Használati útmutató Chief SLB240

Chief Lapos panel támogatás SLB240

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Chief SLB240 (1 oldal) a Lapos panel támogatás kategóriában. Ezt az útmutatót 6 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/1
I N S T A L L A T I O N I N S T R U C T I O N S
Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes
no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a products division of Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8850-000151 Rev01
©2009 Milestone AV Technologies,
a Duchossois Group Company
05/09
SSB-240, SSM-240, SLB-240 and SLM-240 Interface Brackets
SSB-240, SSM-240, SLB-240 and SLM-240 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the specific
installation instructions provided with the mount for additional installation information.
Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
Installation Instructions
WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT over tighten screws when installing interface bracket.
NOTE: Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.
1. Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.
2. Turn projector upside down on a flat surface.
3. Place interface bracket onto of projector and align bracket with threaded inserts in projector.
4. Hold interface bracket and use 1/4" spacer to slide between projector and front mounting hole in bracket.
5. Attach interface bracket to projector using M4 x 16mm Phillips pan head screw with flat washer in front mounting hole and M4 x 8mm
Phillips pan head screws with flat washers in rear mounting holes of bracket. Tighten all fasteners at this time, securing the bracket to the
projector.
NOTE: Security screws can be substituted when mounting interface bracket to projector by using the parts and installation instructions in the
All-Points Security Kit.
Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
(1) Interface Bracket (1) Screw, Phillips Pan Head, Machine, M4 x 16mm ****
(4) 10-24 Thumb Nuts ** (2) Screw, Phillips Pan Head, Machine, M4 x 8mm
(1) All-Points Security Kit (1) 1/2" x .218" x 1/4" Round Spacer ****
(3) Washer, Flat, M4
**Only used when installing SLB/SSB interface brackets. ****Used when mounting surface of projector is recessed.
NOTE: Specific to SSB-style and SSM-style interface bracket installation, all appropriate screws come pre-installed as reflected in the
encircled locations above. DO NOT attempt to substitute and USE ONLY this pre-installed hardware for SSB-style and SSM-style
interface bracket installation.
SLB-240 SLM-240
(
Note: SSB-style interface bracket co
n
n
e
c
t
i
o
s
a
r
e
e
n
c
i
r
c
l
e
d
)
(
N
o
t
e
:
S
S
M
-
s
t
y
l
e
i
n
t
e
r
f
a
c
e
b
r
a
c
k
e
t
c
o
n
n
e
c
t
i
o
n
s
a
r
e
e
n
c
i
r
c
l
e
d
)
Towards front of
projector
Towards front of
projector

Termékspecifikációk

Márka: Chief
Kategória: Lapos panel támogatás
Modell: SLB240

Szüksége van segítségre?

Ha segítségre van szüksége Chief SLB240, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók Lapos panel támogatás Chief

Chief

Chief MWCU Útmutató

3 Április 2025
Chief

Chief KITXWXSM1U Útmutató

3 Április 2025
Chief

Chief RLXT3 Útmutató

3 Április 2025
Chief

Chief MIWRFUB Útmutató

16 Január 2025
Chief

Chief TILD1X5NE1-M Útmutató

16 Január 2025
Chief

Chief TILD1X3NE1-R Útmutató

16 Január 2025
Chief

Chief TILD1X4NE1-L Útmutató

16 Január 2025
Chief

Chief PWRIWUB Útmutató

16 Január 2025
Chief

Chief RSMBU Útmutató

29 December 2024
Chief

Chief RPA640 Útmutató

29 December 2024

Útmutatók Lapos panel támogatás

Legújabb útmutatók Lapos panel támogatás

Konig

Konig KNM-MM20 Útmutató

8 Április 2025
Ergotron

Ergotron Neo-Flex Widescreen Stand Útmutató

3 Április 2025
Ergotron

Ergotron Neo-Flex Cantilever Útmutató

3 Április 2025
Ergotron

Ergotron All-In-One Lift Stand Útmutató

3 Április 2025
Ergotron

Ergotron DS100 Dual Monitor Desk Stand Útmutató

3 Április 2025
Ergotron

Ergotron DS Series DS100 Quad Monitor Desk Stand, Horizontal Útmutató

3 Április 2025
Ergotron

Ergotron LX Series Desk Mount LCD Arm, Tall Pole Útmutató

3 Április 2025
Ergotron

Ergotron LX Series Dual Stacking Arm Útmutató

3 Április 2025
Ergotron

Ergotron 100 Series Double Pivot Útmutató

3 Április 2025
Ergotron

Ergotron Convert-to-LCD & Laptop Kit Útmutató

3 Április 2025