Használati útmutató Audio-Technica ATW-3255

Audio-Technica nincs kategorizálva ATW-3255

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Audio-Technica ATW-3255 (66 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 7 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/66
3000 Series
Wireless In-Ear Monitor System
User Manual
English
2
Important information
The product is intended for commercial use, not for general use.
Warning
To prevent fire or shock hazard, do not expose this apparatus to rain or moisture.
Caution
Do not expose this apparatus to drips or splashes.
To avoid electric shock, do not open the cabinet.
Refer servicing to qualified personnel only.
Do not expose this apparatus to excessive heat such as sunshine, fire or the like.
Do not subject this apparatus to strong impact.
This apparatus should be located close enough to the AC outlet so that you can easily grasp the AC adapter at any
time.
In case of emergency, disconnect the AC adapter quickly.
Do not place any objects filled with liquids, such as vases, on this apparatus.
To prevent fire, do not place any naked flame sources (such as lighted candles) on this apparatus.
Keep the product out of the reach of small children. The product is not intended for use around children.
Do not place the product near fire to avoid an accident or the product catching fire.
Do not install this apparatus in a confined space such as a bookcase or similar unit.
Install this apparatus only in the place where ventilation is good.
The rating label is put on the bottom of this apparatus.
It is desirable that the transmitter should be installed and operated keeping it at least 20 cm or more away from
person’s body.
Battery caution
Keep batteries out of the reach of children.
Observe correct polarity as marked.
Do not expose the battery to excessive heat such as sunshine, fire or the like.
Always consider the environmental issues and follow local regulations when disposing of batteries.
Remove depleted battery immediately.
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
Use only disposable LR06 (AA) alkaline or Ni-MH batteries.
Do not use new and old batteries at the same time.
Do not use different battery types or models.
Do not use a leaking battery. If battery leakage occurs, avoid contact with skin. If contact occurs, immediately wash
thoroughly with soap and water.
If battery leakage comes into contact with your eyes, immediately flush with water and seek medical attention.
Important information
3
For customers in the USA
FCC Notice
Warning:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Caution:
You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to
operate this equipment. A license is required to use the frequency bands under FCC Part 74.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
− Reorient or relocate the receiving antenna.
− Increase the separation between the equipment and receiver.
− Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
− Consult the dealer or an experienced radio/TV technician for help.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter used in other
systems.
RF Exposure Statement
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC
radio frequency (RF) Exposure Guidelines. This equipment has very low levels of RF energy that is deemed to comply
without testing of specific absorption rate (SAR).
Contact:
Responsible Company: Audio-Technica U.S., Inc.
Address: 1221 Commerce Drive, Stow, Ohio 44224, USA
Tel: 330-686-2600
Important information
4
For customers in Canada
ISED statement
CAN RSS-Gen/CNR-Gen
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.
This device complies with RSS-102 radiation exposure limits set forth for an uncontrolled environment.
5
Notes on use
Be sure to read the user manual for any microphone or cable that you attach to the product.
Unplug the AC adapter from the power outlet when not using the product.
Turn off the power of this product before connecting or disconnecting cables.
If you use the product near a TV or radio antenna, noise may be generated in the TV or radio. If this occurs, move the
product away from the device.
Two waves of the same frequency can't be used simultaneously.
Be careful of interference noise caused by the surrounding radio wave environment and use of multiple systems.
Wireless systems may be affected by the spark noise of vehicles, dimmer of lighting apparatus, computers, office
automation apparatus and electronic musical instruments. Place and use the product where it is less likely to be
affected by the above.
Be sure to use the product in combination with components specified by Audio-Technica.
Be sure to use a general-purpose LAN that complies with the Ethernet standard (CAT5e or higher, with shielding is
recommended).
Disconnect the LAN cable when not using the network.
Be sure the connected cable is plugged all the way into the product.
If you use the product close to an electronic or communications device (such as a mobile phone), the product may
produce unwanted noise. If this occurs, move the product away from the device.
When installing the product, ensure that there are no obstacles between the receiver and transmitter that may block
the signal.
To prevent depletion of the batteries/rechargeable batteries, turn off the receiver after use or when not in use.
Over time, discoloration may occur due to ultraviolet rays (especially direct sunlight) and friction.
It is legally prohibited to dismantle and modify this product. In addition, this product is so precisely manufactured
that dismantling it could cause electric shock, failure, or fire. Never dismantle this product.
Using multiple wireless systems
When using multiple units at the same time, use them in the same group and channel.
When multiple units are used simultaneously, the receiver and transmitter should be at least 3 m (9.8') apart.
When using multiple units, turn on receivers one by one, making sure there is no unwanted noise.
6
About Hearing Damage
WARNING!
USE AS LOW A VOLUME AS POSSIBLE. PERMANENT HEARING DAMAGE CAN RESULT FROM USING THIS SYSTEM
AT EXCESSIVE VOLUMES.
For safe operation of this in-ear monitor system, do not listen at excessive sound pressure levels.
Most national safety and health administrations have established guidelines for maximum time being exposed to sound
pressure levels before hearing damage occurs.
Sound pressure levels (SPL) Maximum time being exposed
85 dB (A) SPL 8 hours
88 dB (A) SPL 4 hours
91 dB (A) SPL 2 hours
94 dB (A) SPL 1 hour
97 dB (A) SPL 30 minutes
100 dB (A) SPL 15 minutes
120 dB (A) SPL avoid or hearing damage may occur
In live settings it is difficult to make exact measurements of sound pressure levels (SPL) present at the eardrum, which is
affected not only by the in-ear monitor volume, but by ambient sound on the stage and other factors.
To protect your ears from hearing damage:
Use the in-ear monitor system at the lowest volume possible; turn up the volume only enough to hear.
Be aware that ringing in your ears may indicate that the volume is set too high.
Have your ears examined regularly by an audiologist.
If wax builds up in your ears, stop using the in-ear monitor system until you have seen an audiologist.
To avoid infections, use an antiseptic to wipe the earphones before and after using the system.
Stop using the earphones if you experience ear discomfort or infection.
7
Maintenance
If the product becomes stained or covered with dust, be sure to disconnect the power plug before wiping it off with a
dry and soft cloth.
Do not use benzene, thinner, or electrical contact cleaner, etc. Doing so may cause deformation, damage, or
malfunction.
9
Part names and functions
ATW-T3205 (Stereo Transmitter)
Front panel
1 2 543
1
Power button
Turns transmitter on or off.
2
IR sync window
Used for IR SYNC with receiver.
3
Display
Displays the transmitter status and settings.
4
BACK button
Press to take the display back one screen.
Press and hold (about 2 seconds) on the main screen to toggle RF OFF (turning on while pressing and holding the
BACK button will start the transmitter in RF OFF mode).
Press and hold on the menu screen to return to the main screen.
5
Control dial
Press to display the setting menu. Turn the control dial to select a setting item and press to confirm.
Press and hold (about 2 seconds) to display the “RX SYNC” screen.
Rear panel
1 2 3 5 64
Part names and functions
13
1
A2DC connector plug
2
Housing
3
Cable adjustment slider
4
1.6 m (5.2') detachable cable
5
Input plug (3.5 mm (1/8”) gold-plated stereo mini-plug (L-shaped))
6
LEFT/RIGHT (L/R) indicator
7
Eartip
Replacing the detachable cable
The cable on the ATH-E40 is detachable. If there are signs of deterioration, replace the cable (sold separately). Do not
detach the cable except when replacing it with a new cable.
1
2
1
Headphone
2
Cable
How to detach the cable
Hold the connector and pull straight out in the direction shown by the arrow.

