Használati útmutató Electro-Voice Xi-1082

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Electro-Voice Xi-1082 (1 oldal) a hangszóró kategóriában. Ezt az útmutatót 2 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/1
MB1082 Mounting
Bracket Kit Installation
Instructions
12000 Portland Avenue South, Burnsville, MN 55337
Phone:952/884-4051, Fax:952/884-0043
www.electrovoice.com
© Telex Communications, Inc. 7/2003
Part Number 535431 Rev B
U.S.A. and Canada only. For customer orders, contact Customer Service at:
800/392-3497 Fax: 800/955-6831
Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:
+ 49 9421-706 0 Fax: + 49 9421-706 265
Other International locations. For customer orders, contact Customer Service at:
+ 1 952 884-4051 Fax: + 1 952 736-4212
For warranty repair or service information, contact the Service Repair department at:
800/685-2606
For technical assistance, contact Technical Support at: 866/78AUDIO
Specifications subject to change without notice.
Wall or Ceiling Mounting Instructions
Refer to the Figure and Table below for the following steps:
1. Attach the U-bracket (A) to the wall or ceiling using fasteners that are suitable for the wall or ceiling material (not
supplied).
2. Remove the paper backing from the friction pads (C) and attach these to the U-bracket as shown.
3. Remove the two 3/8-16 bolts from each end of the enclosure.
4. Ensuring that the washer (B) is mounted between the U-bracket and the 3/8-16 screw(s) previously removed from
the enclosure, mount the Xi-1082 to the U-bracket by selecting two of the six avaliable mounting holes on the
bracket.
5. Rotate the speaker so that the input terminal is accessible and attach the wires. Position the speaker for the
desired angle and tighten the screws sufficiently so that the speaker does not inadvertently rotate.
CAUTION:
Due to the weight of the Xi-1082 speaker system, it is imperative that the Xi-1082 bracket be
properly secured to the wall or ceiling. The choice of fastener (not provided with bracket kit)
will be determined by the material and construction of the mounting surface.
met
I .
yt
Q .
oNtraP noitpircseD
A 1 HJ/FJ-02147 thW/klBtekcarB-U
B 2 3504 srehsaW
C 2 02083 sdaPnoitcirF
3/8-16 Screw
from Xi-1082
snoitacificepS
:seloHgnitnuoMgnilieC/lla
W "
04.0,enil-nieerhT retemaid)mm01(
,selohecnaraelc
"8.6decapssretnec
trapa)mm371(
:seloHgnitnuoMerusolcn
E )
mm01("04.0xiS ecnaraelcretemaid
fosdneehtnoseloh
tekcarbeht
:laireta
M l
eetsdellor-toH
:hsini
F r
edwopetihWrokcalB taoc
:)evobaelbatees(deilppuSstra
P n
oitcirF)2(,tekcarb-U srehsaW)2(,sdap
:thgieWte
N )
gk20.1(sbl52.2
:thgieWgnippih
S )
gk74.1(sbl52.3
:srebmuNtra
P )
KLB(4423007 )THW(2043007

Termékspecifikációk

Márka: Electro-Voice
Kategória: hangszóró
Modell: Xi-1082

Szüksége van segítségre?

Ha segítségre van szüksége Electro-Voice Xi-1082, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók hangszóró Electro-Voice

Útmutatók hangszóró

Legújabb útmutatók hangszóró