Használati útmutató American International HYNK1118

Olvassa el alább 📖 a magyar nyelvű használati útmutatót American International HYNK1118 (8 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 3 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/8
HYN-K1118
2001-05 Hyundai Elantra
2001-05 Hyundai Santa Fe
2003-05 Hyundai Tiburon
2002-05 Hyundai Sonata
RADIO MOUNTING KIT
INSTALLATION INSTRUCTIONS
©2004 AMERICAN INTERNATIONAL INDUSTRIES, INC.
Ver. 9/04
1.) Remove the ashtray.
2.) Remove the (2) phillips screws from the ashtray location.
3.) Remove the (2) phillips screws from above the instrument gauges.
4.) Lower the steering wheel all the way down.
5.) Carefully remove the dash trim bezel from around the
Radio/Climate controls.
6.) Disconnect all harnesses from the Radio/Climate control trim bezel
and remove the trim bezel.
7.) Remove the (6) phillips screws securing the Radio to the sub-dash.
8.) Pull the Radio forward, disconnect the wire harness and antenna
lead from the radio and remove radio.
1.) Remove the ashtray.
2.) Remove the (2) phillips screws from the ashtray location.
3.) Carefully unsnap and pull forward the climate control unit.
4.) Disconnect the harnesses from the climate control unit and remove
climate control unit.
5.) Remove the (2) phillips screws from the bottom edge of the Radio
trim bezel.
6.) Gently lift upward on the bottom edge of the radio trim bezel
to release.
7.) Gently pull the top of the radio trim bezel forward to release.
8.) Disconnect all harnesses from the radio trim bezel and remove
trim bezel.
9.) Remove the (4) phillips screws securing the Radio to the sub-dash.
10.) Pull the Radio forward, disconnect the wire harness and antenna
lead and remove the radio.
DASH DISASSEMBLY
2001-05 HYUNDAI ELANTRA
DASH DISASSEMBLY
2001-05 HYUNDAI SANTA FE
1
2
1.) Attach the left and right ISO mount brackets to the kit.
(see illustration below)
2.) Slide the radio in to the kit from the rear and attach the radio to the
mounting brackets using the screws supplied with your new radio.
(do not tighten screws)
3.) Attach the ISO trim ring to the front of the installation kit.
4.) Adjust the radio forward or backward for desired look, and tighten
the ISO mounting screws.
Do not attach the ISO Brackets
1.) Slide the metal sleeve from your new radio into the installation kit
and bend the tabs on the sleeve upward, outward, and downward
to secure the sleeve to the kit.
NOTE: The ISO trim ring included in this kit must be used in place of
the aftermarket Radio’s trim ring if the aftermarket radio’s trim
ring is removable. (See your owner’s manual for radio trim ring
removal instructions)
RADIO & KIT ASSEMBLY INSTRUCTIONS
ISO MOUNT APPLICATIONS
DIN MOUNT APPLICATIONS
Left
ISO Mount
Brackets
ISO Trim Ring
Shaft Type
Radio Inserts
Right

Termékspecifikációk

Márka: American International
Kategória: nincs kategorizálva
Modell: HYNK1118

Szüksége van segítségre?

Ha segítségre van szüksége American International HYNK1118, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók nincs kategorizálva American International

Útmutatók nincs kategorizálva

Legújabb útmutatók nincs kategorizálva