Használati útmutató Chief SSB293

Chief Lapos panel támogatás SSB293

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Chief SSB293 (1 oldal) a Lapos panel támogatás kategóriában. Ezt az útmutatót 7 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/1
I N S T A L L A T I O N I N S T R U C T I O N S
Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes
no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a products division of Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8800-002105 Rev00
©2011 Milestone AV Technologies,
a Duchossois Group Company
07/11
SSB-293, SSM-293, SLB-293 and SLM-293 Interface Brackets
SSB-293, SSM-293, SLB-293 and SLM-293 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the specific
installation instructions provided with the mount for additional installation information.
Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
Installation Instructions
WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT over tighten screws when installing interface brackets.
NOTE: Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.
1. Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.
2. Turn projector upside down on a flat surface.
3. Place three spacers over threaded inserts in bottom of projector.
4. Place the interface bracket onto the spacers, aligning the mounting holes in the bracket with the spacers and threaded inserts in the bottom
of the projector and ensuring that triangle in bracket points towards front of projector.
5. Position M3 x 16mm mounting screws into the spacers, threaded inserts and interface bracket. Tighten all fasteners at this time, securing
the bracket to the projector.
NOTE: Security screws can be substituted when mounting Interface bracket to projector by using the parts and installation
instructions in the All-Points Security Kit.
Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
(1) Interface Bracket (3) Screw, Phillips Flat Head, Machine, M3 x 16mm
(4) 10-24 Thumb Nuts ** (3) Spacer, Nylon, .375 x .194 x .3125
(1) All-Points Security Kit (1) 5/32" Security Hex Key
**Only used when installing SLB/SSB interface brackets.
NOTE: Specific to SSB-style and SSM-style interface bracket installation: All appropriate screws come pre-installed in the circled locations above.
DO NOT attempt to substitute and USE ONLY this pre-installed hardware for SSB-style and SSM-style interface bracket installation.
Note: SSB-style interface bracket connections are circled. Note: SSM-style interface bracket connections are circled.
SLB-293 SLM-293
Towards front
of projector
Towards front
of projector

Termékspecifikációk

Márka: Chief
Kategória: Lapos panel támogatás
Modell: SSB293

Szüksége van segítségre?

Ha segítségre van szüksége Chief SSB293, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók Lapos panel támogatás Chief

Chief

Chief MWCU Útmutató

3 Április 2025
Chief

Chief KITXWXSM1U Útmutató

3 Április 2025
Chief

Chief RLXT3 Útmutató

3 Április 2025
Chief

Chief MIWRFUB Útmutató

16 Január 2025
Chief

Chief TILD1X5NE1-M Útmutató

16 Január 2025
Chief

Chief TILD1X3NE1-R Útmutató

16 Január 2025
Chief

Chief TILD1X4NE1-L Útmutató

16 Január 2025
Chief

Chief PWRIWUB Útmutató

16 Január 2025
Chief

Chief RSMBU Útmutató

29 December 2024
Chief

Chief RPA640 Útmutató

29 December 2024

Útmutatók Lapos panel támogatás

Legújabb útmutatók Lapos panel támogatás

Konig

Konig KNM-MM20 Útmutató

8 Április 2025
Ergotron

Ergotron Neo-Flex Widescreen Stand Útmutató

3 Április 2025
Ergotron

Ergotron Neo-Flex Cantilever Útmutató

3 Április 2025
Ergotron

Ergotron All-In-One Lift Stand Útmutató

3 Április 2025
Ergotron

Ergotron DS100 Dual Monitor Desk Stand Útmutató

3 Április 2025
Ergotron

Ergotron DS Series DS100 Quad Monitor Desk Stand, Horizontal Útmutató

3 Április 2025
Ergotron

Ergotron LX Series Desk Mount LCD Arm, Tall Pole Útmutató

3 Április 2025
Ergotron

Ergotron LX Series Dual Stacking Arm Útmutató

3 Április 2025
Ergotron

Ergotron 100 Series Double Pivot Útmutató

3 Április 2025
Ergotron

Ergotron Convert-to-LCD & Laptop Kit Útmutató

3 Április 2025