Használati útmutató Yamaha NS-AW992

Yamaha hangszóró NS-AW992

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Yamaha NS-AW992 (2 oldal) a hangszóró kategóriában. Ezt az útmutatót 2 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/2
1 2
3
65
a
× 4
C
D
C
A B
10 mm
(3/8˝)
–
+
B
A
C
D
NS-AW992 (R) NS-AW992 (L)
– + – +
158
208 233
169.2
105
40.9
127
ø20
6×11
5.5×10
117
ø5.5
54
69.5
28
37
56
17
ø54
ø6
388
A
× 2
× 2
B
NS-AW992
OUTDOOR SPEAKER
ENCEINTE D’EXTERIEUR
UCG
©2009 Yamaha Corporation All right reserved.
Printed in Indonesia WT55050
Speaker output terminals
Bornes de sortie enceinte
Lautsprecherausgangs-
klemmen
Amplifier or receiver
Amplificateur ou récepteur
Verstärker oder Receiver [mm]
CONSUMER PRECAUTIONS
Read these precautions carefully before setting up your NS-AW992
speakers.
• When mounting these speakers, be sure to work with two or more
persons for safety.
• When installing these speakers outdoors, try to minimize their
exposure to rain and snow by mounting the speaker in corners or
under eaves.
• Since these speakers are to be wall / ceiling mounted, it is essential
that they are firmly secured. Be sure to consult a reliable source
about the best type of fastener for your particular wall / ceiling’s
construction.
• Do not attach them to thin plywood or soft wall / ceiling surface
materials as the screws may tear free, causing the speakers to fall
and be damaged, or result in personal injury.
• Do not fasten the speakers to wall / ceiling with nails, adhesives, or
other unsafe hardware. Long-term use and vibrations may cause
them to pull free.
• Do not place the speakers where they are liable to be knocked over
or struck by falling objects. Stable placement will also ensure better
sound performance.
• When changing the angle of the speakers, be sure to adjust the
angle after loosening the knob on the both sides. The speakers may
be damaged by excessive power.
• Lower the power amplifier / receiver volume control before changing
input sources. Always turn the amplifier / receiver unit off when
installing or removing input cables.
• Anytime you note distortion, reduce the volume control on your
power amplifier / receiver to a lower setting. Never allow your power
amplifier to be driven into “clipping”.
• Do not attempt to modify or fix the speakers. Contact qualified
Yamaha service personnel when any service is needed. The cabinet
should never be opened for any reasons.
• Do not attempt to clean the speakers with chemical solvents as this
might damage the finish. To clean wipe with a dry, soft cloth.
• Secure placement or installation is the owner’s responsibility.
Yamaha shall not be liable for any accident caused by improper
placement or installation of speakers.
After unpacking, please inspect contents to confirm all the following
items are contained.
ASpeaker × 2
BBracket × 2
CKnob × 4
To wall / ceiling mount the speakers, use the included bracket.
AUsing the bracket as a template mark the locations (four points) of
the key hole slots on the mounting area.
BUsing appropriate hardware (not included) securely fasten the
bracket to the wall / ceiling.
CPosition the speaker in the bracket and secure the speaker by
using the two knobs included.
DRotate the YAMAHA emblem according to the position of the
speaker.
When using the brackets to mount the speakers on a wall / ceiling,
please use safety wire (not included) between the speaker and the
bracket to prevent the speaker from falling. Please use safety wire
which withstand load
is 3.7 kg (8.2 lbs.) or
more.
Fix the safety wire with
M5 screw (inch screw: No. 10-32) by using the screw hole [diameter: 5
mm (1/4″), depth: 15 mm (5/8″)] at the rear of the speakers. For safety,
please confirm that installed screw is in the screw hole more than 10
mm (3/8″).
Before making connections, make sure that the amplifier / receiver is
switched off.
CONNECTIONS
• Connect the input terminals at the rear of the speakers to the
speaker output terminals of the amplifier / receiver with the speaker
cables (not included).
• Connect each speaker making sure not to reverse the polarity
“+” (red), “–” (black). If the speaker is connected with reversed
polarity, the sound will be unnatural and lack bass.
HOW TO CONNECT
ARemove approximately 10 mm (3/8″) of insulation from the end of
each speaker cable and twist the exposed wires of the cable
together to prevent short circuits.
BUnscrew the terminal knob.
CInsert one bare wire into the hole in the side of each terminal.
DTighten the terminal knob to secure the wire.
SPECIFICATIONS (For single speaker)
* Specifications subject to change without notice due to product
improvements.
English
1UNPACKING
2MOUNTING THE SPEAKERS
If speaker cable (not included) is being fed from a hole in the wall /
ceiling behind the bracket, pull this speaker cable through the hole in
the bracket before mounting the bracket [figure - ].
2 a
3CONNECTING YOUR AMPLIFIER / RECEIVER
Note: Do not let the bare speaker wires touch each other as this could
damage the speaker or amplifier / receiver, or both.
Type 2-Way Acoustic Suspension
Driver Tweeter 2.5 cm (1″) soft dome type
Woofer 20 cm (8″) cone type
Frequency response 50 Hz to 20 kHz (–10 dB)
Impedance 6 ohms
Nominal input 60 W
Maximum input 180 W
Sensitivity 90 dB / 2.83 V, 1 m
Crossover frequency 6 kHz
Dimension (W × H × D)
(excluding bracket and
knobs)
233 × 388 × 208 mm
(9-1/8″ × 15-1/4″ × 8-1/4″)
Weight (including bracket
and knobs) 4.15 kg (9.1 lbs.)
IP rating IPX3
Materials of the main
parts
Enclosure: HIPS
Punching grill: Aluminum (powder coating)
Bracket: Steel [t = 1.6 mm (1/16″)] (powder
coating)
Movable angle 10 degree pitch
Warranty policy for European Economic Area (EEA) and
Switzerland, Australia customer
In the unlikely event that your Yamaha product needs guarantee service,
please contact the dealer from whom it was purchased. If you experience
any difficulty, please contact Yamaha representative office in your country.
You can find full details on our website
EEA and Switzerland: (http://www.yamaha-hifi.com/ or http://
www.yamahauk.com/ for U.K. resident).
Australia: (http://www.yamahamusic.com.au/)
Warranty policy for U.S. and Canada customer
Your Yamaha product is covered by a limited warranty for two years from
the date of purchase. In the unlikely event of failure due to defective
materials or workmanship, Yamaha will repair or replace them at no
charge.
For full details, please see the included warranty card or visit our website.
U.S.: (http://www.yamaha.com/yec/), Canada: (http://www.yamaha.ca/)
Information for Users on Collection and Disposal of Old Equipment
This symbol specified in the Directives 2002/96/EC indicates
that used electrical and electronic products should not be
mixed with general household waste.
For proper treatment to avoid harmful effect on human health
and environment, please contact your local municipality, your
waste disposal service or the point of sale where you purchased the
items.

