Használati útmutató Zempire Aerodome III
Olvassa el alább 📖 a magyar nyelvű használati útmutatót Zempire Aerodome III (2 oldal) a sátor kategóriában. Ezt az útmutatót 6 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra
Oldal 1/2
INSTRUCTIONS
For a detailed description of all the features and specications
of this product please visit our website.
Tested in New Zealand. Made with care in China
IN THE UNLIKELY EVENT OF YOUR TENT DEVELOPING A LEAK
2. Firstly check all valves are screwed in correctly.
3. AERO-FRAMEDeflate the faulty and unzip the flysheet sleeve.
4. Remove the tube from the Outer by cutting the cable tie holding the zipper
ends together and unzip.
CAUTION: DO TO OPEN THESE ZIPS WHEN THE POLE IS INFLATED.
5. Remove the clear tube from the sleeve.
6. Partially inflate the tube and check for leaks (bubbles) in a basin of water.
7. Using the repair patch provided cover the hole and seal.
8. Partially inflate the tube and re insert into the pole sleeve. Zip together.
9. Connect the zipper ends with the replacement Cable ties provided.
INNER TENT ATTACHMENT
1. Lay out the inner inside the tent with
the door facing the center and the black
floor facing downwards.
2. Attach the buckles at the rear corners
of the tent and connect the toggles on
the inner through the corresponding rings
working your way from the rear to the
front.
3. The room can remain attached when
deflating the tent.
INSTRUCTIONS
12. It is recommended that guy ropes are
pegged out at all times and windows are
opened whenever possible to allow
adequate ventilation.
Insert pegs at a 45o angle
3. Unzip the triangle Valve Cover
on the Right hand side of the tent
and locate the AERO-FRAME
valves.
1. Clear your site making sure there are no sharp
objects where you are going to pitch your tent. Try
to get a site that is as flat as possible. Spread tent
out, the PVC windows are located at the front.
2. Peg out the 4 peg points on the main body of the
tent as shown.
4. Remove the valves completely and re-screw in to ensure the valve is not
cross-threaded. Screw in firmly but do not over tighten. Open the valve caps.
5. The Pump features a double hose adapter
which allows two tubes to be inflated at the
same time.
Ensure the pump is configured as per the
following diagram.
Attach the of the hoses to the AERO-FRAME
valve inlets.
6. AERO-FRAME. Begin to inflate the center and left hand side
Have someone walk inside to help raise the frame during
inflation. Inflate to 7 PSI.
DO NOT INFLATE ABOVE 8PSI. THIS MAY CAUSE DAMAGE
TO THE POLES AND THE TENT.
7. Once inflated to the correct pressure, remove the pump hoses and securely attach
the valve caps. Close the Valve Cover.
8. Inflate the Rear and the Right
Hand Side Room AERO-FRAME
following the same procedure as
above, then remove the hose and
securely attach the valve caps.
Finally inflate the Front Awning
AERO-FRAME.
9. Peg out the remaining peg points around
the tent ensuring that the floor sits flat. It is
easier to align the front door correctly with
the door closed.
10. Peg out the front and room anchor
webbings. These should sit at a 45o angle to
the ground.
DEFLATION
1. AERO-FRAME.Remove the valves from the Take care as poles will be under
pressure.
2. AERO-FRAME It may be necessary to remove some excess air from the
before rolling up your tent. This can be done by carefully walking down the
length of the tube towards the valve end.
PSI0
1
2
3
456
7
8
9
10
INFLAT E
DEF LAT E
DOUBLE ADAPTER
PRESSURE GAUGE
PRESSURE RELEASE VALVE
Valve Cover
Peg
points
PSI0
1
2
3
456
7
8
9
10
Peg
points
Room
Anchor
Webbings
Front
Anchor
Webbings
FRONT
Draft Vents
11. Peg out the 6 draft vents on either side
of the bedrooms. These can be pegged
closed during cooler weather conditions.
Valve Cover
Valve Covers
Termékspecifikációk
| Márka: | Zempire |
| Kategória: | sátor |
| Modell: | Aerodome III |
Szüksége van segítségre?
Ha segítségre van szüksége Zempire Aerodome III, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek
Útmutatók sátor Zempire
19 Augusztus 2024
19 Augusztus 2024
19 Augusztus 2024
19 Augusztus 2024
19 Augusztus 2024
19 Augusztus 2024
19 Augusztus 2024
19 Augusztus 2024
19 Augusztus 2024
19 Augusztus 2024
Útmutatók sátor
- sátor Ikea
- sátor Dometic
- sátor Philips
- sátor Bestway
- sátor Crivit
- sátor Hilleberg
- sátor Rollei
- sátor Gazebo Penguin
- sátor Wood's
- sátor Rocktrail
- sátor Thule
- sátor Babymoov
- sátor Velleman
- sátor Thermex
- sátor Outwell
- sátor SereneLife
- sátor Palmako
- sátor Sojag
- sátor Sunnydaze Decor
- sátor Wechsel
- sátor Eureka
- sátor Walker
- sátor De Waard
- sátor Obelink
- sátor Easy Camp
- sátor Vango
- sátor Ventura
- sátor Big Agnes
- sátor Vaude
- sátor Nomad
- sátor Sunny
- sátor Perel
- sátor Skandika
- sátor Black Diamond
- sátor OZtrail
- sátor Chinook
- sátor Jamet
- sátor Asaklitt
- sátor Jack Wolfskin
- sátor Kayoba
- sátor Camp Master
- sátor Sierra Designs
- sátor Trigano
- sátor Mx Onda
- sátor Isabella
- sátor Edges
- sátor Wynnster
- sátor Robens
- sátor Cabanon
- sátor Aart Kok
- sátor Coleman
- sátor Raclet
- sátor Goldcamp
- sátor Kelty
- sátor Vrijbuiter
- sátor Kathmandu
- sátor Trimm
- sátor Brunner
- sátor Sorara
- sátor MSR
- sátor Dwt-Zelte
- sátor Carl Denig
- sátor Holtkamper
- sátor LECO
- sátor TOOLPORT
- sátor Helsport
- sátor Robinhood
- sátor Gerjak
- sátor Casaria
- sátor High Peak
- sátor Nigor
- sátor Camp Trails
- sátor Hamron
- sátor Khyam
- sátor Black Wolf
- sátor Nordisk
- sátor Grand Canyon
- sátor San Hima
- sátor Mountain Hardwear
- sátor Calima
- sátor Yamazen
- sátor Outdoor Connection
Legújabb útmutatók sátor
9 Április 2025
1 Április 2025
31 Március 2025
30 Március 2025
30 Március 2025
30 Március 2025
30 Március 2025
30 Március 2025
30 Március 2025
30 Március 2025