Használati útmutató StarTech.com IDE2CFINT

StarTech.com nincs kategorizálva IDE2CFINT

Olvassa el alább 📖 a magyar nyelvű használati útmutatót StarTech.com IDE2CFINT (1 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 2 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/1
Introduction
Thank you for purchasing a StarTech.com Compact
Flash to IDE Embedded Card Reader. This product
allows you to connect a compact flash memory card
to a 3.5” IDE Host Interface. After installation, the
host PC will be able to read an inserted Compact
Flash as a standard IDE hard disk.
Features
• Voltage selection for +3.3V or +5.0V compact flash
• On-board LED indicators for power-on and
compact flash access
• Fully compatible with Flash Type I, Type II, and
Micro-drive
• Driverless Hardware, will work with any system that
supports IDE interface
Before You Begin
System Requirements
• An available 40-way (2.54mm) standard IDE
connector
• A +5V floppy disk drive power connector
Basic Setup
Connecting the card reader to the computer
1. Shut down all power connected to the computer as
well as all devices connected to the computer
peripherally. As an added step to ensure safe
installation, unplug the power supply to the
computer.
2. Remove the computer cover. For more detailed
instruction on how to perform this step, please refer
to the documentation that was included with your
computer at the time of purchase.
3. Insert the IDE2CFINT into an available 40-way IDE
connector.
4. Connect the +5V floppy disk drive power
connector (4) to the floppy drive power source.
5. Replace the top of the computer case, as well as
the power cord.
(If your flash card is ready to be installed, skip to
Using the Card Reader - step 3)
Using the Card Reader
Note: This adaptor does not support hot insertion of
CF cards.
1. Make sure the computer is powered down.
2. Open the computer case.
3. Gently insert the desired Compact Flash Card into
the provided socket, using the guide rails to ensure
the pins on the reader are properly aligned with the
card. Note: If the Flash Card is not properly
aligned, you risk causing permanent damage to the
card as well as to the reader.
4. Once the flash card is secured, replace the cover
on the computer casing.
Upon powering the computer back on, the flash card
should be detected as an IDE hard drive.
J
J
J
J
Ju
u
u
u
um
m
m
m
mp
p
p
p
pe
e
e
e
er
r
r
r
r
s
s
s
s
se
e
e
e
et
t
t
t
tt
t
t
t
ti
i
i
i
in
n
n
n
ng
g
g
g
gs
s
s
s
s
By default, the IDE2CFINT is set to act as a Master
drive. As such, ensure that this is reflected accurately
from within your system BIOS. To change the
IDE2CFINT to act as a Slave drive, adjust the
jumper located on JP3 to pins 2 and 3, making the
necessary adjustments to your BIOS settings.
L
L
L
L
LE
E
E
E
ED
D
D
D
D f
f
f
f
fu
u
u
u
un
n
n
n
nc
c
c
c
ct
t
t
t
ti
i
i
i
io
o
o
o
on
n
n
n
ns
s
s
s
s
LED 1 - Card detect indicator
LED 2 - Memory Access activity indicator
LED 3 - Power-on indicator
Warranty and Support
Compact Flash to IDE Embedded Card
Reader
IDE2CFINT
Revised: 22 December 2005 (A)
Support, Warranty Information, and Regulatory Compliance Statement
If you ever need help with your product, visit and access our com-www.startech.com/support
prehensive selection of online tools, documentation, and downloads. This product is backed by a
one-year warranty. In addition, StarTech.com warrants its products against defects in mater ials
and workmanship for the periods noted, following the initial date of purchase. During this period,
the products may be returned for repair, or replacement with equivalent products at our discre-
tion. The warranty covers parts and labor costs only. StarTech.com does not warrant its products
from defects or damages arising from misuse, abuse, alteration, or normal wear and tear.
Limitation of Liability: In no event shall the liability of StarTech.com Ltd. and StarTech.com USA
LLP (or their officers, directors, employees or agents) for any damages (whether direct or indirect,
special, punitive, incidental, consequential, or otherwise), loss of profits, loss of business, or any
pecuniary loss, arising out of or related to the use of the product exceed the actual price paid for
the product. Some states do not allow the exclusion or limitation of incidental or consequential
damages. If such laws apply, the limitations or exclusions contained in this statement may not
apply to you.
FCC Compliance Statement: This equipment has been tested and found to comply with the lim-
its for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is con-
nected.
• Consult the dealer or an experienced radio/TV technician for help.
Power
JP1JP2JP3
1
2
3
LED 1
LED 3
LED 2
Flash Card Socket

Termékspecifikációk

Márka: StarTech.com
Kategória: nincs kategorizálva
Modell: IDE2CFINT

Szüksége van segítségre?

Ha segítségre van szüksége StarTech.com IDE2CFINT, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók nincs kategorizálva StarTech.com

StarTech.com

StarTech.com MCM110SC2P Útmutató

26 Szeptember 2024
StarTech.com

StarTech.com PLATE9M Útmutató

26 Szeptember 2024
StarTech.com

StarTech.com RACKCONV1901 Útmutató

26 Szeptember 2024
StarTech.com

StarTech.com PLATE9MB Útmutató

26 Szeptember 2024
StarTech.com

StarTech.com ET91000LC2 Útmutató

26 Szeptember 2024
StarTech.com

StarTech.com ET10GSFP Útmutató

26 Szeptember 2024
StarTech.com

StarTech.com MCM1110SFP Útmutató

26 Szeptember 2024
StarTech.com

StarTech.com ET91000SFP2 Útmutató

26 Szeptember 2024
StarTech.com

StarTech.com ET91000LC Útmutató

26 Szeptember 2024
StarTech.com

StarTech.com ET91000LCOAM Útmutató

26 Szeptember 2024

Útmutatók nincs kategorizálva

Legújabb útmutatók nincs kategorizálva

Roland

Roland SD-20 Útmutató

16 Október 2024
SilverCrest

SilverCrest SRG 1300 C3 Útmutató

16 Október 2024
IFM

IFM TY0058 Útmutató

16 Október 2024
Thule

Thule Kit 186039 Útmutató

16 Október 2024
Blumfeldt

Blumfeldt Solidflor Útmutató

16 Október 2024
Dimplex

Dimplex QRAD200E Útmutató

16 Október 2024
DAS Audio

DAS Audio AX-112-5 Útmutató

16 Október 2024
Ferplast

Ferplast Ergocomfort Freetime Útmutató

16 Október 2024
AEG

AEG MECK52 Útmutató

16 Október 2024
Black Diamond

Black Diamond BD1121530000ALL1 Útmutató

16 Október 2024