Használati útmutató CyberData Systems 011461

CyberData Systems telefon 011461

Olvassa el alább 📖 a magyar nyelvű használati útmutatót CyberData Systems 011461 (3 oldal) a telefon kategóriában. Ezt az útmutatót 5 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/3
Quick Start Guide 931479A
1.0 Out-of-Box and Prior to Final Installation
1.1. Verify that you have received all of the parts listed on the Installation Quick
Reference placemat.
1.2. Download the current manual, otherwise known as an Operation Guide,
which is available in the Downloads tab at the following webpage:
http://www.cyberdata.net/voip/011461/
Note You can also navigate to the Downloads tab by going to
www.CyberData.net and following the steps that are indicated by
the following figures:
2.0 Select Power Source
PoE Switch PoE Injector
Set PoE power type to Class 0 = 15.4W CAT6 cable recommended—
for longer distances
Be sure you are using a non-PoE switch or port
Make sure port is not in trunk mode
Set port to full duplex/ 100Mbps
1
3 4
2
Part Number: 011461
SIP Vandal Resistant Keypad Phone
SIP Vandal Resistant Keypad Phone
Quick Start Guide
The IP Endpoint Company
Quick Start Guide 931479A
3.0 Power Test
3.1. Plug in the CyberData device and monitor the LED activity above the
ethernet port on the board. See the following figure:
3.2. The amber 100 Mb Link LED blinks off once during the boot up process
when the device begins DHCP addressing and autoprovisioning attempts,
and then comes on again and remains constant (solid amber). The green
Link/Activity LED may be blinking depending on the network activity.
Note The default DHCP addressing timeout is 60 seconds. The device will attempt
DHCP addressing 12 times with a 3 second delay between tries and eventually
fall back to the programmed static IP address (by default 10.10.10.10) if DHCP
addressing fails. The DHCP Timeout is configurable in the device's Network
settings.
3.3. When the device has completed the initialization process, press and hold
the RESET switch (SW1 button) for 3 seconds to announce the IP address.
This concludes the power test. Go to Section 4.0, "Connecting to a Network
in a Test Environment".
100 Mb Link LED
Link/Activity J1
Quick Start Guide 931479A
4.0 Connecting to a Network in a Test Environment
Note The following connections are usually needed for this procedure:
• Computer
• PoE switch or injector
• CyberData device
4.1. In a test environment, use a computer that is connected to the same switch
as a single CyberData device. Note the subnet of the test computer.
4.2. Use the CyberData Discovery Utility program to locate the device on the
network. You can download the Discovery Utility program from the following
link:
http://www.cyberdata.net/assets/common/discovery.zip
4.3. Wait for initialization to complete before using the Discovery Utility program
to scan for a device. The device will show the current IP address, MAC
address, and serial number.
4.4. Select the device.
4.5. Click Launch Browser. If the IP address is in a reachable subnet from the
computer that you are using to access the device, the Discovery Utility
program should be able to launch a browser window pointing to the device’s
IP address.
4.6. Log on to the web interface by using the default username (admin) and
password (admin) to configure the device.
4.7. Perform an audio test by pressing the Test Audio button that is located at
the bottom of the Device Configuration page. If the audio test message is
clearly audible, then your CyberData device is functioning properly.
4.8. The device is now ready to be set for your desired network configuration.
You may search the Compatible IP-PBX Servers index for available
sample VoIP phone system configurations and set up guides at the following
website address:
http://www.cyberdata.net/connecting-to-ip-pbx-servers/

Termékspecifikációk

Márka: CyberData Systems
Kategória: telefon
Modell: 011461

Szüksége van segítségre?

Ha segítségre van szüksége CyberData Systems 011461, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók telefon CyberData Systems

CyberData Systems

CyberData Systems SIP Paging Adapter Útmutató

29 Augusztus 2024
CyberData Systems

CyberData Systems 011462 Útmutató

25 Augusztus 2024
CyberData Systems

CyberData Systems 011461 Útmutató

25 Augusztus 2024
CyberData Systems

CyberData Systems 011460 Útmutató

25 Augusztus 2024

Útmutatók telefon

Legújabb útmutatók telefon

Panasonic

Panasonic KX-TGC202 Útmutató

4 Április 2025
HMD

HMD 150 Music Útmutató

31 Március 2025
Vimar

Vimar R289 Útmutató

30 Március 2025
Trevi

Trevi FLEX 51 Útmutató

18 Március 2025
Profoon

Profoon PDX-5900 Útmutató

15 Január 2025
Gigaset

Gigaset A400A Útmutató

14 Január 2025
Alcatel

Alcatel Smile Útmutató

14 Január 2025
Audioline

Audioline TEL38 Útmutató

13 Január 2025
Alcatel

Alcatel Versatis 80 Útmutató

13 Január 2025
Teledex

Teledex SIP ND210L Útmutató

13 Január 2025