Használati útmutató Elba EWF 0861 A

Elba mosógép EWF 0861 A

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Elba EWF 0861 A (21 oldal) a mosógép kategóriában. Ezt az útmutatót 3 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/21
EWF 0861 A
Washing Machine
Users Manual
2EN
1 Important safety instructions
This section contains safety instructions that will
help protect from risk of personal injury or property
damage. Failure to follow these instructions shall void
any warranty.
General safety
 8yearsandolderchildrenandpeoplewith
reduced physical, sensory, and mental abilities
as well as unskilled or inexperienced persons
can use this appliance provided that they are
supervised and instructed on safe use of the
appliance as well as to the related dangers.
Children should not play or tamper with the
appliance. Cleaning and user maintenance
should never be performed by children unless
supervised by a responsible adult.
 Neverplacetheproductonacarpet-covered
floor; otherwise, lack of airflow beneath the
machine will cause electrical parts to overheat.
This will cause problems with your product.
 Donotoperatetheproductifthepowercable
/ plug is damaged. Call the Authorized Service
Agent.
 Haveaqualifiedelectricianconnecta
16-Amperefusetotheinstallationlocationofthe
product.
 Iftheproducthasafailure,itshouldnotbe
operated unless it is repaired by the Authorized
Service Agent. There is the risk of electric shock!
 Thisproductisdesignedtoresumeoperating
in the event of powering on after a power
interruption.Ifyouwishtocancelthe
programme, see "Cancelling the programme"
section.
 Connecttheproducttoagroundedoutlet
protected by a fuse complying with the values
inthe"Technicalspecifications"table.Donot
neglect to have the grounding installation made
byaqualifiedelectrician.Ourcompanyshall
not be liable for any damages that will arise
when the product is used without grounding in
accordance with the local regulations.
 Thewatersupplyanddraininghosesmustbe
securely fastened and remain undamaged.
Otherwise,thereistheriskofwaterleakage.
 Neveropentheloadingdoororremovethefilter
whilethereisstillwaterinthedrum.Otherwise,
risk of flooding and injury from hot water will
occur.
 Donotforceopenthelockedloadingdoor.The
loading door will be ready to open just a few
minutes after the washing cycle comes to an
end.Incaseofforcingtheloadingdoortoopen,
the door and the lock mechanism may get
damaged.
 Unplugtheproductwhennotinuse.
 Neverwashtheproductbyspreadingorpouring
water onto it! There is the risk of electric shock!
 Nevertouchtheplugwithwethands!Never
unplug by pulling on the cable, always pull out
by grabbing the plug.
 Usedetergents,softenersandsupplements
suitable for automatic washing machines only.
 Followtheinstructionsonthetextiletagsandon
the detergent package.
 Theproductmustbeunpluggedduring
installation, maintenance, cleaning and repairing
procedures.
 Alwayshavetheinstallationandrepairing
procedures carried out by the Authorized
Service Agent. Manufacturer shall not be
held liable for damages that may arise from
procedures carried out by unauthorized
persons.
Intended use
 Thisproducthasbeendesignedfordomestic
use.Itisnotsuitableforcommercialuseandit
must not be used out of its intended use.
 Theproductmustonlybeusedforwashingand
rinsing of laundry that are marked accordingly.
 Themanufacturerwaivesanyresponsibility
arisen from incorrect usage or transportation.
Children's safety
 Electricalproductsaredangerousforthe
children. Keep children away from the product
whenitisinuse.Donotletthemtotamperwith
theproduct.Usechildlocktopreventchildren
from intervening with the product.
 Donotforgettoclosetheloadingdoorwhen
leaving the room where the product is located.
 Storealldetergentsandadditivesinasafeplace
away from the reach of the children.
2 Installation
Refer to the nearest Authorised Service Agent for
installation of the product. To make the product ready
for use, review the information in the user manual
and make sure that the electricity, tap water supply
and water drainage systems are appropriate before
callingtheAuthorizedServiceAgent.Iftheyarenot,
callaqualifiedtechnicianandplumbertohaveany
necessary arrangements carried out.
C Preparation of the location and electrical, tap
water and waste water installations at the place
of installation is under customer's responsibility.
B Installationandelectricalconnectionsofthe
product must be carried out by the Authorized
Service Agent. Manufacturer shall not be
held liable for damages that may arise from
procedures carried out by unauthorized
persons.
A Prior to installation, visually check if the product
hasanydefectsonit.Ifso,donothaveit
installed.Damagedproductscauserisksfor
your safety.
