Használati útmutató Broan PM250

Broan Páraelszívó PM250

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Broan PM250 (12 oldal) a Páraelszívó kategóriában. Ezt az útmutatót 5 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/12
PM250 SERIES
READ AND SAVE THESE INSTRUCTIONS
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO
PERSONS, OBSERVE THE FOLLOWING:
1. Use this unit only in the manner intended by the manufacturer. If you
have questions, contact the manufacturer at the address or telephone
number listed in the warranty.
2. Before servicing or cleaning unit, switch power off at service panel and
lock service panel to prevent power from being switched on accidentally.
When the service disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a tag, to the service panel.
3. Installation work and electrical wiring must be done by a qualified
person(s) in accordance with all applicable codes and standards,
including fire-rated construction codes and standards.
4. Sufficient air is needed for proper combustion and exhausting of
gases through the flue (chimney) of fuel burning equipment to prevent
backdrafting. Follow the heating equipment manufacturer’s guidelines
and safety standards such as those published by the National Fire
Protection Association (NFPA), and the American Society for Heating,
Refrigeration and Air Conditioning Engineers (ASHRAE), and the local
code authorities.
5. When cutting or drilling into wall or ceiling, do not damage electrical
wiring and other hidden utilities.
6. Ducted fans must always be vented to the outdoors.
7. Do not use this unit with any separate solid-state speed control device.
8. To reduce the risk of fire, use only metal ductwork.
9. This unit must be grounded.
TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
A. Never leave surface units unattended at high settings. Boilovers cause
smoking and greasy spillovers that may ignite. Heat oils slowly on low
or medium settings.
B. Always turn hood ON when cooking at high heat or when flambeing
food (i.e. Crepes Suzette, Cherries Jubilee, Peppercorn Beef Flambe’).
C. Clean ventilating fans frequently. Grease should not be allowed to
accumulate on fan or filter.
D. Use proper pan size. Always use cookware appropriate for the size of
the surface element.
WARNING
TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF
A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:*
1. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray,
then turn off the burner. BE CAREFUL TO PREVENT BURNS. If the
flames do not go out immediately, EVACUATE AND CALL THE FIRE
DEPARTMENT.
2. NEVER PICK UP A FLAMING PAN - You may be burned.
3. DO NOT USE WATER, including wet dishcloths or towels - violent
steam explosion will result.
4. Use an extinguisher ONLY if:
A. You know you have a Class ABC extinguisher and you already
know how to operate it.
B. The fire is small and contained in the area where it started.
C. The fire department is being called.
D. You can fight the fire with your back to an exit.
* Based on “Kitchen Fire Safety Tips” published by NFPA.
INTENDED FOR DOMESTIC COOKING ONLY
CAUTION
1. For indoor use only.
2. To reduce risk of fire and to properly exhaust air, be sure to duct air
outside. Do not vent exhaust air into spaces within walls or ceilings
or into attics, crawl spaces, or garages.
3. Take care when using cleaning agents or detergents.
4. Avoid using food products that produce flames under the Range Hood.
5. For general ventilating use only. Do not use to exhaust hazardous or
explosive materials and vapors.
6. To avoid motor bearing damage and noisy and/or unbalanced
impellers, keep drywall spray, construction dust, etc. off power unit.
7. Your hood motor has a thermal overload which will automatically shut
off the motor if it becomes overheated. The motor will restart when
it cools down. If the motor continues to shut off and restart, have the
hood serviced.
8. The bottom of the hood MUST NOT BE LESS than 24” and
recommended at a maximum of 30” above the cooktop for best capture
of cooking impurities.
9. Two installers are recommended.
10. Use with approved cord-connection kit only.
11. Please read specification label on product for further information and
requirements.
POWER
MODULE
REGISTER YOUR PRODUCT ONLINE AT www.broan.com/register
NON-DUCTED RECIRCULATION
FILTER INSTALLATION
1. Remove the metal wires (Fig. 7) and discard them.
2. Install the Non-ducted recirculation Filter over the grease filter
and secure it with the metal wires supplied with the Non-ducted
recirculation Filter (Fig. 4).
WIRING
Note: This range hood must be properly grounded.
The unit should be installed by a qualified electrician in
accordance with all applicable national and local electrical codes.
Secure the conduit to the upper wiring hole through a conduit
connector.
Remove the (2) screws of the lateral wiring field cover and make
electrical connections. Connect both white leads to white supply lead
using suitable connector, connect black to black and green to green.
NON-DUCTED
RECIRCULATION
FILTER
INSTALL THE DUCTWORK
NOTE: To reduce the risk of fire, use only metal ductwork.
1. Decide where the ductwork will run between the hood and the
outside (Refer to Figure 1).
2. A straight, short duct run will allow the hood to perform most
efficiently.
3. Long duct runs, elbows, and transitions will reduce the performance
of the hood. Use as few of them as possible. Larger ducting may
be required for best performance with longer duct runs.
4. Install a roof or wall cap. Connect round metal ductwork to cap and
work back towards hood location. Use duct tape to seal the joints
between ductwork sections.
INSTALL THE HOOD
NOTE: the hood has to be installed, inside the cabinet, at minimum 1”
from the rear wall cabinet and at 3” from the front wall cabinet.
The internal height of cabinet has to be minimum 16”.
The hood should be mounted centered over the cook top burners.
1. Cut a hole in the bottom of the cabinet, using the dimensions shown
in Fig. 2.
2. Take off the (4) “A” screws and remove the metal grid (Fig. 3).
3. NOTE: For installations where the Power Pack is less than 30” above
cook top, it is recommended that the Power Pack be mounted into
a metal liner or non-combustible material. This will allow easier
cleaning and provide protection to the cabinetry (Fig.3A).
4. Insert the hood in the cabinet (Fig. 3) or metal liner (Fig. 3A) and
secure with the (4) “B” mounting sheet metal screws.
(Fig. 3 - wood bottom installation; recommended thickness 1/2”-
3/4”).
(For alternate mounting, use machine screws with washers and
nuts. This alternate mounting method needs to be done prior to
installation of metal liner).
5. In the Non-Ducted Recirculation Configuration, install the Non-
ducted recirculation Filter before replacing the grid (see section
“Non-ducted recirculation filter installation”).
6. Replace the grid after wiring is completed.
ROOF CAP
ROUND
DUCT
POWER
MODULE
WALL
CAP
7”
ROUND
ELBOW
24” TO 30” ABOVE
COOKING SURFACE
10-1/4”
CUT A HOLE IN THE BOTTOM OF THE CABINET
19-1/2”
FIG. 1
FIG. 2
FIG. 4
METAL WIRES
CONNECT DUCTWORK
Ducted Configuration
1. Use 7” round metal duct to connect the discharge collar on the
hood to the ductwork above. An optional 7” round damper may be
used (purchased seperately).
2. Use to make all joints secure and air tight.duct tape
Non-Ducted Recirculation Configuration
1. Connect a 7” round metal duct to the discharge opening so that
the air is sent outside the cabinet and sent back into the room.
2. Use to make all joints secure and air tight.duct tape
LATERAL
WIRING FIELD
COVER
FIG. 5
GRID
FIG. 3
METAL LINER
FIG.3A
MAINTENANCE
ALWAYS SWITCH OFF THE ELECTRICITY SUPPLY BEFORE CARRYING
OUT ANY OPERATIONS ON THE APPLIANCE.
Grease Filter
The grease filter should be cleaned frequently. Use a warm detergent
solution. Grease filter is dishwasher safe.
To remove the grease filter: remove the (4) screws and take off the
metal grid. Take off the metal wires and remove the grease filter.
Non-Ducted Recirculation Filter
The Non-Ducted Recirculation filter should be changed every 6 months.
To remove the Non-Ducted Recirculation filter:
1. Remove the grid taking off the (4) “A” screws 3.9x6mm (Fig. 3).
2. Remove the metal wires (Fig. 4) and replace the Non-ducted
recirculation Filter.
Cleaning
Occasional care will help preserve its fine appearance.
• Clean with warm water and mild detergent only.
• Follow all cleaning by rinsing with clear water.
• Wipe dry with clean, soft cloth.
Light bulbs
This range hood requires two 40-Watt light bulbs (not included).
To change bulbs:
1. Remove the 2.9x9.5mm screw securing the light fitting.
2. Pull down lens to remove.
3. Replace with light bulbs of the same type (MAX 40W, 120V,
Candelabra Base Bulb). CAUTION: BULB MAY BE HOT!
SERVICE PARTS
KEY NO. PART NO. DESCRIPTION
5 97018550 Grid (Silver)
9 99010370 Grease Filter
23 B03295095 Upper Lampholder
24 B03295094 Lower Lampholder
27 98010831 Metal Wire
28 B02300280 Lampholder
29 B03294757 Light Fitting
230 98010828 Controls Closing
236 99030347 Blower Switch (Black)
237 99030342 Light Switch (Black)
332 98010834 Cover Controls
415 99400048 Strain Relief Bushing
Not shown 97018559 Hardware Package
CAS R730090 Blower Assembly
- 97018557 Socket Assembly
(Includes key No.24, 23, 28)
- - “40 Watt Max.Candelabra
Bulbs not included”
- B08999040 Non-Ducted Filter Kit
(purchased separately)
GREASE
FILTER
METAL WIRES
FIG. 7
FIG. 8
FIG. 6
OPERATION
Controls
Light switch: turns the lamps on and off.
Blower switch: makes it possible to select the motor operating
speed.
ON
OFF
HI
LO
OFF

