Használati útmutató Speco Technologies O4DT1

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Speco Technologies O4DT1 (11 oldal) a Térfigyelő kamera kategóriában. Ezt az útmutatót 6 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/11
Quick Start Guide
4MP Turret IP Camera
O4DT1
Version 1.0.0
i
Welcome
Thank you for purchasing this network camera!
This manual is designed to be a reference guide for the product .
Please read this manual carefully before operang the unit and retain it for future reference.
Should you require any technical assistance, please contact Speco Technologies Technical Support.
ii
Important Safeguards and Warnings
1 Electrical safety
All installaon and operaon here should conform to local electrical safety codes.
Use a cered/listed 12VDC Class 2 power supply only.
Please note: Do not connect two power supplying sources to the device at the same me; it may
result in device damage! The product must be grounded to reduce the risk of electric shock.
Improper handling and/or installaon could run the risk of re or electrical shock.
2 Environment
Heavy stress, violent vibraon or exposure to water is not allowed during transportaon, storage
and installaon.
This product should be installed in a cool, dry place away from direct sunlight and heat sources.
Do not install the product in extreme temperature condions.
Do not expose the camera to electromagnec radiaon. Otherwise it may result in CMOS sensor
failure.
Do not block any venlaon openings.
Do not allow water and liquid intrusion into the camera.
3. Operaon and Daily Maintenance
Please shut down the device and then unplug the power cable before you begin any maintenance
work.
Do not touch the CMOS sensor opc component. You can use a blower to clean the dust on the
lens surface.
Always use the dry so cloth to clean the device. If there is too much dust, use a cloth dampened
with a small quanty of neutral detergent. Finally use the dry cloth to clean the device.
Please use a professional opcal cleaning method to clean the enclosure. Improper enclosure
cleaning (such as using cloth) may result in poor IR funconality and/or IR reecon.
The grounding holes of the product are recommended to be grounded to further enhance the
reliability of the camera.
Dome cover is an opcal device, please don’t touch or wipe cover surface directly during
installaon and use, please refer to the following methods if dirt is found:
Stained with dirt
Use oil-free so brush or hair dryer to remove it gently.
Stained with grease or ngerprint
Use oil-free coon cloth or paper soaked with alcohol or detergent to wipe from the lens center
outward. Change the cloth and wipe several mes if it is not clean enough.

Termékspecifikációk

Márka: Speco Technologies
Kategória: Térfigyelő kamera
Modell: O4DT1

Szüksége van segítségre?

Ha segítségre van szüksége Speco Technologies O4DT1, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók Térfigyelő kamera Speco Technologies

Útmutatók Térfigyelő kamera

Legújabb útmutatók Térfigyelő kamera