Használati útmutató Indesit WITXL 125 (EE)

Indesit mosógép WITXL 125 (EE)

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Indesit WITXL 125 (EE) (60 oldal) a mosógép kategóriában. Ezt az útmutatót 2 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF

Oldal 1/60

WASHING MACHINE

WITXL 125

Instructions for use

Contents

Installation, 2-3

Unpacking and levelling

Electric and water connections

The first wash cycle

Technical details

Washing machine description, 4-5

Control panel

How to open and shut the drum

Leds

Starting and Programmes, 6

Briefly: how to start a programme

Programme table

Personalisations, 7

Setting the temperature

Setting the spin cycle

Functions

Detergents and laundry, 8

Detergent dispenser

Bleach cycle

Preparing your laundry

Special items

Precautions and advice, 9

General safety

Disposal

Saving energy and respecting the environment

Care and maintenance, 10

Cutting off the water or electricity supply

Cleaning your appliance

Caring for your appliance door and drum

Cleaning the pump

Checking the water inlet hose

Cleaning the detergent dispenser

Troubleshooting, 11

Service, 12

Before calling for Assistance

English, 1

БЪЛГАРСКИ, 13

BG GR

ΕΛΛΗΝΙΚΑ, 25

ITUK

Italiano, 49

Українська, 37

! Keep this instruction manual in a safe place for future refe-

rence. Should the appliance be sold, transferred or moved,

make sure the instruction manual accompanies the washing

machine to inform the new owner as to its operation and

features.

! Read these instructions carefully: they contain vital infor-

mation on installation, use and safety.

Unpacking and levelling

Unpacking

1. Unpack the washing

machine.

2. Check whether the

washing machine has been

damaged during transport.

If this is the case, do not

install it and contact your

retailer.

3. Remove the four protec-

tive screws and the rubber

washer with the respective

spacer, situated on the

rear of the appliance (see

figure).

4. Seal the gaps using the

plastic plugs provided.

5. Keep all the parts: you will need them again if the washing

machine needs to be moved to another location.

Warning: should the screws be re-used, make sure you fasten

the shorter ones at the top.

! Packaging materials are not children’s toys.

Levelling

1. Install the washing machine

on a flat sturdy floor, without

resting it up against walls,

furniture cabinets or other.

2. If the floor is not perfectly

level, compensate for any

unevenness by tightening or lo-

osening the adjustable front feet

(see figure); the angle of inclina-

tion, measured according to the

worktop, must not exceed 2°.

Levelling your appliance correctly will provide it with stability

and avoid any vibrations, noise and shifting during operation.

If it is placed on a fitted or loose carpet, adjust the feet in

such a way as to allow enough room for ventilation beneath

the washing machine.

Putting your appliance in place and moving it.

If your washing machine

is equipped with a special

set of retractable wheels

you can easy move it.

To lower the wheels and

thus move the appliance

effortlessly, just pull the

lever, situated on the left-

hand side beneath the

base. Once the appliance

is in the required position,

put the lever back in place. The washing machine is now

firmly in place . (see figure)

Electric and water connections

Connecting the water inlet hose

1. Connect the supply

pipe by screwing it to a

cold water tab using a ¾

gas threaded connection

(see figure).

Before performing the

connection, allow the

water to run freely until it is

perfectly clear.

2. Connect the other end of

the water inlet hose to the

washing machine,

screwing it onto the applian-

ce’s cold water inlet, situated

on the top right-hand side

on the rear of the appliance

(see figure).

3. Make sure there are

no kinks or bends in the

hose.

! The water pressure at the tap must be within the values

indicated in the Technical details table

(on the next page).

! If the water inlet hose is not long enough, contact a

specialist store or an authorised serviceman.

! Never use hoses that have already been used.

