Használati útmutató Futaba DLPH-1

Futaba távirányító DLPH-1

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Futaba DLPH-1 (1 oldal) a távirányító kategóriában. Ezt az útmutatót 3 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/1
ReceiverLink
ReceiverLink
ReceiverLink
ReceiverLink
ReceiverLink
BatteryF/S
BatteryF/S
BatteryF/S
BatteryF/S
BatteryF/S
Precautions
Precautions
Precautions
Precautions
Precautions
1.Install two receivers on the aircraft as shown in the wiring diagram on the
next page.
2.Link the two receivers using the dual receiver feature of the transmitter.
For systems without dual receiver capability, link each receiver in turn.
WARNING
Failuretofollowthesesafetyprecautionsmayresultinsevereinjurytoyourselfandothers.
Inordertopreventanyshortcircuits,pleaseobservethepolarityofall
connections.
Ensurethattheunitisconnectedproperlytothereceiver.
■If the connector is disconnected during flight, it becomes inoperable.
Ensurethattheunitismountedinanareathatwilleliminateexposureto
fuelandwater.
■As with any electronic components, proper precautions are urged to pro-
long the life and increase the performance of the unit.
Allowaslightamountofslackintheunitcablesandfastenthemata
suitablelocationtopreventanydamagefromvibrationduringflight.
Besuretolinkthetworeceiverswiththetransmitter.
■It will not work unless the two receivers are linked. After startup, even if
the link on one side is disconnected, the other side will continue to oper-
ate normally.
UsedinasetofFutabaS.BUS/S.BUS2systems.
DonotsupplyreceiverpowerfromtheESC.Whenusingthereceiver
powersupplytypeESC,removethered(+)cordofthe3chwiringfrom
theESCsothatthepowerisnotsuppliedfromtheESC.
■Use a dedicated battery to power the receiver / servo.
Donotconnecttheservoandtelemetrysensordirectlytothereceiver.
■Large current flows through the Rx port of DLPH-1 and is damaged.
Donotconnectahighvoltagebatterybeyondthespecificationsofthe
servoused.
■There is a risk of explosion, fire and damage.
Donotusemorethan60Aforamoment.
■Reference: Although it depends on the servo used and flight style, acro
flight with 15 HPS servos has been confirmed.
Toensure that the DLPH -1 is functi oning a s desired, please test
accordingly.
■Do not fly until inspection is complete.
Beforetheflight,disconnectthewiringofthemainreceiverfromthe
DLPH-1thatisoperatingnormally,andcheckifthesubreceiveralone
cancontrolit.
■Check if the DLPH-1 switches.
DonotusetheDLPH-1withanythingotherthananR/Cmodel.   
Transmitterinlinkmode Transmitterinlinkmode
For FASSTest18CHSelect
dualmodeandlinkprimary
*Followthelinkprocedure
foreachreceivermanual.
ForFASSTest18CHSelectdual
modeandlinksecondary
Turnonthemain
receiverandlink
Turnonthesub
receiverandlink
MainRX
SubRX
Workswiththe
mainreceiver
Troubleoccurredinthe
mainreceiver ！！
DLPH-1automatically
switchestosub-receiver Switchtothemain
receiverwhen
communicationis
recovered
Appllcablesystems
S.BUS/S.BUS2receiver
*Exceptforcars
Thank you for purchasing the DLPH-1. Before using your new DLPH-1, please
read this manual thoroughly and use the DLPH-1 properly and safely. After read-
ing this manual, store it in a safe place.
Use : Two receivers and two batteries communication
switching device
