model identier that can be used to consult the portal of the registry at https://eprel.ec.europa.eu.
IEC 436
:
®/TM/© 2024 Whirlpool. Produced under license.

Termékspecifikációk

Márka: Whirlpool
Kategória: mosogatógép
Modell: WH3ID10BS7SA0

Szüksége van segítségre?

Ha segítségre van szüksége Whirlpool WH3ID10BS7SA0, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók mosogatógép Whirlpool

Whirlpool

Whirlpool WH3ID10BS7SA0 Útmutató

14 Január 2025
Whirlpool

Whirlpool WH8IA15AM3TUS0 Útmutató

14 Január 2025
Whirlpool

Whirlpool WH8IC15B4M6LHC0 Útmutató

14 Január 2025
Whirlpool

Whirlpool W0I D734L S Útmutató

14 Január 2025
Whirlpool

Whirlpool WH8IB15B2M6LS0 Útmutató

14 Január 2025
Whirlpool

Whirlpool WFE 2B19 Útmutató

14 Január 2025
Whirlpool

Whirlpool ADP 1967 GRM Útmutató

13 Január 2025
Whirlpool

Whirlpool WIE2C19AUSA Útmutató

10 Január 2025
Whirlpool

Whirlpool WH7FA14BN7A0X Útmutató

9 Január 2025
Whirlpool

Whirlpool WH6FB10BS7A0X Útmutató

9 Január 2025

Útmutatók mosogatógép

Legújabb útmutatók mosogatógép

Neff

Neff S583C50X0G Útmutató

14 Január 2025
Etna

Etna ENFI 8517 Útmutató

14 Január 2025
Candy

Candy CDCF 6 Útmutató

14 Január 2025
Ariston Thermo

Ariston Thermo LSI 41 Útmutató

14 Január 2025
Bauknecht

Bauknecht BCIF 5O539 PLEGT Útmutató

14 Január 2025
Grundig

Grundig GNVP4432PW Útmutató

14 Január 2025
Hoover

Hoover HFS 2F492X/E Útmutató

14 Január 2025
Seiki

Seiki SC-1300AU6DWW Útmutató

14 Január 2025
Asko

Asko DFI675XXL Útmutató

13 Január 2025
Smeg

Smeg ST4533IN Útmutató

13 Január 2025