Installation

Connecting the drain hose

Connect the drain hose,

without bending it, to a

draining duct or a wall

drain situated between 65

and 100 cm from the floor;

alternatively, place it over

the edge of a basin, sink

or tub, fastening the duct

supplied to the tap (see

figure). The free end of

the hose should not be

underwater.

! We advise against the use of hose extensions; in case

of absolute need, the extension must have the same

diameter as the original hose and must not exceed 150

cm in length.

Electric connection

Before plugging the appliance into the mains socket,

make sure that:

• the socket is earthed and in compliance with the

applicable law;

• the socket is able to sustain the appliance’s

maximum power load indicated in the Technical

details table ;(on the right)

• the supply voltage is included within the values i

ndicated on the Technical details table

(on the right);

• the socket is compatible with the washing

machine’s plug. If this is not the case, replace

the socket or the plug.

! The washing machine should not be installed in an ou-

tdoor environment, not even when the area is sheltered,

because it may be very dangerous to leave it exposed to

rain and thunderstorms.

! When the washing machine is installed, the mains so-

cket must be within easy reach.

! Do not use extensions or multiple sockets.

! The power supply cable must never be bent or dange-

rously compressed.

! The power supply cable must only be replaced by an

authorised serviceman.

Warning! The company denies all liability if and when

these norms are not respected.

The first wash cycle

Once the appliance has been installed, and before you

use it for the first time, run a wash cycle with detergent

and no laundry, setting the 90°C programme without a

pre-wash cycle.

65 - 100 cm

Technical details

Model WITXL 125

Dimensions

40 cm wide

85 cm high

60 cm deep

Capacity from 1 to 6 kg

Electric

connections

Please refer to the technical data plate

fixed to the machine.

Water

connections

maximum pressure 1 MPa (10 bar)

minimum pressure 0.05 MPa (0.5 bar)

drum capacity 42 litres

Spin speed up to 1200 rpm

Control

programmes

according to

1061/2010

directive

programme 2; temperature 60°C and

40°C.

This appliance is compliant with

the following European Community

Directives:

- 2004/108/CE (Electromagnetic

Compatibility)

- 2006/95/CE (Low Voltage)

- 2002/96/CE

Termékspecifikációk

Márka:	Indesit
Kategória:	mosógép
Modell:	WITXL 125 (EE)

Szüksége van segítségre?

Ha segítségre van szüksége Indesit WITXL 125 (EE), tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek

Az Ön neve*

Az Ön e-mail címe*

Írja ide kérdését

Útmutatók mosógép Indesit

Indesit WG1234TG Útmutató

5 Április 2025

Indesit iwc 6165 Útmutató

3 Április 2025

Indesit iwdc 6145 s Útmutató

2 Április 2025

Indesit IM 760 MY TIME IT Útmutató

27 Március 2025

Indesit iwc 7105 Útmutató

21 Március 2025

Indesit PWE 81271 W Útmutató

16 Január 2025

Indesit widxxl 106 eu Útmutató

16 Január 2025

Indesit sixl 145 Útmutató

16 Január 2025

Indesit WIN 101 Útmutató

16 Január 2025

Indesit iwd 7125 fr Útmutató

16 Január 2025

Útmutatók mosógép

Legújabb útmutatók mosógép

Electrolux EWT1366EDW Útmutató

10 Április 2025

Miele Novotronic W 153 F Útmutató

10 Április 2025

Miele WER 875 WPS PWash & TDos & 9kg & WiFi Útmutató

10 Április 2025

Hanseatic WA 1200-5 Útmutató

10 Április 2025

Friac wa 1231 e Útmutató

9 Április 2025

Zanussi-electrolux fjs 1486 x Útmutató

9 Április 2025

Miele WSE383 WCS Útmutató

9 Április 2025

AEG-Electrolux 74604 oko lavamat Útmutató

8 Április 2025

Hotpoint NDB 10748 WA Útmutató

8 Április 2025

Whirlpool FFB 7269 BV Útmutató

8 Április 2025