Használati útmutató Ring RBGDC50

Ring Dashcam RBGDC50

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Ring RBGDC50 (5 oldal) a Dashcam kategóriában. Ezt az útmutatót 5 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/5
Dash Camera Troubleshoong Guide
Page | 1 Rev 1
Recording Problems
1. Camera stops recording for no reason
For DC10/50 models, check if Moon Detecon feature is switched on. In order to save space on smaller
SD cards this feature will stop recording whenever no moon is detected in front of the camera. When
movement is detected the camera will commence recording again. For larger SD cards this feature is not
required.
To turn this feature o select:-
MENU > Video > Moon Detecon > O
DC10/50
2. Screen goes blank during recording
Check if the Backlight or LCD Power Save funcon is switched on. This feature will switch o the LCD ‘ ’ ‘ ’
screen aer a selected me in order to reduce distracon at night. This may give the impression
recording has stopped but it will sll be recording in the background.
To turn this feature o select:-
For DC10/50 models - MENU > Setup > Backlight > O
For DC200 model MENU > General Setngs > LCD Power Save –
DC10/50 DC200
3. Camera does not start recording aer ignion switched on
This can happen if the internal baery is heavily discharged. If the camera has not been used for some
me and the internal baery is fully discharged, it may take a few minutes before there is sucient
energy from the power adapter to charge the baery and power the dash camera
4 Recording is intermient .
4.1 Check SD card speed
Check the SD card being used has a speed of at least Class 6 (preferably Class10). The speed of the card
is indicated by a number inside a circle like below. If the SD card is not fast enough recording may be
intermient and les may become corrupted, causing playback problems.
Dash Camera Troubleshoong Guide
Page | 2 Rev 1
4.2 Check SD card is not fake
There are some fake SD cards on the market, which may not perform to their specied speed and cause
recording problems, especially when recording at Full HD resoluon. If you wish to check the speed of
an SD card there are programs available such as which can conrm the data transfer rate. HD Tune
The table below shows expected transfer rates for each class of SD card. Highlighted in red are speeds
for the Class6 & Class10 cards recommended for use with Ring dash cameras
4.3 Check SD card is compable with camera
Check the SD card being used is not the UHS - Ultra High Speed type (indicated by a number inside a ‘U’),
as these may not be compable with the current Ring dash cameras.
4.4 Check power supply
Check the 12V power adapter is securely ed into the car power socket and the LED is always
illuminated whilst the engine is switched on. If the LED ickers or goes out during use, then the power
adapter may not be securely ed into the socket, which will cause the camera to power down.
Check the fuse in the end of the adapter is not blo wn
Dash Camera Troubleshoong Guide
Page | 3 Rev 1
Check the cable for damage, which may have caused the fuse to blow
4.5 Check 12V power socket on Stop/Start vehicles
If you have a stop/start vehicle, check that the 12V power socket does not power down when the
vehicle enters stop/start mode. If this happens the dash camera will also switch o. In this case the hard
wire kit (Part: RBGDCHK) can be used to connect directly to the vehicle fuse box
5. Error message is displayed
5.1 ‘Card Full’ message appears on screen
If the loop recording funcon is set to O this message will be displayed when the card becomes full. ‘ ’
To avoid this problem set the length of each video clip to 3 or 5 minutes using the procedure below. This
will ensure ‘loop mode’ is acvated, which will automacally delete the oldest les when the card
becomes full.
For DC10/50 model – MENU > Video > Loop Recording
For DC200 model MENU > Movie Mode > Move Clip Time –
5 Card Error message appears on screen .2 ‘ ’
The SD card has become corrupted. Remove the useful les then re-format the card using the camera
menu opon
For DC10/50 models MENU > Setup > Format –
For DC200 model MENU > General Setngs > Format SD- –Card
File transfer problems
1. Error when connecng via USB
If the error similar to below appears then the SD card may not have been correctly formaed.
Re-format the SD card using procedure below depending on camera model
For DC10/50 models MENU > Setup > Format –
For DC200 model MENU > General Setngs > Format SD- –Card

Termékspecifikációk

Márka: Ring
Kategória: Dashcam
Modell: RBGDC50

Szüksége van segítségre?

Ha segítségre van szüksége Ring RBGDC50, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók Dashcam Ring

Ring

Ring RBGDC50 Útmutató

13 Július 2024

Útmutatók Dashcam

Legújabb útmutatók Dashcam

Rexing

Rexing V33 Útmutató

14 Január 2025
Navman

Navman DDR MiVue 740 Útmutató

14 Január 2025
Navman

Navman Smart Box II Útmutató

14 Január 2025
Alpine

Alpine PKG-RSE3DVD Útmutató

13 Január 2025
Cobra

Cobra SC 250R Útmutató

11 Január 2025
Cobra

Cobra SC 220C Útmutató

11 Január 2025
Hikvision

Hikvision AE-DC5313-C6PRO Útmutató

11 Január 2025
Minolta

Minolta MNCD406X Útmutató

11 Január 2025
Sencor

Sencor SCR 3400 Útmutató

7 Január 2025
Sencor

Sencor SCR 3300 Útmutató

7 Január 2025