Használati útmutató Presto Nitro 02939

Presto Kávéfőző Nitro 02939

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Presto Nitro 02939 (14 oldal) a Kávéfőző kategóriában. Ezt az útmutatót 7 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/14
• Enjoy smooth, flavorful nitro cold brew coffee on tap, at home!
No more paying for high-priced coffee shop nitro brews.
• Infuse cold brew with flavor! Add nitrous oxide or pure nitrogen*
for a smooth texture, delicate flavor, and rich, creamy head.
• Keg fits easily in most home refrigerators for delicious nitro coffee
on demand.
• Holds up to 48 ounces of cold brew.
INSTRUCTIONS ©2021 National Presto Industries, Inc.
Form 4015-046A
Visit www.GoPresto.com
Estas instrucciones también están disponibles en español.
Para obtener una copia impresa:
• Descargue en formato PDF en www.GoPresto.com/espanol.
• Envíe un correo electrónico a contact@GoPresto.com.
• Llame al 1-800-877-0441, oprima 2 y deje un mensaje.
*Dispenser works with 8 g
nitrous oxide (NO) cartridges
and 2 g pure nitrogen (N)
cartridges. Cartridges not
included.
Nitro Coffee
dispenser
Important Safety Information
To reduce the risk of personal injury or property damage when using this appliance, basic safety precautions should always be observed,
including the following:
1. Read all instructions before using this coffee dispenser.
2. When charging this unit, do not exceed one 8-gram cartridge of nitrous oxide (N
2O) or two 2-gram cartridges of nitrogen (N
2).
3. WARNING! Nitrous oxide cartridges are to be used only for the purpose of preparing coffee. Do not inhale the contents of the cartridge.
Misuse of nitrous oxide can be dangerous to your health.
4. Close supervision is necessary when this appliance is used near children. It is not recommended that children use this appliance.
5. Do not use if keg is dented, bulged out, or damaged. If the bottom of the keg has bulged out, the pressure inside the keg has exceeded
safe limits and the dimple has inverted to safely reduce pressure. The unit must be replaced.
6. Do not operate in the event the appliance malfunctions or has been damaged in any manner. Return the appliance to the Presto Factory
Service Department for examination, repair, or adjustment.
7. The use of accessory attachments not recommended by the appliance manufacturer may cause injuries. Use only genuine Presto
® acces-
sory attachments and replacement parts.
8. Do not place on or near a hot gas or electric burner, in a heated oven, microwave oven, or freezer.
9. This unit is not designed for hot liquids; nonfood; or caustic, highly acidic materials.
10. Do not use appliance for other than intended use.
This appliance requires nitrous oxide (N
2O) or pure nitrogen (N2) cartridges, which are SOLD
SEPARATELY.
Non-threaded 8 g N2O whipped cream chargers and 2 g N
2 chargers are compatible with this coffee
dispenser. They are available online and at select retailers.
CO2 cartridges are not recommended for making nitro cold brew coffee.
Fig. A Push-down tap
Dispensing spout
Cartridge valve
Cartridge holder
Spout connector
Pressure release
valve with ring
Tap head
Collapsible funnel
Silicone tube
Keg brush
Spout brush
Keg cap
(used to store coffee
before nitrogenation)
Barbed tting
Stainless steel
mini keg
Keg opening
ACCESSORIES INCLUDED
Tap head O-ring
SPARE PARTS INCLUDED
Flat end
Extra silicone tube
One set of replacement O-rings
for spout and tap head
Tap assembly
includes:
• Push-down tap
• Tap head
• Dispensing spout
Fig. D
Fig. E
Fig. B
O-rings
Spout connector
Rounded end
of cartridge
Cartridge
holder
Cartridge
valve
Fig. C
Flat end
Barbed
tting
Cartridge holder
Dispensing
spout
2
Getting Acquainted
Before using the Presto® Nitro Coffee Dispenser, become familiar with the various parts (Fig. A). Unscrew the tap head and remove it
from the mini keg. Wash the tap head, mini keg, silicone tubes, dispensing spout, and silicone funnel in warm, soapy water. Rinse and
dry thoroughly.
How to Use
1. Remove tap head from mini keg. Expand funnel and place in keg opening. The
funnel must be fully extended to work properly.
Note: If using homemade cold brew coffee, it must be ltered before pouring
into keg and infusing with gas.
2. Pour up to 48 ounces store-bought or ltered homemade cold brew coffee into
keg and remove funnel. You can charge as little as you like, but do not exceed
48 ounces. If your cold brew is a concentrate, dilute as you would for drinking.
DO NOT OVERFILL, as you must leave space in the keg for the injected gas.
IMPORTANT: Do not add dairy/non-dairy beverages or creamers, sugar, or sweeteners to the keg as
blockage of the tap head could occur. Instead, add them to the glass before dispensing coffee.
3. Attach dispensing spout to spout connector (Fig. B).
Tip: For easy insertion, prior to attachment, run spout connector under hot tap water.
4. Attach the at end of one of the two silicone tubes to the barbed tting (Fig. C). Push and twist the tube
until it is past the second barb. Retain the second tube as a spare.
5. Insert tap assembly into keg and screw on until tight.
6. Place one non-threaded 8 g N
2O cartridge or one 2 g N2 cartridge into cartridge holder, rounded end
rst (Fig. D).
Screw cartridge holder onto cartridge valve until you hear a whoosh sound (Fig. E). This
indicates cartridge is pierced and gas has been injected into keg.
Note: You may hear a slight amount of gas escape and notice a few drops of coffee by the pressure
release valve. This is normal.
Fig. F
3
7. Unscrew cartridge holder and discard cartridge. Shake keg side to side and up and down for 15 to 20 seconds.
If using pure nitrogen (N
2), allow keg to rest for 20 minutes and then charge with a second 2 g cartridge.
8. Place keg in refrigerator and allow it to rest for at least an hour.
9. Remove keg from refrigerator. Shake keg
for 15 to 20 seconds.
Place glass under spout and press tap to
dispense coffee.
10. Rotate spout up for drip-free storage (Fig. F). Store in refrigerator up to 7 days.
11. Once keg is empty, disassemble and clean per the instructions below.
Care and Cleaning
1. Pull up on pressure release valve ring (Fig. A, page 2) to release any remaining gas in keg.
2. Unscrew tap assembly and remove it from keg. Pour out any remaining coffee.
3. Pull silicone tube off the barbed tting and dispensing spout off spout connector.
4. To ush coffee out of the barbed tting, run water through the spout connector while pressing down the tap.
5. Wash keg, silicone tube, tap head, dispensing spout, and collapsible funnel in warm water. Use small brush to thoroughly clean
inside both ends of the dispensing spout.
IMPORTANT: Do not wash any of the coffee dispenser parts in the dishwasher. Also avoid using harsh detergents, degreasers,
abrasives, or acidic cleaning agents.
Note: For a more thorough cleaning, ll keg with hot water and 1 tablespoon baking soda and soak for 10 minutes. Use large keg
brush to clean inside keg, reaching the entire bottom and top inside rim. Rinse thoroughly.
6. Allow keg to dry upside down. Do not reattach tap head or keg cap until keg is completely dry.
7. Over time, O-rings on spout and tap head may tear or become damaged. If this occurs, one set of replacement O-rings is included.
Remove worn O-ring(s) with your ngernail, the end of a paper clip, or carefully cut with an X-acto* knife. Discard and replace
with new O-ring(s).
Questions and Answers
I did not hear a “whoosh” sound when I attached the cartridge holder to the cartridge valve. Why?
1. The cartridge may not be positioned correctly in the cartridge holder
(Fig. D, page 2). Reposition it and try again.
2. The cartridge holder is not screwed on far enough. Turn it until you hear a “whoosh”.
3. The cartridge may have already been used or is defective. Try again with a new cartridge.
When I charged the coffee dispenser, coffee sprayed out of the unit and an excessive amount of gas released. What caused this?
You used more than 48 ounces of coffee. When you overll the keg, there is not enough room for the injected gas, causing a brief
release of the excess gas and coffee. If this occurs, remove the tap assembly and empty the coffee into a container. Remeasure the
coffee and repeat the steps on page 2; do not use more than 48 ounces of coffee.
There is no foam on my coffee or cascading. What am I doing wrong?
The coffee may have lost some gas during storage. Charge it with another cartridge.
Sometimes when I dispense the coffee, very little comes out. Why does this happen?
1. Sediment in the keg may have blocked the tap head due to inadequately ltered homemade coffee. Relter the coffee and then
recharge it.
2. The coffee may have lost some gas during storage. Charge it with another cartridge.
*X-acto is a registered trademark of Sanford, L.P. Presto is not affiliated with this company.

