Használati útmutató Lindy NC-60

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Lindy NC-60 (12 oldal) a fejhallgató kategóriában. Ezt az útmutatót 5 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/12
NC-60
ACTIVE NOISE CANCELLING
These headphones have been developed to deliver superb quality Hi-Fi sound without the distraction of annoying
background noise. NC-60 benefits from both a Lindy two year warranty and free lifetime technical support. To
ensure correct use, please read this manual carefully and retain for future use.
Thank you for purchasing these NC-60 Noise Cancelling Headphones.
Product Contents
NC-60 Headphones 3.5mm audio cable, 1.5m 1/4’’ stereo-plug adapter
Dual-plug flight adapter 2 x AAA Batteries Carry case with mesh pouch
40mm high output
drivers with
neodymium magnets
Battery compartment,
remove to install
2 x AAA batteries
Volume control
Selectable active noise
cancellation removes up
to 85% of external noise
Lightweight design
for optimum comfort
Features and Benefits
1
Introduction
The NC-60 has been designed to be used for active noise cancelling and so audio performance has been optimised
for this mode. For your convenience, when the batteries become flat or are removed, the headphones will continue to
operate in passive mode.
Operation
1. Adjust the volume of the NC-60 using the Volume Control (3)
2. Switch on the Noise Cancelling feature by sliding the On/Off Switch (4) to On; the Noise Cancelling Indicator (5) will
illuminate Blue
3. After you turn the Noise Cancelling feature on you may hear a slight hissing noise, this is completely normal and will
reduce after a few seconds and become inaudible during audio playback
4. When using the Noise Cancelling feature, if the battery level becomes low the Noise Cancelling Indicator will become
dim. If you continue to use the Noise Cancelling feature the battery will eventually drain, but the headphones will
continue to operate passively
Noise Cancelling
Battery Installation
1. Push the battery cover cap inward and downward in a single motion to remove the cap
2. Install 2 x AAA batteries (alkaline are recommended) into the battery compartment taking care to match the indicated
battery polarity.
3. Replace the cap, ensuring it is in the correct orientation and that the small plastic lugs on the back are aligned with the
corresponding holes in the earpiece
4. Finally slide the cap upward until it clicks into position
Overview
Left
1. 3.5mm Audio Socket
2. Removable Battery Compartment
Right
3. Volume Control
4. Noise Cancelling On/Off Switch
5. Noise Cancelling Indicator
Left Right
5
4
3
Check the volume level before placing the headphones over your ears
Do not listen to the headphones at high volume for excessive periods as this may damage your hearing
Discontinue use if you experience any discomfort or irritation from using the headphones
These headphones must not be worn whilst driving a motor vehicle
Safety
1
2
2

Termékspecifikációk

Márka: Lindy
Kategória: fejhallgató
Modell: NC-60

Szüksége van segítségre?

Ha segítségre van szüksége Lindy NC-60, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók fejhallgató Lindy

Lindy

Lindy LH900XW Útmutató

6 Január 2025
Lindy

Lindy 70368 Útmutató

2 Szeptember 2024
Lindy

Lindy 70309 Útmutató

2 Szeptember 2024
Lindy

Lindy LE400W Útmutató

19 Augusztus 2024
Lindy

Lindy BNX-100XT Útmutató

18 Augusztus 2024
Lindy

Lindy WHF-45 Útmutató

18 Augusztus 2024
Lindy

Lindy NC-60 Útmutató

16 Augusztus 2024
Lindy

Lindy LTS-50 Útmutató

16 Augusztus 2024
Lindy

Lindy BNX-80 Útmutató

15 Augusztus 2024
Lindy

Lindy BNX-60 Útmutató

15 Augusztus 2024

Útmutatók fejhallgató

Legújabb útmutatók fejhallgató