Size : 62.8×62.4×18.1 mm
( in)2.47×2.46×0.71
Weight : 50 g (1.76 oz)
FET rated :
Always 60 A / 2 pcs
Operating voltage : DC6.4 V to 13.0 V
Accessories:
Switch / Receiver connection cord x 2
/ Mini screwdriver/ Flange damper / Eyelet / Wood screw
◆ Abouttelemetrysystem
Whenusingthedualreceiverfunction
・Thetelemetryfunctionofthemainreceiver
canbeused
・Sub-receivertelemetryfunctionisnotavailable
Otherthandualreceiverfunction
・Telemetrynotavailable
・SettelemetrytoINH(disabled)
TwoS.BUS2/S.BUSReceivers
MainReceiverSubReceiver
7R6%866%86SRUW
:KHQXVLQJ(6&
9DULRXVWHOHPHWU\VHQVRUV6%86J\URHWF
6ZLWFK
(6&
5HFHLYHUق6HUYRك%DWWHU\
ٴ/L)HFHOOV岜9
ٴ/L3RFHOOV岜9
ٴق/L3RFHOOV岜9ك
ٴ/L)HFHOOV岜9
ٴ/L3RFHOOV岜9
ٴق/L3RFHOOV岜9ك
5HFHLYHUق6HUYRك%DWWHU\
6%86
&+
&+
&+
&+
&+
&+
&+
&+
&+
&+
&+
&+
&+
&+
&+
&+
&+
&+
6%86
AntennaMakearrangeindifferent
fourdirections.
HowtoUseWiring
HowtoUseWiring
HowtoUseWiring
HowtoUseWiring
HowtoUseWiring
FUTABA CORPORATION
Hobby Radio Control Business Center Sales & Marketing Department
1080 Yabutsuka, Chosei-mura, Chosei-gun, Chiba-ken, 299-4395, Japan
TEL: +81-475-32-6051, FAX: +81-475-32-2915
©FUTABA CORPORATION 2021, 10 (1)
DonotsupplyreceiverpowerfromtheESC.Whenusingthe
receiverpowersupplytypeESC,removethered(+)cord
ofthe3chwiringfromtheESCsothatthepowerisnotsupplied
fromtheESC.
■Use a dedicated battery to power the receiver / servo.
This receiver employs an electronic switching (current is controlled by an FET circuit)
system. When the exclusive switch is set to ON or is pulled, the power is turned on.
Switches other than the exclusive switch cannot be used. In addition, since a very
VPDOOFXUUHQWÀRZVHYHQZKHQWKHSRZHULVR൵DOZD\VGLVFRQQHFWWKHEDWWHU\IURPWKH
connector when the receiver is not in use.
One or 2 batteries can be connected. When 2 batteries are connected, the battery with
the highest voltage is used. When only one battery is connected, always insulate the
unused connector. The battery can be connected to either side.
8VHEDWWHULHVZLWKVX൶FLHQWFDSDFLW\IRUWKHVSHFL¿FDWLRQVDQGQXPEHURIVHUYRPRWRUV
to be used.
Evenifthevoltageofoneofthe
batteriesdrops,powerissupplied
fromtheotherbattery.
Evenifthepowersupplywiringof
oneofthebatteriesbreaks,power
issuppliedfromtheotherbattery.
Whentheswitch issetto ON,
p o we r i s s u p p l i e d f r om  th e
batterywiththehighestvoltage.
Theoperatingtimeisthetotal
timeofthe2batteries.
E l e c t r i c  p o w e r  w i l l  b e
automaticallyandalternatively
suppliedfromthebatterywhich
voltageishigher.
Battery2 Battery1
Suppliedfrom
battery2
Suppliedfrom
battery1
Suppliedfrom
battery1
BatteryLED
BatteryLED
BatteryLED
BatteryLED
BatteryLED
Dualbatterysystem
Dualbatterysystem
Dualbatterysystem
Dualbatterysystem
Dualbatterysystem
7KHEDWWHU\/('RQWKHVLGHEHLQJXVHGOLJKWVXS,WWXUQVR൵ZKHQHDFKEHFRPHV9RUOHVV
Battery2lights
greenwhen6V
orhigher
Battery1lights
greenwhen6V
orhigher
Two power supply batteries can be connected to the DLPH-1. Power is supplied
from the battery with the highest voltage. The operating time is the total time of the 2
batteries. For example, even if the voltage of one battery drops, power can be supplied
IURP WKH RWKHU EDWWHU\(YHQ RQH EDWWHU\ FDQ EH XVHG EXW VDIHU ÀLJKW LV SRVVLEOH LI 
batteries are used.
DLPH-1