Termékspecifikációk

Márka: Yamaha
Kategória: hangszóró
Modell: NS-AW992

Szüksége van segítségre?

Ha segítségre van szüksége Yamaha NS-AW992, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók hangszóró Yamaha

Yamaha

Yamaha WX-010 Útmutató

15 Január 2025
Yamaha

Yamaha DXR15 MKII Útmutató

14 Január 2025
Yamaha

Yamaha NS-F 51 Útmutató

13 Január 2025
Yamaha

Yamaha CMA3SW Útmutató

10 Január 2025
Yamaha

Yamaha IF2112/64 Útmutató

10 Január 2025
Yamaha

Yamaha IF2115/99 Útmutató

10 Január 2025
Yamaha

Yamaha VXC2FB Útmutató

10 Január 2025
Yamaha

Yamaha VXC6W Útmutató

10 Január 2025
Yamaha

Yamaha VXC2P Útmutató

10 Január 2025
Yamaha

Yamaha VXC8-VA Útmutató

10 Január 2025

Útmutatók hangszóró

Legújabb útmutatók hangszóró

Match

Match UP C42BMW-FRT.3 Útmutató

3 Április 2025
Turbosound

Turbosound PQ12-SB Útmutató

3 Április 2025
Trust

Trust Tytan GXT 658 Útmutató

3 Április 2025
Turbosound

Turbosound PQ15-YB Útmutató

3 Április 2025
Klipsch

Klipsch Synergy KSB-S1 Útmutató

3 Április 2025
Klipsch

Klipsch Synergy KSF-10.5 Útmutató

3 Április 2025
Klipsch

Klipsch kO-R1 Útmutató

3 Április 2025
Klipsch

Klipsch Synergy SB-1 Útmutató

3 Április 2025
Klipsch

Klipsch Reference RB-5 II Útmutató

3 Április 2025
Klipsch

Klipsch Contractor CS-800-R Útmutató

3 Április 2025