Használati útmutató Indesit WITL 125

Indesit mosógép WITL 125

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Indesit WITL 125 (72 oldal) a mosógép kategóriában. Ezt az útmutatót 11 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/72
1
GB
WASHING MACHINE
WITL 125
Instructions for use
Contents
Installation, 2-3
Unpacking and levelling, 2
Electric and water connections, 2-3
The first wash cycle, 3
Technical details, 3
Washing machine description, 4-5
Control panel, 4
How to open and shut the drum, 5
Leds, 5
Starting and Programmes, 6
Briefly: how to start a programme, 6
Programme table, 6
Personalisations, 7
Setting the temperature, 7
Setting the spin cycle, 7
Functions, 7
Detergents and laundry, 8
Detergent dispenser, 8
Bleach cycle, 8
Preparing your laundry, 8
Special items, 8
Precautions and advice, 9
General safety, 9
Disposal, 9
Saving energy and respecting the environment, 9
Care and maintenance, 10
Cutting off the water or electricity supply, 10
Cleaning your appliance, 10
Caring for your appliance door and drum, 10
Cleaning the pump, 10
Checking the water inlet hose, 10
Cleaning the detergent dispenser, 10
Troubleshooting, 11
Service, 12
Before calling for Assistance, 12
ES
Nederlands, 25
ES
NL
Deutsch, 13
ES
DE
English, 1
GB
GB
Magyar, 37
ES
HU
ES
Slovenský, 49
SK
Español, 61
ES
ES
ES
2
GB
Keep this instruction manual in a safe place for future
reference. Should the appliance be sold, transferred or
moved, make sure the instruction manual
accompanies the washing machine to inform the new
owner as to its operation and features.
Read these instructions carefully: they contain vital
information on installation, use and safety.
Unpacking and levelling
Unpacking
1. Unpack the washing
machine.
2. Check whether the
washing machine has
been damaged during
transport. If this is the
case, do not install it
and contact your
retailer.
3. Remove the four
protective screws and
the rubber washer with
the respective spacer,
situated on the rear of
the appliance (see
figure).
4. Seal the gaps using the plastic plugs provided.
5. Keep all the parts: you will need them again if the
washing machine needs to be moved to another
location.
Warning: should the screws be re-used, make sure
you fasten the shorter ones at the top.
Packaging materials are not children's toys.
Levelling
Your machine may make a considerable amount of
noise if the two front feet have not been adjusted
correctly.
1. Install the washing
machine on a flat sturdy
floor, without resting it
up against walls,
furniture cabinets or
other.
2. If the floor is not
perfectly level, compen-
sate for any unevenness
by tightening or
loosening the adjustable
front feet (see figure); the angle of inclination, measured
according to the worktop, must not exceed 2°.
Levelling your appliance correctly will provide it with
stability and avoid any vibrations, noise and shifting
during operation. If it is placed on a fitted or loose
carpet, adjust the feet in such a way as to allow
enough room for ventilation beneath the washing
machine.
Putting your appliance in place and moving it.
If your washing
machine is equipped
with a special set of
retractable wheels you
can easy move it. To
lower the wheels and
thus move the
appliance effortlessly,
just pull the lever,
situated on the left-
hand side beneath the
base. Once the appliance is in the required
position, put the lever back in place. The washing
machine is now firmly in place (see figure).
Electric and water connections
Connecting the water inlet hose
1. Insert seal A into
the end of the inlet
hose and screw the
latter onto a cold
water tap with a 3/4
gas threaded mouth
(see figure).
Before making the
connection, allow the
water to run freely
until it is perfectly
clear.
2. Connect the other
end of the water inlet
hose to the washing
machine,
screwing it onto the
appliance's cold water
inlet, situated on the top
right-hand side on the
rear of the appliance
(see figure).
3. Make sure there are no kinks or bends in the
hose.
The water pressure at the tap must be within the
values indicated in the Technical details table
(on the next page).
If the water inlet hose is not long enough,
contact a specialist store or an authorised
serviceman.
Installation
A
3
GB
ServiceTroubleshootingPrecautions CareProgrammes DetergentsInstallation Description
Connecting the drain hose
Connect the drain hose,
without bending it, to a
draining duct or a wall
drain situated between
65 and 100 cm from
the floor;
alternatively, place it
over the edge of a
basin, sink or tub,
fastening the duct
supplied to the tap (see
figure). The free end of
the hose should not be
underwater.
We advise against the use of hose extensions; in
case of absolute need, the extension must have the
same diameter as the original hose and must not
exceed 150 cm in length.
Electric connection
Before plugging the appliance into the mains
socket, make sure that:
the socket is earthed and in compliance with the
applicable law;
the socket is able to sustain the appliance's
maximum power load indicated in the Technical
details table (on the right);
the supply voltage is included within the values i
ndicated on the Technical details table
(on the right);
the socket is compatible with the washing
machine's plug. If this is not the case, replace
the socket or the plug.
The washing machine should not be installed in an
outdoor environment, not even when the area is
sheltered, because it may be very dangerous to
leave it exposed to rain and thunderstorms.
When the washing machine is installed, the mains
socket must be within easy reach.
Do not use extensions or multiple sockets.
The power supply cable must never be bent or
dangerously compressed.
The power supply cable must only be replaced by
an authorised serviceman.
Warning! The company denies all liability if and when
these norms are not respected.
The first wash cycle
Once the appliance has been installed, and before
you use it for the first time, run a wash cycle with
detergent and no laundry, setting the 90°C
programme without a pre-wash cycle.
65 - 100 cm
Technical details
Model WITL 125
Dimensions
40 cm wide
85 cm high
60 cm deep
Capacity from 1 to 5 kg
Electric
connections
voltage 220/230 Volts 50 Hz
maximum absorbed power 1850 W
Water
connections
maximum pressure 1 MPa (10 bar)
minimum pressure 0.05 MPa (0.5 bar)
drum capacity 42 litres
Spin speed up to 1200 rpm
Control
programmes
according to
IEC456 directive
programme 2; temperature 60°C;
run with a load of 5 kg.
This appliance is compliant with the
following European Community
Directives:
- 73/23/CEE of 19/02/73 (Low
Voltage) and subsequent amendments
- 89/336/CEE of 03/05/89
(Electromagnetic Compatibility) and
subsequent amendments
- 2002/96/CE

