Használati útmutató Hifonics HF7BEQ

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Hifonics HF7BEQ (10 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 3 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/10
Operator’s Guide
HF7BEQ
Thank you for purchasing the HIFONICS HF7BEQ 7-Band Equalizer/
two-way crossover. This unit has both a pre-amp equalizer and
crossover to provide the multi-speaker system of your vehicle with
improved sound performance. Please read the entire manual to
ensure proper connections and application.
CAUTION
Always consider consulting a professional audio installer
before installing any audio components. Be careful and take
your time. Do not let wires make contact with metal edges or
hot engine components.
Features
ILLUMINATED BLUE CONTROL KNOB LEDS
LOW AND HIGH LEVEL AUDIO INPUTS (SPEAKER LEVEL)
DESIGNATED SUBWOOFER UNBALANCED OUTPUT
SUBWOOFER X-OVER FREQUENCY CONTROL
INPUT LEVEL CONTROL ADJUSTMENT
FADER CONTROL
HALF DIN CHASSIS SIZE
MOUNTING HARDWARE (INCLUDED)
SEVEN EQUALIZATION BANDS EACH ADJUST +/- 12dB
1
Mounting and Hardware
Prior to mounting, connect the wires
to ensure proper operation.
MOUNTING
1. Select the desired mounting location, either under the dash or
in the dash. Make sure that there is adequate depth for the HF7BEQ.
2. Use the mounting brackets and hardware provided. Make sure
there is proper clearance for the mounting bracket screws when
attaching under the dash. Use caution to ensure there are no wiring
harnesses behind the dash panel (where the mounting
screws are fastened).
3. Route the power, ground, and remote wires away from moving
parts to prevent pinching or shortened wires.
WIRING
1. : The power wire should connect to a constant or Power Wire
switched +12 volt source with a in-line fuse. We recommend (2 Amp)
that you use the radio constant or switch +12 volt source.
2. : Connect the ground wire to a clean chassis ground Gound Wire
point. Be sure to remove all paint and primer to expose clean metal.
Use a ring terminal and lock or star washer to secure the ground wire.
3. : The remote wire should be connected to the source Remote Wire
until remote or antenna wire that provides +12 volts when the
source unit is “on” and 0 volts when the source unit is turned “off.”
2

Termékspecifikációk

Márka: Hifonics
Kategória: nincs kategorizálva
Modell: HF7BEQ

Szüksége van segítségre?

Ha segítségre van szüksége Hifonics HF7BEQ, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók nincs kategorizálva Hifonics

Útmutatók nincs kategorizálva

Legújabb útmutatók nincs kategorizálva