Használati útmutató Golden Age Project PREQ-73 Premier

Golden Age Project Vevő PREQ-73 Premier

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Golden Age Project PREQ-73 Premier (2 oldal) a Vevő kategóriában. Ezt az útmutatót 3 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/2
W W W . G O L D E N A G E P R O J E C T . C O M I
Vintage style preamplifier and equalizer
PREQ-73 PREMIER
INTRODUCTION
Congratulations on choosing the Golden Age Project PREQ-73 PREMIER microphone preamplifier and equalizer!
The PREQ-73 PREMIER is a one-channel vintage style microphone-, line- and instrument preamplifier with a
three-band band equalizer with inductor based midrange offering a smooth and effective sound shaping. The
signal path uses only discrete components like resistors, capacitors and transistors. The microphone and line
input and the line output are transformer balanced, using three different transformers, each one optimized for its
purpose. This is the way audio components were built before integrated circuits became available.
The circuit used in the PREQ-73 PREMIER is similar to the preamp and the equalizer section in the classical 1073
module with a corresponding sound character that is warm, punchy, sweet and musical. These classic character-
istics have been heard on countless recordings through the years and it is a versatile sound that works very well
on most sound sources and in most genres. The essence of this sound is now available at a surprisingly low cost,
making it available to nearly everyone.
FEATURES
- Vintage Style electronics. No integrated circuits in the signal path.
- Maximum gain in mic mode is 80 dB, enough to handle passive ribbon mics with quiet sound sources.
- Classic 23-position Gain/Line switch with 5 dB steps and a gain range of 20 to 80 dB for mic and -10 to +20 dB for line.
- A two band LF (+/-15 dB) and HF (+/-20 dB) shelving equalizer with two selectable frequencies for each band.
- Inductor based +/- 15 dB midrange equalizer section with three selectable frequencies. The lowest one is selectable between 350 and 700 Hz.
- Switchable impedance in mic mode, 1200 or 300 Ohm, will change the tone of most mics. The input impedance in line mode is 10 kOhm.
- Switchable phantom power and absolute phase.
- A high-impedance instrument input for any sound module, electric guitar or bass.
- A simple but effective 4-step LED output level meter.
- The output level control makes it possible to make fine gain adjustments and also to overload the main gain stage(s) for more character.
- Separate combo XLR/TRS jack for the MIC and LINE input and separate output XLR and TRS jacks for flexible connections.
- Selectable 600 Ohm output termination.
- Classic style knobs and buttons.
- Prepared for mounting one ot two units in the UNITE PREMIER rack kit. It can also be mounted in one of the other UNITE rack kits and combined with
--the red and black Golden Age Project products.
- Connector free internal wiring, all connections except the ones to the gain switch
are soldered for the purest signal and most longterm stable signal path.
- UK made Carnhill microphone input and line output transformers.
- The pcb is prepared for the Carnhill 9046M line input transformer.
- Polystyrene capacitors in the amplifier circuits.
- Tantalum capacitors in the signal path.
- Beefed up power supply.
- Sturdy toggle switches with gold plated contacts.
- External power supply to avoid interaction with the audio circuits and transformers.
- A solid build quality that will last many years of normal use.
W W W . G O L D E N A G E P R O J E C T . C O M II
---------------------------
Thank you for choosing the PREQ-73 PREMIER!
I hope it will serve you well and that it will help you in making
many great sounding recordings.
Bo Medin
- Instruments can be connected to the TS input jack on the front
panel. It has an input impedance of about 100 kOhms. Engage the
DI switch to select this input.
The DI input works in the MIC positions of the LINE/MIC switch. Mic
and Line sources at the back can remain connected while using
the DI input.
- Engage the 48 V phantom power for any mic that needs it. It´s a
good procedure to always disengage the phantom power and wait
for about 10 seconds before unplugging the mic.
- When the LOW-Z switch is engaged, the input impedance of the
input in MIC mode drops from 1200 Ohms to 300 Ohms. This will
change the tone of most mics and will give you one more sound-
shaping option. It will also increase the signal level.
- The phase switch simply reverses the phase by reversing the
wires from the secondary winding of the output transformer.
Reversing the phase of a signal is useful in many situations, one
example is phase reversing the lower mic of a snare drum to make
it sum in phase with the upper mic.
- To activate the equalizer section, engage the EQ switch and select
frequencies with the toggle switches and adjust the level.
- There is an internal jumber just behind the MF frequency switch
that can be set to 350 or 700 Hz, the default from factory is 350 Hz.
- The output transformer used in the PREQ-73 PREMIER is made
for having an ideal load of about 600 Ohm. The input impedance of
most modern units is 10 kOhm or more.
The PREQ-73 PREMIER therefore has a 600 Ohm output termina-
tion resistor that is engaged by the jumper (JP1) located just
behind the XLR output jack. The termination reistor will lower the
ouput level slightly and also affect the upper frequency range,
Remove the jumper if the PREQ-73 PREMIER feed a unit with a 600
Ohm input impedance.
- If the PREQ-73 PREMIER is placed close to another unit with a
power supply, the input transformers and the eq midrange induc-
tor can pick up the electromagnetic field that especially mains
transformers generate. If you notice a small hum or any other
noise in the normal noise floor in a case like this, try moving the
PREQ-73 PREMIER away from other unit and the hum will most
likely disppear.
WARRANTY
The PRE-73 PREMIER is built to last. But as in any electronic
device, components can break down.
There is a 1,0 A, slow blow fuse located inside the unit, close to the
24 V AC input jack. If the unit dies, check this fues. If it has blown,
replace it with a new one.
You can also try another 24 V AC adaptor if you have one available
If this doesn´t help, or if the unit has another problem, it will need
repair and you should then contact the reseller where you bought
the unit.
The warranty period is decided by the Distributor for your country.
The Distributor will support Golden Age Project resellers and end
users with repairs and spare parts.
REGISTRATION
You are welcome to register your unit at our website:
www.goldenageproject.com
You are also welcome to visit: www.goldenagepremier.com
CIRCUIT DESCRIPTION
The signal first enters an input
transformer, one for the mic input and
another one for the line input. The pri-
mary of the mic input transformer has
two windings that are either connected
in series or in parallel which results in
an input impedance of either 1200 or
300 Ohm.
The transformers are followed by two input gain stages. For gains
up to 50 dB, only one of them is being used. For gains above 50
dB, the second gain stage is inserted in the signal path. Both gain
stages uses only three transistors each.
The signal is then fed to the equalizer section if it is engaged and
onwards to the output level potentiometer and from there on to the
output stage. This stage again only uses three transistors, the last
one in the chain is a hefty 2N3055 power transistor run in class-A
mode, driving the output transformer.
All in all, the complete signal chain contains a maximum of only
15 active elements including the six transistors in the eq section.
Compare that to the big number of transistors that are usually
used in one single integrated circuit!
MODERN VERSUS OLD
It is true that there are some great IC´s available today that
achieves very low levels of static and dynamic distortion. The
simple circuits that the PREQ-73 PREMIER uses, and even more so
the transformers, cannot match the low distortion specifications of
modern IC´s.
It is the distortion components that imparts a sound character to
the audio signal and, if the distortion components are of the right
sort, this is a good thing since it makes the recorded voice or
instrument sound “better”, more musical, more pleasing to the ear.
This is one reason why vintage style units are so popular today.
Modern, transparent sounding audio circuits is surely not a bad
thing, sometimes they are prefered over colored ones. It´s all about
taste and it depends on the genre. For most modern music styles,
color and character is usually a good thing.
USING THE PREQ-73 PREMIER
Using a preamplifier and an equalizer is not rocket science. Find
some points below to help you in getting the maximum out of the
PREQ-73 PREMIER:
- Connect the cable from the power supply to the 24 V AC connector
on the back panel of the PREQ-73 PREMIER. Power on the unit with
the POWER switch at the front.
- Connect your mic and/or line sources to one of the input XLR/
TRS combo jacks on the back panel. A mic and a line source can be
connected at the same time,
- Switching between mic and line input is done by setting the LINE/
MIC switch to one of the line or mic gain positions.
- If you want the smallest amount of coloration, always set the
OUTPUT level potentiometer at or close to maximum and adjust
the output level with the stepped LINE/MIC gain switch.
- If you want more character, turn the OUTPUT level potentio-
meter counterclockwise and increase the gain with the LINE/
MIC switch. This will drive the input gain and the equalizer stages
harder and provoke more character from them.
- For even more character, you can also overdrive the output stage
and the output transformer but you will then need a level control
after the PREQ-73 PREMIER in order to reduce the level to the
appropiate one. This level control can be a passive damping device
(like the Shure A15AS XLR switchable pad) or an input level control
in the unit following the PREQ-73 PREMIER. Vintage character for modern ideas!