Termékspecifikációk

Márka: Broan
Kategória: Páraelszívó
Modell: PM250

Szüksége van segítségre?

Ha segítségre van szüksége Broan PM250, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók Páraelszívó Broan

Broan

Broan Elite E6030SSM Útmutató

6 Január 2025
Broan

Broan Elite E6430SSM Útmutató

6 Január 2025
Broan

Broan Elite RMIP45 Útmutató

30 Augusztus 2024
Broan

Broan Elite 619004 Útmutató

30 Augusztus 2024
Broan

Broan BWS1304SS Útmutató

30 Augusztus 2024
Broan

Broan EWS1306BLS Útmutató

30 Augusztus 2024
Broan

Broan BWP1304SS Útmutató

30 Augusztus 2024
Broan

Broan PM250 Útmutató

30 Augusztus 2024
Broan

Broan Elite 614804EX Útmutató

30 Augusztus 2024
Broan

Broan BWP1364SS Útmutató

30 Augusztus 2024

Útmutatók Páraelszívó

Legújabb útmutatók Páraelszívó

MPM

MPM -60-OVS-27 Útmutató

8 Január 2025
La Germania

La Germania KIN52PRO1XD Útmutató

8 Január 2025
La Germania

La Germania KIN70PRO1XD Útmutató

8 Január 2025
Arçelik

Arçelik ADE 907-2 D Útmutató

8 Január 2025
Arçelik

Arçelik ADE 907-2 B Útmutató

8 Január 2025
Arçelik

Arçelik ADP 604 RB Útmutató

8 Január 2025
Miele

Miele HR 1134-1 G Útmutató

7 Január 2025
Miele

Miele DAR 1220 Útmutató

7 Január 2025
Miele

Miele HR 1956-2 DFGD Útmutató

7 Január 2025
Pando

Pando P-1001 Útmutató

7 Január 2025