Termékspecifikációk

Márka: Presto
Kategória: Kávéfőző
Modell: Nitro 02939

Szüksége van segítségre?

Ha segítségre van szüksége Presto Nitro 02939, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók Kávéfőző Presto

Presto

Presto Nitro 02939 Útmutató

2 Október 2024
Presto

Presto 02815 Útmutató

31 Július 2024
Presto

Presto 6-Cup Stainless Steel Útmutató

21 Július 2024
Presto

Presto MyJo 02835 Útmutató

8 Július 2024
Presto

Presto 02811 Útmutató

7 Július 2024

Útmutatók Kávéfőző

Legújabb útmutatók Kávéfőző

Bialetti

Bialetti Moka Express 2 Útmutató

9 Április 2025
Bravilor Bonamat

Bravilor Bonamat RLX 131 Útmutató

7 Április 2025
Aroma

Aroma AEM-108 Útmutató

7 Április 2025
Cloer

Cloer 5021 Útmutató

6 Április 2025
Electra

Electra Micro Casa Útmutató

5 Április 2025
Bodum

Bodum 1928-18 Útmutató

4 Április 2025
Jura

Jura IMPRESSA XJ9 Professional Útmutató

2 Április 2025
Gerlach

Gerlach GL 4411 Útmutató

2 Április 2025
Harper

Harper HCM702 Útmutató

2 Április 2025
ProfiCook

ProfiCook KA 1137 Útmutató

1 Április 2025