Használati útmutató Kicker SF150SC15

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Kicker SF150SC15 (11 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 4 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/11
1
S 150SC15 F
Designed for 2015 Ford F150 Super-Cab and Super-Crew vehicles
(Compatible in vehicles with or without Sony® System
©2015 Stillwater Designs
S 150SC15-A2-201F 60502
SubwooferHarness
SubwooferPower Harness
M8Bolt  X 2
M6Bolt  X 2
M6Nut  X 2
Fuse
WireTie  X 6
AdapterHarness
WireTaps
SubwooferAssembly
AmplifierRelocationBracket
(notusedonnonSony®trucks)
2
Fig. 4
Power Harness Routing
1. Disconnect negative battery cable.
2. Make sure supplied fuse is not installed in fuse holder and connect the subwoofer power wire to
the stud pictured in figure 1.
3. Route the power harness toward and along the firewall and secure with supplied wire ties.
4. Make a small incision in the grommet on the driver side of the firewall and pass the power
harness into the cabin. Fig. 2
5. Install the black two pin power connector on the subwoofer power harness. Note: Make sure
the blue retainer in the center of the connector body is not depressed. If the retainer is
depressed, the terminal will not fully seat in the connector body. Make sure the terminal
is installed into position 1 on the connector body. There should be a block-out plug
installed to prevent the terminal from being installed into the wrong position on the
connector body.
Subwoofer Harness Routing
6. Pull loose the dash end trim panel on the drivers side of dash. Fig. 3
7. Connect the black ground wire of the subwoofer harness to the bolt above the drivers kick
panel. Fig. 4
Fig. 1 Fig. 2
Fig. 3
3
8. Remove the driver side front and rear threshold panel along the bottom of the door opening by
prying up.
9. Snap loose the drivers side kick panel.
10. Connect the subwoofer harness black two-pin power connector to the power harness black two-
pin connector.
11. Connect the subwoofer harness white two pin signal input connector to the corresponding white
connector of the adaptor harness.
Input Connection Non Sony® Equipped Truck
(For trucks equipped with Sony, skip to step 25)
12. Locate the black connector and find the twisted pair of wires that are white and white/brown
stripe.
13. Install one of the supplied wire taps on each of the two wires using a pair of pliers.
14. Connect the green wire of the adaptor harness to the white wire. Connect the brown wire
of the adaptor harness to the white/brown stripe wire. Fig. 5
Fig. 5

Termékspecifikációk

Márka: Kicker
Kategória: nincs kategorizálva
Modell: SF150SC15

Szüksége van segítségre?

Ha segítségre van szüksége Kicker SF150SC15, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók nincs kategorizálva Kicker

Kicker

Kicker 51MWLE104 Útmutató

14 Január 2025
Kicker

Kicker 50HDS962 Útmutató

31 Augusztus 2024
Kicker

Kicker 50HDR154 Útmutató

31 Augusztus 2024
Kicker

Kicker 50HDS144 Útmutató

31 Augusztus 2024
Kicker

Kicker SF150SC15 Útmutató

3 Augusztus 2024
Kicker

Kicker KMLC Útmutató

26 Július 2024

Útmutatók nincs kategorizálva

Legújabb útmutatók nincs kategorizálva