Termékspecifikációk

Márka: Golden Age Project
Kategória: Vevő
Modell: PREQ-73 Premier

Szüksége van segítségre?

Ha segítségre van szüksége Golden Age Project PREQ-73 Premier, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók Vevő Golden Age Project

Golden Age Project

Golden Age Project PRE-73 JR Útmutató

12 Augusztus 2024
Golden Age Project

Golden Age Project PRE-73 MKIII Útmutató

17 Július 2024
Golden Age Project

Golden Age Project PRE-573 Premier 500 Series 1073-Style Microphone Preamp Útmutató

15 Július 2024
Golden Age Project

Golden Age Project PRE-73 Premier Útmutató

15 Július 2024
Golden Age Project

Golden Age Project PRE-73 DLX Útmutató

11 Július 2024
Golden Age Project

Golden Age Project PREQ-73 Premier Útmutató

9 Július 2024
Golden Age Project

Golden Age Project PRE-573 MKIII Útmutató

7 Július 2024
Golden Age Project

Golden Age Project PRE-73 DLX PREMIER Útmutató

4 Július 2024

Útmutatók Vevő

Legújabb útmutatók Vevő

Yamaha

Yamaha Aventage RX-A4A Útmutató

9 Április 2025
Yamaha

Yamaha Aventage RX-A8A Útmutató

9 Április 2025
DJI

DJI D-RTK 3 Útmutató

5 Április 2025
Phonocar

Phonocar PH544 Útmutató

5 Április 2025
QSC

QSC SPA-Qf 60x2 Útmutató

2 Április 2025
Harper

Harper HDT2-5010 Útmutató

2 Április 2025
Harper

Harper HDT2-2010 Útmutató

2 Április 2025
Alpine

Alpine MRX-F65 Útmutató

31 Március 2025
Streacom

Streacom TL1 Útmutató

31 Március 2025
Pro-Ject

Pro-Ject Stereo Box DS Útmutató

30 Március 2025