Használati útmutató TOA WM-5270

TOA mikrofon WM-5270

Olvassa el alább 📖 a magyar nyelvű használati útmutatót TOA WM-5270 (28 oldal) a mikrofon kategóriában. Ezt az útmutatót 5 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF

Oldal 1/28

1. SAFETY PRECAUTIONS

• Be sure to read the instructions in this section carefully before use.

• Make sure to observe the instructions in this manual as the conventions of safety symbols and messages

regarded as very important precautions are included.

• We also recommend you keep this instruction manual handy for future reference.

INSTRUCTION MANUAL

Thank you for purchasing TOA's Wireless Microphone.

Please carefully follow the instructions in this manual to ensure long, trouble-free use of your equipment.

WM-5270WIRELESS MICROPHONE

Indicates a potentially hazardous situation which, if mishandled, could

result in death or serious personal injury.

WARNING

Indicates a potentially hazardous situation which, if mishandled, could

result in moderate or minor personal injury, and/or property damage.

CAUTION

• To prevent the electromagnetic wave from badly inﬂ uencing medical equipment, make sure to switch off the

unit's power when placing it in close proximity to the medical equipment.

• When the unit is not in use for 10 days or more, be sure to take the battery out of the unit because battery

leakage may cause personal injury or contamination of environment.

• Make sure to observe the following handling precautions so that a ﬁ re or personal injury does not result from

leakage or explosion of the battery.

· Do not short, disassemble, heat nor put the battery into a ﬁ re.

· Do not solder a battery directly.

· Be sure to use the speciﬁ ed type of battery.

· Note correct polarity (positive and negative orientation) when inserting a battery in the unit.

· Avoid locations exposed to the direct sunlight, high temperature and high humidity when storing batteries.

• Attention should be drawn to the environmental aspects of battery disposal.

The frequencies between 865 MHz and 867 MHz do not comply with "CE."

CAUTION TO USER: Changes or modiﬁ cations not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.

2. GENERAL DESCRIPTION

The TOA's WM-5270 Wireless Microphone employs a dynamic microphone with high input handling capacity,

and is suitable for vocal use.

3. FEATURES

• An optimized PLL-synthesizer minimizes the oscillation frequency drift resulting from the ambient temperature

or voltage ﬂ uctuation.

• The maximum input sound pressure can be set in the range of 130 dB SPL to 142 dB SPL by a PAD switch,

permitting adaptation to wide range of input sound pressure.

• Power/Battery lamps indicate battery consumption to prevent the unit from malfunctioning when the battery

level remarkably decreases.

• Operates on a single AA battery.

• Employs a built-in antenna.

• The state of battery consumption can be displayed on the tuner's indicator when the unit is used in conjunction

with the optional WT-5800, WT-5805 or WT-5810 Wireless Tuner.

6. REPLACING THE BATTERY

Step 1. Hold down the power switch for one second or more to turn off the

power.

Step 2. Hold the microphone body and rotate the microphone grip

counterclockwise to remove it.

Step 3. Insert an AA battery according to (+) and (–) indications on the

battery compartment.

Step 4. Replace the microphone grip by sliding and rotating it clockwise.

Battery replacement

• A brand-new AA alkaline battery will continuously operate the unit for about

10 hours.

• When the battery capacity becomes low, the green LED of the Power/

Battery lamps starts to dim, while the red LED to light. When only the red

LED lights, replace the battery with a new one. In this condition, the unit

transmits the remaining battery capacity information to the tuner, causing

the tuner's BATT indicator to light.

4. HANDLING PRECAUTIONS

• Do not expose the unit to rain or an environment where it may be splashed by water or other liquids, as doing

so may result in unit failure.

• Never open nor remove the unit case to modify the unit. Refer all servicing to your nearest TOA dealer.

• Take care not to drop the unit onto the ﬂ oor nor bump it against a hard object as the unit could fail.

• Do not place the unit in locations of high temperature (ex. in an ill-ventilated car in summer) or high humidity

as the unit could fail.

• Do not use the unit in locations where it is exposed to seawater.

• To clean, use a dry cloth. When the unit gets very dirty, wipe lightly with a cloth damped in a dilute neutral

cleanser, then wipe with a dry cloth. Never use benzine, thinner, or chemically-treated cleaning towel.

• Avoid using a mobile telephone near the wireless microphone in use. Noise could be picked up.

• When using two or more wireless microphones, keep them at least 50 cm away from each other to avoid

malfunctions or noise.

• Keep the wireless microphone at least 3 m away from the receiving antenna. Using the microphone in close

proximity to the antenna could result in malfunctions or noise.

5. NOMENCLATURE

POWER

BAN K CH ANN EL

I/O

PAD

678 9 A

2 1

BANK CHANNEL

I / O

PAD

56789A

321

Power/Battery lamps

Power ON/OFF switch

Pressing this switch for more than one second turns the power on or off.



