Használati útmutató Jindara Grange

Jindara Fűtő Grange

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Jindara Grange (8 oldal) a Fűtő kategóriában. Ezt az útmutatót 3 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/8
Operation & Installation Instructions
Grange Freestanding
Please keep these instructions for future reference.Rev C 232344
Grange Freestanding 16
AF Gason Pty. Ltd. reserves the right to modify or alter specications, material, etc. in the interest of product improvement.
WARRANTY
1. Subject to clauses 2 & 3 of this warranty, A.F. Gason Pty Ltd ACN 004 667 556 warrants the follow components of its heaters against defects in workmanshiping
and/or materials for the following periods from the date of purchase:
a) the rebox for ten years;
b) the paint nish for a period of months if the purchaser has followed the instructions provided by Gason in the operation and Installation Instructions manual; and12
c) all other components for 12 months except the glass, re brick lining or bae plate if, in the opinion of Gason, these items have been damage d by impact.
2. This extended warranty does not apply;
a) if the heater is purchased from a person who has not been authorised by Gason to sell its products;
b) if, in the opinion of Gason, the heater or any other component has been subject to abuse, misuse, alteration, modication or has not been installed, operated or maintained in
accordance with the instructions provided by Gason; or,
c) to owners other than the original purchaser.
3. If you believe that the heater you purchased contains a manufacturing de fect and you wish to make a claim under this warranty, please contact an authorised Gason service
centre to arrange for an assessment.
4. If, after assessing the heater, Gason determines that the heater contains a manufacturing fault, Gason may at its discretion:
a) replace the heater;
b) repair or replace specic components of the heater; or
c) provide a full refund.
5. Parts replaced under warranty are warranted for the balance of their original warranty period.
6. If, at the discretion of Gason, the heater or any part needs to be replaced, serviced or repaired at an authorised Gason service centre, then the person claiming under this
warranty must pay all costs associated with:
a) returning the heater; and
b) the delivery or collection of any new or repaired heater.
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are en to a replacement or refund for a mtitled ajor failure and for
compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality
and the failure does not amoun t to a major failure.
Any benets you receive under these warranties are in addition to other rights and remedies that you may have as a consumer under law in relation to the heater to which
these warranties relate.
These warranties are given by:
AF Gason Pty Ltd
Blake Street
Ararat VIC 3377
Please contact us if you have any queries on:
Phone: 03 53522151
or email us via the “Contact Us” section of our website: www.gason.com.au
Grange Freestanding 2 Grange Freestanding 15
T
Read and follow these instructions carefully before installing and
u
sing this appliance
WARNING
!
WARNING
!
Safety Warnings
• A ue re with resulting damage may occur if the appliance is not installed,
operated and maintained as per this booklet.
• Never place combustible materials such as wood, paper or furniture near the
appliance.
• This appliance is designed to burn dry wood. Do not burn rubbish, driftwood,
flammable liquids or any substance containing salts or corrosives.
• This appliance must not be installed and operated in an area where kerosene,
petrol, paint thinner or other ammable liquid is used or stored.
• The ue system must be inspected and cleaned annually or sooner if required.
Failure to do so could result in an excessive buildup of creosote which may
result in a ue re which may damage the ue or cause damage to your home.
• The surface of the appliance becomes hot during operation. Do not touch the
surface of this appliance. Keep children away from this appliance during
operation. Do not allow anyone to operate this appliance who is not familiar
with this instruction booklet.
WARNING
!
Paint Curing and Care
Your heater is coated with the best available heat resistant paint. Even though
t
he paint has been baked after application, it may require further temperature
c
uring. It may, if you overre the heater on its rst re, discolour. For your rst
t
wo or three rings, never exceed medium air setting and always have the fan
o
n when above low burn. Do not wipe the heater while the paint is curing. After
t
he paint has cured the only maintenance required to maintain the heater’s nish
i
s to wipe it with a soft cloth. Do not use any commercial cleaners or solvents on
t
he paint nish.
W
e are proud of the presentation of our products. If at any time you need to
f
reshen up the paint, your local dealer has touchup paint available for purchase.
If you have any enquiries, please contact the dealer from whom you purchased your heater:
P
LEASE COMPLETE:
D
ealer Name
D
ealer Address
Phone:
P
lease attach your original purchase dockets to this booklet for future reference.
705 548
285
845
830
205
748
Top Plate
541
Top Plate
Removing heater from pallet:
• Remove p2-x2 Tek Screws from rear of pedestal base.
• Remove p2-x4 Phillips Head screws holding the pedestalller panel to the pedestal, and removed panel to gain access to a
third tek Screw which holds to pedestal base to the pallet.
• Remove third Tek Screw and re-attatch pedestalller panel and p2-x4 Phillips Head screws.
O/All weight: 220kg
Package dimensions: 980Hx795Wx685D
To aid heater installation, remove door, top plate, bae system and cast iron liners to reduce overall heater weight.
To aid heater installation, remove door, top plate, bae system and cast iron
