Használati útmutató Minn Kota MK 230PC

Minn Kota Akkumulátor töltő MK 230PC

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Minn Kota MK 230PC (13 oldal) a Akkumulátor töltő kategóriában. Ezt az útmutatót 3 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/13
OWNER’S MANUAL FOR
MINN KOTA ONBOARD
BATTERY CHARGERS
Models: MK115PC, MK230PC,
MK345PC, MK460PC
Service Information:
Please call our service department at
1.800.227.6433 if you have any problems
with your battery charger. A technical support
representative will be happy to assist you.
Compliant with FCC
PART 15, Class A
Designed and Constructed to
Marine UL1236 Standard.
2
1) IMPORTANT SAFETY INSTRUCTIONS
a) SAVE THESE INSTRUCTIONS! This manual contains important safety and operating instructions applicable to the safe and efficient use
of your Minn Kota battery charger.
b) The Minn Kota battery charger is a powerful electrical device. If incorrectly installed, configured or operated, the battery charger can damage
batteries and / or electrical equipment. Please thoroughly read the instructions and safety information contained in this manual before operat-
ing the battery charger.
c) Use of an attachment not recommended or sold by Johnson Outdoors Inc. may result in risk of fire, electric shock, or injury to persons or prop-
erty.
d) The charger is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure that they do not
play with the charger.
e) To reduce risk of damage to electric plug or cord, pull by the plug rather than the cord when disconnecting the battery charger.
f) An extension cord should not be used unless absolutely necessary. Use of the improper extension cord could result in a risk of fire or electric
shock. If extension cord must be used, make sure:
i) That pins of plug of the extension cord are the same number, size and shape of those of the plug on the battery charger;
ii) That extension cord is properly wired and in good electrical condition; and
iii) That wire in extension cord is proper size as follows:
g) Do not operate the battery charger with a damaged cord or plug.
h) Do not operate the battery charger if it has received a sharp blow, been dropped or otherwise damaged in any way.
i) Do not disassemble the charger. Incorrect reassembly may result in a risk of electric shock or fire.
j) To reduce risk of electric shock, unplug the charger from outlet before attempting any maintenance or cleaning. Disconnecting the leads will not
reduce this risk.
k) To reduce risk of shock or spark, never touch the ring terminals together while the charger is plugged into an outlet or extension cord.
l) External connections to the battery charger shall comply with the United States Coast Guard electrical regulations (33CFR183, Sub Part 1).
2) PERSONAL PRECAUTIONS
a) Consider having someone close enough nearby to come to your aid when you work near a lead acid battery.
b) Have plenty of fresh water and soap nearby in case battery acid contacts skin, clothing or eyes.
WARNING: RISK OF EXPLOSIVE GASES
WORKING IN THE VICINITY OF A LEAD ACID BATTERY IS DANGEROUS. BATTERIES CONTAIN SULFURIC ACID AND PRODUCE
EXPLOSIVE GASES. A BATTERY EXPLOSION COULD RESULT IN LOSS OF EYESIGHT OR SERIOUS BURNS. FOR THIS REASON, IT
IS OF UTMOST IMPORTANCE THAT YOU FOLLOW THE INSTRUCTIONS EACH TIME YOU USE THE CHARGER.
TO REDUCE THE RISK OF BATTERY EXPLOSION, FOLLOW THESE INSTRUCTIONS AND THOSE PUBLISHED BY THE BATTERY
MANUFACTURER FOR ANY EQUIPMENT YOU INTEND TO USE IN THE VICINITY OF THE BATTERY. REVIEW CAUTIONARY
MARKINGS ON THESE PRODUCTS AND ON ENGINE, MOTOR OR OTHER EQUIPMENT REQUIRING BATTERY USAGE.
Minimum recommended AWG wire size for various length extension cords used with the Minn Kota battery charger:
MK115PC Length of Cord in feet 25 50 100 MK230PC Length of Cord in feet 25 50 100
AWG Size 18 18 16 AWG Size 16 16 12
MK345PC Length of Cord in feet 25 50 100 MK460PC Length of Cord in feet 25 50 100
AWG Size 16 12 10 AWG Size 14 12 10
WARNING – DO NOT ATTEMPT TO REPAIR OR SERVICE THE CHARGER YOURSELF. OPENING THE CHARGER MAY EXPOSE YOU
TO HIGH VOLTAGES, THE RISK OF ELECTRIC SHOCK, AND OTHER HAZARDS.
c) Wear complete eye protection and clothing protection. Avoid touching eyes while working near battery.
d) If battery acid contacts skin or clothing, wash immediately with soap and water. If acid enters eye, immediately flush eye with running cold
water for at least 10 minutes and get medical attention immediately.
e) Never smoke or allow a spark or flame in vicinity of battery, engine, motor or other flammable or explosive equipment.
f) Be extra cautious to reduce risk of dropping a metal tool onto the battery or across the battery terminals. It might spark or short circuit the bat-
tery or other electrical component that may cause an explosion.
g) Remove personal metal items such as rings, bracelets, necklaces, and watches when working with a lead acid battery. A lead acid battery
can produce a short circuit current high enough to weld such items, causing severe burns.
h) Use the Minn Kota battery charger for charging and maintaining FLOODED LEAD-ACID, MAINTENANCE FREE, GEL CELL, AND AGM /
STARVED ELECTROLYTE batteries only. It is not intended to supply power to low voltage electrical systems other than for charging and
maintaining batteries. Do not use the charger for charging dry-cell batteries that are commonly used with home appliances. These batteries
may burst and cause injury to persons and damage to property.
i) NEVER charge a frozen battery.
3) PREPARING TO CHARGE
a) If necessary to remove battery from boat or vehicle to charge or maintain, always remove grounded terminal from battery first (if applicable).
Make sure all accessories in the boat or vehicle are off, so as not to cause an arc.
b) Be sure area around battery is well ventilated while battery is being charged or maintained.
c) Clean battery terminals. Be careful to keep corrosion from coming in contact with eyes.
d) Add distilled water in each cell until battery acid reaches level specified by battery manufacturer. Do not overfill. For a battery without remov-
able cell caps, such as valve regulated lead acid batteries, carefully follow manufacturer’s recharging instructions.
e) Study all battery manufacturers’ specific precautions while charging and for recommended rates of charge.
4) CHARGER LOCATION AND MOUNTING
a) Locate charger as far away from battery as the dc cables permit.
b) Never place charger above battery being charged; gases from battery will corrode and damage charger.
c) Never allow battery acid to drip on charger when reading electrolyte specific gravity or filling battery.
d) Do not operate charger in a closed-in area or restrict ventilation in any way.
e) Do not set a battery on top of charger.
f) Do not mount the charger below the waterline of the boat or directly adjacent to fuel tanks.
g) Each DC output cord is six feet long. Make sure that all DC output cords can reach the batteries and that the AC power cord can reach a
power source. When using an extension cord, make the AC connection to the charger outside of the battery compartment as far away as
practical to reduce the risk of a spark igniting gasses in the compartment.
h) Each output cord is equipped with a temperature sensor. By monitoring external temperature, the battery charger adjusts the charging profile
of the battery to assure full charge without overcharging or undercharging the battery. Attempting to shorten the output wires could damage
the temperature sensor and affect the charger output.
i) If the DC battery leads are not long enough, they may be lengthened by splicing and soldering 12 AWG (minimum) wire. Each splice should
be covered with dual wall adhesive lined heat shrink tubing to protect the joint from corroding. The splice should be made between the
fork in the output cable and the fuse holder. The fuse holder should always remain within 7” of the battery terminals. The maximum exten-
sion length is 15 feet. You may contact the Minn Kota Service Department with any questions. Do not splice the AC power cord, as this
voids the three year Limited Warranty.
3