Channel selector switch

Keep the switch in the "L" position

(factory-preset).

Leave the switch setting to qualified

service technicians.

Pad switch

This switch is used for microphone sensitivity adjustment.

The sensitivity can be decreased by 0, –6, or –12 dB.

A green LED lights as long as the battery capacity is sufficient. When the battery

capacity becomes low, the green LED starts to dim, while the red LED to light.

The microphone does not transmit the signal if the channel selector switch is set to

the idle channel. In this case, the red LED and green LED flash alternately.

POWER

[Bottom]

Green LED

Power ON/OFF switch

Red LED

7. CHANNEL NUMBER SETTING

Step 1. Switch off the power. Rotate the microphone grip

counterclockwise to remove it.

Step 2. Using the screwdriver housed in the microphone

body, set the Channel selector switch pointer to

the desired channel number.

Step 3. Replace the microphone grip.

Note

Make sure that the wireless microphone is identical to the

wireless tuner in the channel number.

Should the microphone's setting differ from that of the

tuner, the tuner does not receive the microphone signal.

BANK CHANNEL

I / O

PAD

56789A

321

Channel selector

switch

8. PAD SWITCH

The input sensitivity can be decreased by 0 dB, –6 dB or –12 dB with the PAD switch.

Select the appropriate level so that the output sound is not distorted when the volume

control knob of the tuner is set at the 2 o'clock position.

If a loud voice distorts the output sound, decrease the sensitivity by shifting the PAD switch

to the –6 dB or –12 dB position.

Note: The PAD switch is factory-preset to 0 dB.

The table at right shows the relationship

between the PAD switch positions and the

maximum input levels.

9. OPERATION

Step 1. Conﬁ rm that the wireless microphone and the wireless tuner are identical in the channel number.

If not identical, turn off the power ON/OFF switch, then set the channel number to the same channel

number as the tuner.

Step 2. Hold down the power switch for one second or more to turn on the power.

Then, conﬁ rm the green LED of the Power/Battery lamps will light.

Step 3. Hold down the power switch for one second or more to turn off the power after use.

10. OPERATIONAL HINTS

• The microphone's service distance is 3 – 120 m. When the microphone user moves in a facility, signal

dropouts (momentary losses of signal reception) may be encountered. These dropouts are caused by the

building's architectural designs or materials which block the travel of or reﬂ ect the radio signal. If this occurs,

the user needs to change locations for better signal reception.

• The proper operation of your wireless system may be interfered with by other system operating on the same

frequency. In such cases, change the operating frequency of your system. (As to dealing with the interference,

refer to the operating instructions of the wireless tuner.)

• Should you have any questions regarding the use or availability of TOA wireless products, please contact

your local TOA dealer.

• If the output sound is distorted at the large volume level, use the microphone by shifting the PAD (input

sensitivity reduction) switch to the –6 dB or –12 dB position to decrease the sensitivity.

• Attach the supplied rolling stopper as needed, preventing the microphone

from rolling and dropping onto the ﬂ oor.

Rolling stopper

(supplied)

WM-5270

PAD switch Maximum input level

0 dB 130 dB SPL

–6 dB 136 dB SPL

–12 dB 142 dB SPL

BANK CHANNEL

I / O

PAD

56789A

321

Pad switch

Termékspecifikációk

Márka:	TOA
Kategória:	mikrofon
Modell:	WM-5270

Szüksége van segítségre?

Ha segítségre van szüksége TOA WM-5270, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek

Az Ön neve*

Az Ön e-mail címe*

Írja ide kérdését

Útmutatók mikrofon TOA

TOA RM-210 S Útmutató

4 Szeptember 2024

TOA PM-660U Útmutató

30 Augusztus 2024

TOA WM-5270 Útmutató

30 Augusztus 2024

TOA BC-5000-2 Útmutató

30 Augusztus 2024

TOA IR-200BT-2 Útmutató

29 Augusztus 2024

TOA IP-A1MP Útmutató

29 Augusztus 2024

TOA IR-200BC Útmutató

29 Augusztus 2024

TOA AM-1 Útmutató

20 Augusztus 2024

TOA RM-320F Útmutató

30 Július 2024

TOA S2.4HBX Útmutató

29 Július 2024

Útmutatók mikrofon

Legújabb útmutatók mikrofon

Røde NT1 Signature Series Útmutató

10 Április 2025

Genesis Radium 400 G2 Útmutató

9 Április 2025

Ambient TinyMike ATM216 Útmutató

9 Április 2025

Ambient Sound Fish ASF-1 MKII Útmutató

9 Április 2025

Ambient ASF-G Útmutató

9 Április 2025

Ambient Soundfish 2 MkII Útmutató

9 Április 2025

Ambient UMP III Útmutató

9 Április 2025

Comica VP3 Útmutató

2 Április 2025

Atlas Sound MWHHM Útmutató

2 Április 2025

Synco G2A1 Útmutató

2 Április 2025