Termékspecifikációk

Márka: Indesit
Kategória: mosógép
Modell: WITL 125

Szüksége van segítségre?

Ha segítségre van szüksége Indesit WITL 125, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók mosógép Indesit

Indesit

Indesit IM 760 MY TIME IT Útmutató

27 Március 2025
Indesit

Indesit iwc 7105 Útmutató

21 Március 2025
Indesit

Indesit PWE 81271 W Útmutató

16 Január 2025
Indesit

Indesit widxxl 106 eu Útmutató

16 Január 2025
Indesit

Indesit sixl 145 Útmutató

16 Január 2025
Indesit

Indesit WIN 101 Útmutató

16 Január 2025
Indesit

Indesit iwd 7125 fr Útmutató

16 Január 2025
Indesit

Indesit w 165 Útmutató

16 Január 2025
Indesit

Indesit WN480XWI Útmutató

16 Január 2025
Indesit

Indesit W 144 XS Útmutató

16 Január 2025

Útmutatók mosógép

Legújabb útmutatók mosógép

Electrolux

Electrolux ew 1440 f Útmutató

30 Március 2025
Grundig

Grundig GWN 27430 Útmutató

30 Március 2025
Zanussi

Zanussi ZWF1637W Útmutató

30 Március 2025
Techwood

Techwood WB 91042 Y Útmutató

30 Március 2025
Hoover

Hoover DXOA G68AHC7-84 Útmutató

30 Március 2025
Foron

Foron WN0802 WN0932 Vitatop Útmutató

30 Március 2025
Zanker

Zanker 5121 Útmutató

29 Március 2025
Daewoo

Daewoo DWD-F1222 Útmutató

29 Március 2025
Bauknecht

Bauknecht wat excellence 2255 Útmutató

29 Március 2025
Whirlpool

Whirlpool awe 8726 Útmutató

29 Március 2025