Termékspecifikációk

Márka: Minn Kota
Kategória: Akkumulátor töltő
Modell: MK 230PC

Szüksége van segítségre?

Ha segítségre van szüksége Minn Kota MK 230PC, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók Akkumulátor töltő Minn Kota

Minn Kota

Minn Kota MK 106D Útmutató

29 Július 2024
Minn Kota

Minn Kota MK 210D Útmutató

29 Július 2024
Minn Kota

Minn Kota MK 220D Útmutató

29 Július 2024
Minn Kota

Minn Kota MK 230PC Útmutató

29 Július 2024
Minn Kota

Minn Kota MK 440D Útmutató

29 Július 2024
Minn Kota

Minn Kota MK 330D Útmutató

29 Július 2024

Útmutatók Akkumulátor töltő

Legújabb útmutatók Akkumulátor töltő

Alecto

Alecto BL-179 Útmutató

15 Január 2025
Graupner

Graupner Ultramat 12 Útmutató

13 Január 2025
Fuxtec

Fuxtec FX-E1LG1A Útmutató

13 Január 2025
Voltcraft

Voltcraft Charge Manager 410 Útmutató

12 Január 2025
Nitecore

Nitecore UHX1 PRO Útmutató

12 Január 2025
Envivo

Envivo ENV-1597 Útmutató

11 Január 2025
Nitecore

Nitecore EMR05 TAC Útmutató

11 Január 2025
Xblitz

Xblitz XC1 Útmutató

11 Január 2025
Jackery

Jackery Explorer 240 v2 Útmutató

8 Január 2025
Jackery

Jackery Explorer 1000 v2 Útmutató

8 Január 2025