Használati útmutató Waring Commercial DMC180DCA

Waring Commercial Konyhai robotgép DMC180DCA

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Waring Commercial DMC180DCA (2 oldal) a Konyhai robotgép kategóriában. Ezt az útmutatót 2 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/2
014310 RV05 0410
WARING COMMERCIAL
314 Ella T. Grasso Ave.
Torrington, CT 06790
www.waringproducts.com
MIXERS
IMPORTANT SAFEGUARDS
FOR
WARING COMMERCIAL MIXERS
1. READ ALL INSTRUCTIONS.
2. To protect against electrical hazards, do not immerse the
Waring Commercial Mixer in water or other liquid.
3. Unplug from outlet when not in use, before putting on or
taking off parts, and before cleaning.
4. Avoid contacting moving parts.
5. Do not operate the Waring Commercial Mixer or any other
electrical equipment with a damaged cord or plug, or after
the unit malfunctions, is dropped or damaged in any manner.
Return it to the nearest authorized service facility for exami-
nation, repair, or adjustment.
6. Do not use outdoors.
7. Do not let cord hang over edge of table or counter, or touch
hot surfaces.
8. Put this list in a safe place, do not discard.
SAVE THESE INSTRUCTIONS
SOLUTION PRODUCT DILUTION IN WATER TEMPERATURE
WASHING: DIVERSEY WYANDOTTE 4 TABLESPOONS/GALLON HOT (115˚ F)
DIVERSOL BX/A OR CX/A
RINSING: PLAIN WATER WARM (95˚F)
SANITIZING: CLOROX®INSTITUTIONAL 1 TABLESPOON/GALLON COLD (50˚ F -
BLEACH 70˚ F)
+
A. B. C.
Circuit Grounding Conductor
Connected Properly
Grounding Prong
Adapter
Grounding Lug
Cover
Mounting
Screw
Cover of Grounded Outlet Box
CLEANING & SANITIZING INSTRUCTIONS
1. Rinse container thoroughly under running water. Add 8 ounces of clean
rinse water to container. Place container in normal operating position on
mixer and run on high speed for two (2) minutes. Empty container.
2. UNPLUG POWER CORD FROM ELECTRICAL OUTLET.
3. Loosen and remove thumbscrew. Unscrew and remove on/off switch
actuator knob.
4. Carefully remove stainless steel panel.
5. Wash, rinse, and sanitize thumbscrew, on/off switch actuator knob, stain-
less steel panel, and container. Sanitize these parts by immersing in
sanitizing solution for two (2) minutes. Shake off excess moisture and
allow parts to air dry.
6. Working from the top down, wash, rinse, and sanitize the portion of the
mixer housing situated directly over the container, and the portion of the
spindle above the agitator, using absorbent wiping cloths moistened with
cleaning solution, rinse water and sanitizing solution.
7. Reassemble panel, on/off switch actuator knob, and thumbscrew to mixer
housing.
8. Wash, rinse, and sanitize the agitator and the bottom of the spindle as
follows:
❑ Plug power cord into electrical outlet.
❑Add 8 ounces of washing solution to container and place in normal
operating position on mixer.
❑ Run on high speed for a minimum of two (2) minutes.
❑ Empty container, and repeat two-minute run with 8 ounces of rinse
water.
❑ Empty container, and repeat two-minute run with 8 ounces of
sanitizing solution.
❑ Empty container. Run motor for a few seconds with empty container in
normal operating position to spin off any excess moisture. Empty
container. Do not rinse container, spindle, or agitator after sanitizing is
completed.
❑Allow all parts to air dry.
Wash, rinse, and sanitize as outlined above prior to initial use, and whenever
mix will not be used again within a period of one hour.
Surfaces of the mixer housing which are outside of the food-contact areas
may be cleaned as required, using wiping cloths moistened with cleaning
solution, rinse water, and sanitizing solution. UNPLUG POWER CORD
FROM ELECTRICAL OUTLET BEFORE CLEANING HOUSING.
Prevent liquid from running into housing by wringing all excess moisture
from wiping cloths before using them.
Washing solutions based on non-sudsing detergents and chlorine-based
sanitizing solutions having a minimum chlorine concentration of 100 PPM
are recommended.
The following washing, rinsing, and sanitizing solutions, or their equivalents,
may be used.
Green/Yellow: Earth Ground • Blue: Neutral • Brown: Live
GROUNDING INSTRUCTIONS
•For your protection, Waring Commercial Mixers are equipped with a 3-
conductor cordset.
•120 Volt units are supplied with a molded 3-prong grounding-type plug
and should be used in combination with a properly connected grounding
type outlet as shown in Figure A.
If a grounding type outlet is not available, an adapter, shown in Figure B,
may be utilized to enable a 2-slot wall outlet to be used with a 3-prong plug.
Referring to Figure C, the adapter must be grounded by attaching its
grounding lug under the screw of the outlet cover plate.
Caution: Before using an adapter, it must be determined that the outlet
cover plate screw is properly grounded. If in doubt, consult a licensed
electrician.
Never use an adapter unless you are sure it is properly grounded.
Note: Use of an adapter is not permitted in Canada.
•240 Volt units are supplied without a plug, and an appropriate one must be
installed by user in accordance with local electrical codes observing the
following cordset conductor color coding:
OPERATION
After adding materials to be mixed, place container on mixer so that its top
rim engages the spring-loaded on/off switch actuator knob. Slide actuator
knob upward with rim of container to start motor. Seat bottom of container
onto container support.
When mixing is finished, disengage container from support and carefully
lower it, allowing spring-loaded switch knob to slide back down and stop
motor.
On two-speed models, HIGH or LOW speed operation is selected by a
rocker switch located on the top of the mixer housing.
Counter-top models are equipped with Xa U-shaped stabilizing leg on the
base of the unit. For maximum stability, the leg should be unfolded and fully
seated in position, projecting from the rear of the base.

