Használati útmutató Midea MF-16FW15KRA

Midea Ventilator MF-16FW15KRA

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Midea MF-16FW15KRA (15 oldal) a Ventilator kategóriában. Ezt az útmutatót 3 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/15
ELECTRIC FAN
Ba asa Melayu
English
h
中文
16”REMOTE-CONTROL WALL FAN
MODEL:MF-16FW15KRA
1. If the supply cord is damaged, it must be replaced by manufacturer
or its service agent or a similarly qualified person in order to avoid
a hazard.
2. Indoor use only.
3. To protect against the risk of electrical shock, do not immerse the
unit, cord or plug in water or other liquid.
4. This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety
Young children should be supervised to ensure that they do not
play with the appliance.
5. When the appliance is not in use and before cleaning, unplug the
appliance from the outlet.
6. When the fan was assembled, the rotor blade guard shall not be
taken off anymore.
7. Correct Disposal of this product
This marking indicates that this product should not be
dispOSCd with other household wastes throughout the EU. To
prevent possible harm to the environment or human health from
uncontrolled waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources. To return your used
device, please use the return and collection systems or contact
the retailer where the product was purchased. They can take this
product for environmental safe recycling.
1
PART FIGURE
1.Front guard
2.Spinner
3.Circlip
4.Blade
5. Plastic nut
6.Rrea guard
7.Motor shaft
8.Motor
CAUTION
WARNING
RULES FOR SAFE OPERATION
1. Never insert finger, pencil, or any other object through the grille when fan is
running.
2. Disconnect fan when moving from one location to another.
3. Be sure fan is on a stable surface when operating to avoid overturning.
4. DO NOT use fan in window, rain may create electrical hazard.
5. Indoor use only.
Read Rules for Safe Operation and Instructions Carefully.
2
1. Remove the spinner and the plastic nut from the front side of the motor.
Fix the rear grille to the motor then tighten the plastic nut again. (Fig.1)
2. Insert the blade into shaft, make sure the stopper pin is fitted into groove of the
blade. Turn the spinner counter clockwise to tighten the blade. (Fig.2)
3. Fix the front guard and the rear guard with circlip and then use the fasten clip
to tighten the fan guard. (Figure 3)
MOUNTING ON THE WALL
The fan should be installed on a solid wooden or
pillar which stands vertically to the floor.
Caution: To prevent the fan from falling off, do not
install it on walls less then 10 cm thick or made of
materials that are easily damaged.
1.Installing the mounting bracket
Fix the supplied mounting bracket firmly to the wall
using the two screws.
NOTE: The bracket should be pceiling and at least 30 cm from adjoining wall.
2.Installing the stand
Mount the stand on the bracket by inserting the bracket catch into the slot on the
stand.
TO ADJUST THE WIND DIRECTION
Push the guard lightly to the desired or down direction.
OPERATING INSTRUCTION
ASSEMBLY OF BLADE OF GRILLES
Fig.1 Fig.2 Fig.3

Termékspecifikációk

Márka: Midea
Kategória: Ventilator
Modell: MF-16FW15KRA

Szüksége van segítségre?

Ha segítségre van szüksége Midea MF-16FW15KRA, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók Ventilator Midea

Útmutatók Ventilator

Legújabb útmutatók Ventilator

Windmill

Windmill FC07W3 Útmutató

22 December 2024
Windmill

Windmill FC07W1 Útmutató

22 December 2024
Windmill

Windmill FC07W2 Útmutató

22 December 2024
Windmill

Windmill FC07W5 Útmutató

22 December 2024
NewAir

NewAir NFN12AWH00 Útmutató

22 December 2024
NewAir

NewAir AF-600 Útmutató

22 December 2024
Yamazen

Yamazen FCR-D408 Útmutató

21 December 2024
Yamazen

Yamazen FCT-D408 Útmutató

21 December 2024
Yamazen

Yamazen FCR-J401 Útmutató

21 December 2024