Használati útmutató Ebode eSD18

Ebode detektor eSD18

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Ebode eSD18 (36 oldal) a detektor kategóriában. Ezt az útmutatót 2 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/36
www.ebodeelectronics.eu
Wireless Smoke Detector
eSD18
User guide 2
Bedienungsanleitung 7
Gebruikershandleiding 12
Användarmanual 17
Guide utilisateur 22
Manual do utilizador 27
Before using our product, please read this documents carefully.
7-5-2013 2 ebode eSD18
User Guide
Contents
1. CONFORMITY OF USE
2. INTRODUCTION
3. INSTALLATION INSTRUCTIONS
4. USING THE SMOKE DETECTOR
5. REGISTERING THE DETECTOR WITH THE BSS880 HOME PROTECTOR & CONSOLE
6. REGISTERING WITH THE SC28 HOME PROTECTOR
7. REGISTERING WITH THE BS800 HOMEGUARD
1. Conformity of Use
For carefree and safe use of this product, please read this manual and safety information
carefully and follow the instructions. The unit is registered as a device that does not cause
or suffer from radio-frequency interference. It is CE approved and it conforms with the
Low Voltage Directory. The safety and installation instructions must be observed.
Technical manipulation of the product, or any changes to the product, is forbidden, due to
security and approval issues. Please take care to set up the device correctly - consult your
user guide. Young children should use the device only under adult supervision. No
guarantee or liability will be accepted for any damage caused due to incorrect use of the
equipment supplied, other than indicated in this owner’s manual.
Safety Warnings
Avoid strong mechanical tear and wear, extreme ambient temperatures, strong
vibrations and atmospheric humidity.
Do not disassemble any part of the product: the device contains live parts and no
user-serviceable parts are inside. The product should only be repaired or serviced by
qualified and authorized service personnel. Defected pieces must be replaced by original
(spare) parts.
Batteries: keep batteries out of the reach of children. Dispose of batteries as chemical
waste. Never use old and new batteries or different types of batteries together. Remove
the batteries when you are not using the system for a longer period of time. When
inserting batteries, please be sure the polarity is right. Make sure that the batteries are
not short circuits and are not disposed in fire (danger of explosion).
In case of improper usage or if you have opened, altered and repaired the product
yourself, all guarantees expire. The supplier does not accept responsibility in the case of
improper usage of the product or when the product is used for purposes other than
specified. The supplier does not accept responsibility for additional damage other than
covered by the legal product responsibility.
7-5-2013 3 ebode eSD18
2. Introduction
Thank you for purchasing the ebode eSD18. t warned by smoke emission and intervene Ge
on time to avoid damage caused by smoke and fire. The ebode eSD18 smoke detector has
an optical sensor for fast response and is powered by a 9 Volt battery (not included). The
eSD18 is easy and quick to assemble and has a test button for function check. Place the
eSD18 on every floor of your home for maximum security. Upon detection of smoke, the
eSD18 will sound an alarm 85DB. The eSD18 can be used stand-alone, and also has the of
option to be connected to an X-10 alarm BS800 (HomeGuard) and Protector Plus (BS880 /
BS880 and 4/7).
3. Installation instructions
Recommended Installation Locations
We recommend the installation of a Smoke Combination Detector in the following locations
illustrated below. For maximum protection we suggest an alarm be installed on each level of
a multilevel home including every bedroom, hallway, finished attic and basement. Put an
alarm at both ends of a bedroom, hallway or large room if the hallway or room is more
than 30ft.(9.1m) long. If you have only one alarm, ensure it is placed in the hallway outside
of the main sleeping area, or in the main bedroom. Verify the alarm can be heard in all
sleeping areas. Locate an alarm in every room where someone sleeps with the door closed.
Mount the alarm on the ceiling in the centre of the room. Ceiling mounting is preferred in
ordinary residential construction. When mounting an alarm on the ceiling, locate it at a
minimum of 4”(10cm) from the side wall. If installing the alarm on the wall, at a minimum
of 4”(10cm) and a maximum of 12”(30.5cm) below the ceiling (see diagram below).
Figure 1.1
Where not to mount the detector
Do not install in garages, kitchens, furnace rooms or bathrooms and install at least feet 15
(5m) away from any fuel burning appliance Do not install within 3ft (0.9m) of the .
following: The kitchen door or a bathroom that contains tub or shower, forced air ducts
used for heating or cooling, ceiling or whole house ventilating fans, or other high air flow
areas. Avoid excessively dusty, dirty or greasy areas. Dust, grease or household chemicals
contaminate the alarm’s sensors, causing it to malfunction. Do not place the alarm where
drapes or other objects can block the sensor. Smoke must be able to reach the sensors to
accurately detect these conditions. Do not install in peaks of vaulted ceiling, “A” frame
ceilings or gabled roofs. Avoid installing the detector in damp and humid areas. Install at
least one foot away from fluorescent lights; electronic noise may cause false alarms.
Extreme temperatures will effect the sensitivity of the Smoke Alarm. Do not install in areas
where the temperature is below 40 degrees Fahrenheit (4.4 Celsius) or above 100 degrees
Fahrenheit (37.8 Celsius). Place the detector away from doors and windows that open to
the outside.

Termékspecifikációk

Márka: Ebode
Kategória: detektor
Modell: eSD18

Szüksége van segítségre?

Ha segítségre van szüksége Ebode eSD18, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók detektor Ebode

Ebode

Ebode eWD18 Útmutató

27 Augusztus 2024
Ebode

Ebode eSD18 Útmutató

16 Augusztus 2024

Útmutatók detektor

Legújabb útmutatók detektor

Velleman

Velleman HAM222 Útmutató

9 December 2024
IFM

IFM OW1010 Útmutató

6 December 2024
Sauter

Sauter SP 200K Útmutató

6 December 2024
Alecto

Alecto HA-58 Útmutató

3 Október 2024
Amprobe

Amprobe ULD-400-T Útmutató

30 Szeptember 2024
Hager

Hager EE809 Útmutató

21 Szeptember 2024
Denver

Denver MET-110 Útmutató

14 Szeptember 2024