Termékspecifikációk

Márka: Waring Commercial
Kategória: Konyhai robotgép
Modell: DMC180DCA

Szüksége van segítségre?

Ha segítségre van szüksége Waring Commercial DMC180DCA, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók Konyhai robotgép Waring Commercial

Waring Commercial

Waring Commercial Luna WSM7L Útmutató

21 Augusztus 2024
Waring Commercial

Waring Commercial Luna WSM20L Útmutató

21 Augusztus 2024
Waring Commercial

Waring Commercial WFP14SW Útmutató

21 Augusztus 2024
Waring Commercial

Waring Commercial Luna WSM10L Útmutató

21 Augusztus 2024
Waring Commercial

Waring Commercial WFP11SW Útmutató

21 Augusztus 2024
Waring Commercial

Waring Commercial WDM120T Útmutató

12 Augusztus 2024
Waring Commercial

Waring Commercial WFP14SC Útmutató

11 Augusztus 2024
Waring Commercial

Waring Commercial MMB150E/K Útmutató

11 Augusztus 2024
Waring Commercial

Waring Commercial DMC201DCA Útmutató

10 Augusztus 2024
Waring Commercial

Waring Commercial WFP16SCD Útmutató

10 Augusztus 2024

Útmutatók Konyhai robotgép

Legújabb útmutatók Konyhai robotgép

Concept

Concept SM3382 Útmutató

31 Március 2025
Reber

Reber 9508 N Útmutató

30 Március 2025
Reber

Reber 9500 N Útmutató

30 Március 2025
Reber

Reber 8683 N Útmutató

30 Március 2025
Ninja

Ninja BN650UK Útmutató

27 Március 2025
KitchenAid

KitchenAid 5KFP0921 Útmutató

27 Március 2025
TriStar

TriStar MX-4804 Útmutató

15 Január 2025
Create

Create CHEF CHOP Útmutató

15 Január 2025
Bredeco

Bredeco BCPM-1200-EXP Útmutató

15 Január 2025
Bredeco

Bredeco BCPM-1200R Útmutató

15 Január 2025