Használati útmutató Adastra Z5M

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Adastra Z5M (4 oldal) a keverőpult kategóriában. Ezt az útmutatót 4 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/4
953.019UK User Manual
Z5M
Zoning Mixer
Item ref: 953.019UK
User Manual
Version 1.1
Caution: Please read this manual carefully before operating
Damage caused by misuse is not covered by the warranty
953.019UK User Manual
Introduction:
Thank you for choosing this Adastra zoning mixer. The Z5M is a professional 1U mixer offering many features
to give versatile control for up to 5 stereo output zones. In order to achieve the best results from this
equipment and avoid damage through misuse, please read and follow these instructions and retain for future
reference.
Warning:
To prevent the risk of fire or electric shock, do not expose any part of the unit to rain or moisture.
If liquids are spilled on the surface, stop using immediately, allow unit to dry out and have checked by
qualified personnel before further use.
Avoid impact, extreme pressure or heavy vibration to the unit.
There are no user serviceable parts inside the Z5M refer all servicing to qualified service personnel.
Safety
Check that the supplied mains lead is in good condition and the supply voltage is correct.
Ensure signal leads are of good condition and connected to appropriate inputs/outputs
Do not allow any foreign particles to enter the unit through control or connector apertures
Placement
Keep out of direct sunlight and away from heat sources.
Keep away from damp or dusty environments.
When rack-mounting, avoid placing heavy units above the unit and ensure all connectors and controls are
accessible
Cleaning
Use a soft cloth with a neutral detergent to clean the casing as required
Use a soft brush to clear debris from the control surface
Do not use strong solvents for cleaning the unit.
953.019UK User Manual
Front Panel
Rear Panel
Applications
The Z5M can be used for any multi-output setup and is ideally suited to controlling a multi-room zoning sound
system with up to 5 stereo or mono zones. Individual zones can be selected as mono if speaker placement is
not conducive to stereo imaging. 2 separate stereo inputs can be selected or blended at will for each zone,
opening up the possibility of separate program material for specific zones.
Connection
All connections are via balanced XLR and operate at line level. Use good quality XLR signal leads to connect
the source signals to LINE 1 and LINE 2 inputs. Each output should be connected to the respective amplifier
or active speakers for the particular zone, again using good quality XLR signal leads. Connect mains using the
supplied IEC lead.
6. LINE 2 left & right inputs (balanced XLRF)
7. LINE 1 left & right inputs (balanced XLRF)
8. ZONES 1 to 5 left & right outputs (balanced XLRM)
9. IEC mains inlet and fuse
1. POWER switch and indicator
2. LINE 1 source volume controls for each zone
3. MONO mode switch and indicator for each zone
4. LINE 2 source volume controls for each zone
5. LINE 1 and 2 signal indicators

Termékspecifikációk

Márka: Adastra
Kategória: keverőpult
Modell: Z5M

Szüksége van segítségre?

Ha segítségre van szüksége Adastra Z5M, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók keverőpult Adastra

Adastra

Adastra RX45 Útmutató

29 Augusztus 2024
Adastra

Adastra CM30B Útmutató

16 Augusztus 2024
Adastra

Adastra Z5M Útmutató

9 Augusztus 2024
Adastra

Adastra DM25 Útmutató

9 Augusztus 2024

Útmutatók keverőpult

Legújabb útmutatók keverőpult