Termékspecifikációk

Márka: Audio-Technica
Kategória: nincs kategorizálva
Modell: ATW-3255

Szüksége van segítségre?

Ha segítségre van szüksége Audio-Technica ATW-3255, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók nincs kategorizálva Audio-Technica

Audio-Technica

Audio-Technica ATW-DA2218 Útmutató

28 December 2024
Audio-Technica

Audio-Technica ATLK-EXT165 Útmutató

7 December 2024
Audio-Technica

Audio-Technica AT-VMN95ML Útmutató

7 December 2024
Audio-Technica

Audio-Technica AT-VMN95C Útmutató

7 December 2024
Audio-Technica

Audio-Technica AT-SUT1000 Útmutató

7 December 2024
Audio-Technica

Audio-Technica AT-HDSL2 Útmutató

7 December 2024
Audio-Technica

Audio-Technica AT-OC9XSL Útmutató

7 December 2024
Audio-Technica

Audio-Technica AT-LH18H Útmutató

7 December 2024
Audio-Technica

Audio-Technica AT-MONO3/SP Útmutató

7 December 2024
Audio-Technica

Audio-Technica AT33EV Útmutató

7 December 2024

Útmutatók nincs kategorizálva

Legújabb útmutatók nincs kategorizálva

MOZA

MOZA SR-P Útmutató

10 Április 2025
Soundstream

Soundstream VRN-64HBL Útmutató

10 Április 2025
Panasonic

Panasonic Lumix DMW-AC11 Útmutató

10 Április 2025
Planet

Planet PWR-240-48 Útmutató

9 Április 2025
CaterChef

CaterChef 445001 Útmutató

9 Április 2025
IFM

IFM E40581 Útmutató

9 Április 2025
Livn

Livn Bolt Útmutató

9 Április 2025
Livn

Livn Beats Útmutató

9 Április 2025
Alpine

Alpine DP2-40C-BC Útmutató

9 Április 2025
IFM

IFM O3R252 Útmutató

9 Április 2025