Használati útmutató Boska Unika+

Boska vágógép Unika+

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Boska Unika+ (32 oldal) a vágógép kategóriában. Ezt az útmutatót 7 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/32
864112 GOL20M 1
INSTALLATION & USE
1 Remove the blade cover. Please note: the blade is sharp!
2 Plug the transformer into the socket (230v~50hz).
3 Set the temperature yourself with the temperature control, from level 1 to 10.
The knife is warm within 5-10 minutes.
4 Lay the cheese to be sliced with the rind against the clamping plate and the light yellow,
edible part of the cheese against the thickness regulator. Please note: do not press the cheese
against the thickness regulator; place the cheese against it and the blade will do the rest.
5 Adjust the knobs to obtain the desired slice thickness (max 15mm). To minimize slicing loss,
cut wedge-shaped slices;
5A Set the adjusting knob at the edge of the rind higher than the adjusting knob further away
from you, so that the cheese is nicely round-cut and you are not left with any unsalable pieces.
6 Bring the lever down to cut off a slice of cheese.
7 Turn the temperature controller off.
8 Turn the adjusting knobs back to 0 to prevent cuts.
EN
Unika +
CLEANING
Make sure the temperature controller is turned off, the adjusting knobs are back to 0, the
plug has been removed from the socket and the appliance has cooled down fully.
The Unika+ should be cleaned daily.
Clean the Unika+ before you change to a different type of cheese, to prevent
cross-contamination.
Use hot water, a soft brush and a neutral cleaning agent such as mild soap or washing-up
liquid to clean the Unika+.
Make sure that the water is no hotter than 70°C to prevent damage to the plastic
components.
Never clean with a hard-bristle brush, abrasive materials, cleaning agents containing
baking soda or chlorine, or disinfecting or corrosive cleaning agents.
Rinse the Unika+ with clean water. Dry the machine thoroughly, to prevent components
from being damaged by dust and moisture.
After cleaning, put the cover back on the blade.
2 864112 GOL20M
Unika +
EN
1 2 3
4 5 5A
6 7 8
864112 GOL20M 3

Termékspecifikációk

Márka: Boska
Kategória: vágógép
Modell: Unika+

Szüksége van segítségre?

Ha segítségre van szüksége Boska Unika+, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók vágógép Boska

Útmutatók vágógép

Legújabb útmutatók vágógép