C Make sure that the water inlet and discharge
hoses as well as the power cable are not
folded, pinched or crushed while pushing the
product into its place after installation or cleaning
procedures.
Appropriate installation location
 Placethemachineonarigidfloor.Donotplace
it on a long pile rug or similar surfaces.
 Totalweightofthewashingmachineandthe
dryer-withfullload-whentheyareplaced
3EN
ontopofeachotherreachestoapprox.180
kilograms. Place the product on a solid and flat
floor that has sufficient load carrying capacity!
 Donotplacetheproductonthepowercable.
 Donotinstalltheproductatplaceswhere
temperaturemayfallbelow0ºC.
 Placetheproductatleast1cmawayfromthe
edges of other furniture.
Removing packaging reinforcement
Tilt the machine backwards to remove the packaging
reinforcement. Remove the packaging reinforcement
by pulling the ribbon.
Removing the transportation locks
A Donotremovethetransportationlocksbefore
taking out the packaging reinforcement.
A Remove the transportation safety bolts before
operating the washing machine, otherwise, the
product will be damaged.
1. Loosen all the bolts with a spanner until they
rotate freely (C).
2. Remove transportation safety bolts by turning
them gently.
3. AttachtheplasticcoverssuppliedintheUser
Manual bag into the holes on the rear panel. (P)
C Keep the transportation safety bolts in a safe
place to reuse when the washing machine
needs to be moved again in the future.
C Never move the product without the
transportation safety bolts properly fixed in
place!
Connecting water supply
C Thewatersupplypressurerequiredtorunthe
productisbetween1to10bars(0.11MPa).
Itisnecessarytohave10–80litersofwater
flowing from the fully open tap in one minute
to have your machine run smoothly. Attach a
pressure reducing valve if water pressure is
higher.
C Ifyouaregoingtousethedoublewater-inlet
productasasingle(cold)water-inletunit,you
must install the supplied stopper to the hot
water valve before operating the product.
(Applies for the products supplied with a blind
stopper group.)
C Ifyouwanttousebothwaterinletsofthe
product, connect the hot water hose after
removing the stopper and gasket group from
the hot water valve. (Applies for the products
supplied with a blind stopper group.)
A Models with a single water inlet should not be
connectedtothehotwatertap.Insuchacase
the laundry will get damaged or the product will
switch to protection mode and will not operate.
A Donotuseoldorusedwaterinlethoseson
thenewproduct.Itmaycausestainsonyour
laundry.
1. Connect the special hoses supplied with the
product to the water inlets on the product. Red
hose(left)(max.90ºC)isforhotwaterinlet,blue
hose(right)(max.25ºC)isforcoldwaterinlet.
A Ensure that the cold and hot water connections
are made correctly when installing the product.
Otherwise,yourlaundrywillcomeouthotatthe
end of the washing process and wear out.
2. Tighten all hose nuts by hand. Never use a
wrench when tightening the nuts.
3. Openthetapscompletelyaftermakingthe
hose connection to check for water leaks at
theconnectionpoints.Ifanyleaksoccur,turn
off the tap and remove the nut. Retighten the
nut carefully after checking the seal. To prevent
water leakages and damages caused by them,
keep the taps closed when the machine is not in
use.
Connecting to the drain
 Theendofthedrainhosemustbedirectly
connected to the wastewater drain or to the
washbasin.
A Your house will be flooded if the hose comes out
of its housing during water discharge. Moreover,
there is risk of scalding due to high washing
temperatures! To prevent such situations and to
ensure smooth water intake and discharge of
the machine, fix the end of the discharge hose
tightly so that it cannot come out.
 Thehoseshouldbeattachedtoaheightofat
least40cm,and100cmatmost.
 Incasethehoseiselevatedafterlayingiton
the floor level or close to the ground (less than
40cmabovetheground),waterdischarge
becomes more difficult and the laundry may
come out excessively wet. Therefore, follow the
heights described in the figure.

Termékspecifikációk

Márka: Elba
Kategória: mosógép
Modell: EWF 0861 A

Szüksége van segítségre?

Ha segítségre van szüksége Elba EWF 0861 A, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók mosógép Elba

Útmutatók mosógép

Legújabb útmutatók mosógép

Hoover

Hoover VHD842 Útmutató

16 Október 2024
GE

GE GSD3715FAA Útmutató

16 Október 2024
Freggia

Freggia WTIE148 Útmutató

16 Október 2024
Freggia

Freggia WISE126R Útmutató

16 Október 2024
Freggia

Freggia WISE126B Útmutató

16 Október 2024
Freggia

Freggia WISE126 Útmutató

16 Október 2024
Freggia

Freggia WISA105 Útmutató

16 Október 2024
Freggia

Freggia WISA106 Útmutató

16 Október 2024
Freggia

Freggia WIA107 Útmutató

16 Október 2024