Használati útmutató JBL GSF3

JBL hangszóró GSF3

Olvassa el alább 📖 a magyar nyelvű használati útmutatót JBL GSF3 (6 oldal) a hangszóró kategóriában. Ezt az útmutatót 7 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/6
Installation Guide
GSF3 & GSF6 Landscape Speakers
CAUTION: Installation must be done by qualified persons using safe
installation standards.
The installer is responsible for proper selection and use of mounting hardware
and processes to install the speakers in a safe manner.
Wire Connection
• CABLE-- - - - The GSF speakers have a captive 1 meter long cable for bare wire connection via an external installer provided
weather proof- junction box.
o Polarity -- – . The red wire is + (positive) and the black wire is (negative)
o Wire Gauge – 1 The wire gauge is 18 AWG ( mm2).
o Wire Jacket – - The wire jacket is 5 mm (+0/ 05.mm) in diameter.
o Connecting -- Use proper wire nuts or other safe connectorsprofessional that are appropriate for the installation
conditions and that are sized properly for wire gauge(s) and number of wires to be connected together in the
connector.
o Routing – - - When using the ground stake or L bracket base, the cable can be routed through the base.
Black - = (negative)
Red = + (positive)
CABLE
Bare-Wire End of Cable
Setting TAP SELECTOR SWITCH
(TAP SELECTOR SWITCH is located on the bottom of the speaker enclosure)
• Rotate bottom- : panel TAP SELECTOR SWITCH to select between
o GSF3:
8 - ) Ω(ie, low impedance / direct
15W or 7.5W for either 70V or 100V distributed speaker system
3.75W for 70V distributed speaker system only
o GSF6:
8 - Ω(ie, low impedance / direct)
30W or 15W for either 70V or 100V distributed speaker system
7.5W for 70V distributed speaker system only
Installing GROUND OUDSPEAKER-STAKE BASE or L BRACKET BASE - to L
• The speaker comes with both a GROUND-STAKE BASE and an L-BRACKET BASE. Use whichever one applies to the installation
requirements of the project.
• At the bottom of the LOUDSPEAKER there is a SOCKET. Three come with the speaker (packaged in a separate - rhead set sc ews
pouch) for attaching the chosen base into the SOCKET.
o Screw Dimensions -- – , GSF3: M4 x 0.7 5mm with 3 mm hex drive
GSF6: M4 x 0.7 – 9 , mm with 3 mm hex drive
(GSF SPEAKER shown with L-BRACKET BASE)
(continued ↓)
ROTARY TAP SELECTOR SWITCH
• Use the included 3 mm hex wrench to tighten the 3 set screws to hold the chosen base securely.
• For GROUND-STAKE BASE, press base into the ground.
(GSF SPEAKER shown with included GROUND STAKE base)-
• For L BRACKET BASE, securely attached base to either horizontal surface (such as decking or railing) or vertical surface (such as t- he
side of a building or post). Use the proper attachment hardware for the material and characteristics of what it’s being attached to.
Aiming LOUDSPEAKER
• Loosen HINGE BOLT by using included 4 mm hex key. Aim loudspeaker, and then retighten.
• Aiming Speaker at Downward Angle Provides Best Drainage – The greatest water drainage and reliability can be achieved by
aiming the speaker at a slight downward aiming angle.
• Maximum Upward Aiming Angle of 30° -- For when aimed slightly upward, there is a drain hole at the bottom of the speaker
that helps to drain water from the front of the speaker’s driver °at aiming angles up to a maximum 30 . At upward aiming
angles potentially °greater than 30 , water can pool on the driver, causing damage.
Ingress Protection Rating
• IP66 -- The GSF speakers are rated IP66 ( per IEC529 highly protected against ingress from dust and water). However, the
speaker is not rated for submersion in water, so steps must be taken to ensure that no immersion situation occurs.
HINGE BOLT
(use included 4 mm hex key)
(Shown with included L-BRACKET base)
CAUTION WHEN RE-AIMING SPEAKER:
When ground stake is utilized, re aiming speaker - -
horizontally requires either: a) completely pull ing
stake from ground and re back into -pressing
ground at new aiming angle or b) loosening 3 set ,
screws, re- -aiming speaker, and re tightening set
screws. Trying to rotate speaker with stake in
ground could and set screws tightened result in
damage or breakage.
CAUTION WHEN ROTATING ON L- : BRACKET
When bracket rotating speakerL- is utilized, on L-
bracket otating requires loosening 3 set screws, r
speaker, and re tightening set screws. Trying to -
rotate speaker set screws tightened could with
result in damage or breakage.

Termékspecifikációk

Márka: JBL
Kategória: hangszóró
Modell: GSF3

Szüksége van segítségre?

Ha segítségre van szüksége JBL GSF3, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók hangszóró JBL

JBL

JBL Control 426LP Útmutató

9 Április 2025
JBL

JBL Conceal C83 Útmutató

8 Április 2025
JBL

JBL sCl-4 Útmutató

29 Március 2025
JBL

JBL B-6ICDT Útmutató

12 Január 2025
JBL

JBL B-8IC Útmutató

12 Január 2025
JBL

JBL 4349 Útmutató

12 Január 2025
JBL

JBL Tower X Marine MT10HLW Útmutató

6 Január 2025
JBL

JBL Control CM42AW Útmutató

1 Január 2025
JBL

JBL Performance P36AW Útmutató

1 Január 2025
JBL

JBL Balboa 30 Útmutató

1 Január 2025

Útmutatók hangszóró

Legújabb útmutatók hangszóró

Behringer

Behringer B2520 PRO Útmutató

10 Április 2025
Marshall

Marshall Willen Útmutató

10 Április 2025
Crestron

Crestron SAROS IC8T Útmutató

8 Április 2025
LD Systems

LD Systems STINGER G3 TMB Útmutató

8 Április 2025
Crestron

Crestron SAROS ICE4T Útmutató

7 Április 2025
Crestron

Crestron SAROS ICI6T Útmutató

7 Április 2025
Focal

Focal K2 Power M FRAK Útmutató

5 Április 2025
Match

Match UP C42BMW-FRT.3 Útmutató

3 Április 2025
Turbosound

Turbosound PQ12-SB Útmutató

3 Április 2025
Trust

Trust Tytan GXT 658 Útmutató

3 Április 2025