liners to reduce overall heater weight. SEE PAGE 15 FOR PALLET REMOVAL.
This heater is painted in Stove Bright Metallic Black - code 6309.
Grange Freestanding 14 Grange Freestanding 3
Installation
WARNING
!
Installation
THE INS TALLATION OF THIS APPLIANCE MUST BE CARRIED OUT AS PER THI S
MANUAL AND THE FLUE MANU FACTURER’S SPECIFIC ATIONS.
WE RECOMMEND TH AT YOU USE A QU TALIFIED INS ALLER TO RY TCAR OU
THE INS TALLATION.
If you have any other enquirie please contact the dealer from whom yo s, u
purchased your heate r.
THIS APPLIANCE WEIGHS IN EXCESS OF 220 KILOGRAM S. EEXTREME CAR
SHOULD BE TAKEN WHEN HANDLING THE APPLIANCE .
AF Gason Pty. Ltd. accepts no liability whatsoever for any interpretation of AS/NZS 2918:2001.
It is important you understand these installation instructions and minimum clearances to combustible materials before
selecting a position for your Jindara Grange to ensure safe and correct installation is achieved.
Installation permit
Depending on your local authority requirements, a permit may be required for the installation of your heater. It is your
responsibility to arrange the same.
Flue requirements
As per the dimensions in Figure 1 & 2 the Jindara Grange can be installed with a Perforated 6” Default Flue Kit including a
180 degree x 900mm ue shield, or Figure 3 & 4 a Solid 6” Default Flue Kit including a 180 degree x 900mm ue shield.
The ue system installed with the Jindara Grange must comply with Australian and New Zealand installation
standards AS/NZS 2918:2001, and be installed to the ue manufacturer’s instructions.
The performance of your Jindara Grange is highly reliable on an eective ue system. In many cases poor start-up, dirty glass,
down draft which causes smoking when the door is open, and a reduction in heat outupt can all be related to the ue system
being too short, or incorrect installation. Too tall a ue can result in excess draft and short burn times along with excessive
heat output.
Clearance to combustibles
The Jindara Grange freestanding heater conforms to AS/NZS 2918:2001 when positioned in relation to combustible surfaces
as shown in Figure 1 & 2 on the following page. All dimensions used in this document are in millimetres and are minimum
unless otherwise stated.
These dimensions in Figure 1 & 2 state the minimum distance the Jindara Grange can be placed in relation to any
combustible materials - plaster, wallpaper, timber, MDF, etc.
In the instance your Jindara Grange is surrounded by non-combustible materials - brick, stone, concrete, cement sheet,
villaboard or similar, wall clearances can be reduced to 50mm. A 50mm clearance is required to ensure room air can
circulate around the wood heater during operation.
For additional clearance details, or to access the Jindara Grange Freestanding Conformance Certicate, please contact the
Jindara Dealer from whom you purchased your heater.
Hearth & oor requirements
If the Jindara Grange will be installed onto a non-combustible oor such as a brick, stone or concrete slab with tiles, etc.
which is at least 9mm thick, and extends at least 300mm in front of the appliance base, a hearth or oor protector may not
be required.
If the Jindara Grange is to be installed onto a combustible oor, a minimum 9mm Bellis Board, or similar non-combustible
hearth or oor protector must be placed in between the appliance and the combustible oor. At a minimum, the oor
protector must extend 300mm in front of the appliance base. The protector must be at least 1000mm wide and 815mm deep.
• If desirable, the floor protector can extend 895mm deep for perforated flue installations, also 895mm for solid flue Installations
or larger to meet skirting boards or walls at the rear of the appliance when installed as per the rear wall clearances.
Firewood
Getting the most out of your rewood
Firewood is a sustainable source of energy and when used correctly can provide a cost eective form of heating in your
home. Too often poor heating results and operational issues are attributed to using unseasoned wood which leads to
excess smoking, causing creosote buildup and dirty glass. Wood should be stored in a dry place where good ventalition is
availabe. Freshly cut wood should be stored for between 12-24 months before burning.
Use only hardwood with your Jindara Grange.
Thermal eciency
A wood’s eciency does not depend only on its type, but also on its moisture content as well as the temperature of the
combustion chamber. To achieve a greater eciency and longer burn cycle out of your Jindara Grange, without the
emissions of hazardous particulates, your wood must be well seasoned.
Ideally, wood should not be burnt when its moisture content is above 20%. A moisture meter to measure moisture content
is a handy addition.
0% moisture
100% thermal eciency
10% moisture
88% thermal eciency
30% moisture
63% thermal eciency
50% moisture
39% thermal eciency
An example of available thermal eciency for a piece of wood as a fuel source at varying moisture levels.
The combustion process of burning wood
When wood is heated up to approximately 100 degrees celsius, moisture begins to evaporate from the fuel. There is no
heating value from the wood at this point. As moisture releases from the wood, it reduces the eciency of the combustion
process robbing heat energy from the wood. This demonstrates the importance of dry and well seasoned wood.
As rebox temperatures reach 250-300 degrees celsius, wood solids begin to break down and release volatile gases which
ignite and produce heat.
From 300+ degrees celsius, the main energy available from wood is released when fuel vapors containing up to 60% of
the wood’s potential heat is released.
Understanding combustion principles and learning how to manipulate various conditions surrounding the operation of
your Jindara Grange enables you to achieve maximum comfort and eciency from your Australian made wood heater.
Figure 14