DualRXLinkPowerHUB
1M23N38101
72.0mm
44.8mm
Instruction Manual
Ifoneofthetworeceivers
becomesunreceivable,itwill
automaticallyswitchtothe
otherreceiver.
Automatically
switchesbetweenthe
twobatteries.
Upto18high-performanceservoscanbePWMconnected.
2．
4．
1．
3．
LEDReceiver2（Sub）
Nosignalreception:OFF
Receivingsignals:Green
Receivingerror:Red
LEDReceiver1（Main）
Nosignalreception:OFF
Receivingsignals:Green
Receivingerror:Red
● Li-Fe2cells
orLi-Po3cells
（Li-Po3cells）
Do notconnecttheservo and telemetry
sensordirectlytothereceiver.
Thetwobatteriesshouldnotuse
differenttypes.
Besuretoremovethebattery
whennotinuse.
Li-po3cell11.4Vcannotbeused
withFutabaHobbyServos.
(asof2021/10)
T
T
T
Telemetryfunction(voltagedisplay)
elemetryfunction(voltagedisplay)
elemetryfunction(voltagedisplay)
elemetryfunction(voltagedisplay)
Telemetryfunction(voltagedisplay)
The DLPH-1 is equipped with a telemetry sensor function. The receiver voltage displayed on the
transmitter home screen is only a constant value. The voltages of battery 1 and battery 2 should
be monitored by telemetry voltage.
DLPH-1 uses two continuous slots. Please note that the proper default start slot for this accessory
is number 6. When setup-changing or adding, it is the following numbers that are made to a start
slot.
1,2,3,4,5,6,8,9,10,11,12,13,14,16,17,18,19,20,21,22,24,25,26,27,28,29,30
By connecting the transmitter and SB2 port, it is possible to register to the transmitter and change
the start slot. In that case, it is necessary to connect the battery to DLPH-1 and supply power.
Information on how to change the slot assignment is included in the transmitter's manual.
Telemetry → Voltage T32MZexample
ReceiverBattery1Voltage
ReceiverBattery2Voltage
Voltageswitch
11.4V
7.6V
6.4V
Mounting hole dimensions
●)RUUHFHLYHUVWKDWFDQVHWWKHEDWWHU\)6VHWWKHEDWWHU\)6WR9
or less or OFF.
●Also, make sure that the battery F / S of the two receivers have the same
settings.
6LQFHWKHRXWSXWYROWDJHIURP'/3+LV9LIWKHEDWWHU\)6LVVHWWR
9RUKLJKHUWKHEDWWHU\)6ZLOODOZD\RSHUDWH
InstalltheDLPH-1inawell-
ventilatedplacetocoolit.
*Ifthebatterylevelis40-30%orless,
thereceiverwillnotturnonforsafety.
Besuretoswitchaccordingtothebatteryused.
Iftheswitchpositionandtheconnectedbatteries
aredifferent,powerwillnotbesupplied.

Termékspecifikációk

Márka: Futaba
Kategória: távirányító
Modell: DLPH-1

Szüksége van segítségre?

Ha segítségre van szüksége Futaba DLPH-1, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók távirányító Futaba

Futaba

Futaba DLPH-1 Útmutató

11 December 2024
Futaba

Futaba T3PV Útmutató

11 December 2024
Futaba

Futaba SBS-01V Útmutató

11 December 2024

Útmutatók távirányító

Legújabb útmutatók távirányító

Velleman

Velleman DVRRC4 Útmutató

9 December 2024
Audio-Technica

Audio-Technica AT-SL931HD Útmutató

7 December 2024
Canon

Canon BG-E20 Útmutató

12 Október 2024
Neewer

Neewer RT112 Útmutató

8 Október 2024
Neewer

Neewer RT113 Útmutató

8 Október 2024
Logitech

Logitech Harmony 785 Útmutató

8 Október 2024
DSC

DSC WS4949 Útmutató

8 Október 2024
MB Quart

MB Quart N1-RC Wireless Útmutató

7 Október 2024
Technics

Technics EUR644377 Útmutató

5 Október 2024
Logitech

Logitech Harmony 600 Útmutató

5 Október 2024