Termékspecifikációk

Márka: Jindara
Kategória: Fűtő
Modell: Grange

Szüksége van segítségre?

Ha segítségre van szüksége Jindara Grange, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók Fűtő Jindara

Jindara

Jindara Kimberley Mk2 Útmutató

19 Augusztus 2024
Jindara

Jindara Hamersley MK2 Freestanding Útmutató

17 Augusztus 2024
Jindara

Jindara Tilga Útmutató

17 Augusztus 2024
Jindara

Jindara Hamersley Mk2 Útmutató

16 Augusztus 2024
Jindara

Jindara Riverina Útmutató

13 Augusztus 2024
Jindara

Jindara Mallee Útmutató

12 Augusztus 2024
Jindara

Jindara Spectre Útmutató

12 Augusztus 2024
Jindara

Jindara Grange Útmutató

11 Augusztus 2024
Jindara

Jindara Gawler Útmutató

9 Augusztus 2024
Jindara

Jindara Sturt Útmutató

8 Augusztus 2024

Útmutatók Fűtő

Legújabb útmutatók Fűtő

Electrolux

Electrolux EO12D103C0 Útmutató

22 December 2024
Electrolux

Electrolux EO12D104C0 Útmutató

22 December 2024
NewAir

NewAir AH-450B Útmutató

22 December 2024
NewAir

NewAir NGH1K6WH00 Útmutató

22 December 2024
Sencor

Sencor SOH 8211GY Útmutató

21 December 2024
Yamazen

Yamazen DSF-VE121 Útmutató

21 December 2024
Yamazen

Yamazen DSE-SKC103 Útmutató

21 December 2024
Yamazen

Yamazen DBC-L122 Útmutató

21 December 2024
Yamazen

Yamazen DMSF-J062 Útmutató

21 December 2024
Yamazen

Yamazen DC-ZT12 Útmutató

20 December 2024