Használati útmutató Vimar 01985.120

Vimar Dimmer 01985.120

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Vimar 01985.120 (1 oldal) a Dimmer kategóriában. Ezt az útmutatót 7 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/1
Viale Vicenza, 14 - 36063 Marostica VI Italy
Tel. +39 0424 488 600 - Fax (Italia) +39 0424 488 188 - Fax (Export) +39 0424 488 709
www.vimar.com
MASTER dimmer 120 V~ 60 Hz for incandescent lamps 40-500 W electronic
transformers 40-300 VA, CFL lamps 10-200 W, LED lamps 3-200 W, for LED
electronic power supplies, protection fuse, installation on DIN rails (60715
TH35), occupies 4 modules size 17.5 mm. For nautical scope.
ON/OFF switch and adjustment with two built-in buttons. MOSFET+TRIAC microprocessor
technology, works in both LE (Leading Edge) and TE (Trailing Edge) modes. MASTER function,
protection fuse. The device receives commands directly from the Busbar and is able to control
the load directly. It can also control up to 3 SLAVE dimmers for DIN rails 01986.120.
IMPORTANT: Lamps controllable from a single master or slave dimmer must all be the
same. All controllable loads must be declared DIMMERABLE by the manufacturer. Check
the type of compatible dimmering on the lamp package: LE (Leading Edge) or TE (Trailing
Edge). If it is not specified, the lamp can operate in both modes (chosen at the discretion
of the installer).
CHARACTERISTICS.
• RatedsupplyvoltageTPBusbar:29V
• Ratedsupplyvoltagemains:120V~,60Hz
• AbsorptionfromTPBusbar:15mA
• Dissipatedpower:7.8W
• Terminals:N neutral, load, phase, L Ssynchronization,TPBusbar
• ProtectionfusetypeF5AH250V
• Functionsthatcanbeaccomplishedwiththedimmer:
- Switching on, off and dimmering
- Changing absolute brightness
- Actuating/saving scenarios
- Enabling "Flash Start" mode for CFL lamps
- "Ramp" operation
- Switch-off delay and warning function
-Phasecutting:LE/TE
• Localcontrols:
Pressingthe button enables using the local buttons. All messages from the busbar are
ignored.
- Briefly pressing the button :ONcontrol
- Briefly pressing the button :OFFcontrol
-Pressingandholdingdownthebutton :Increasebrightness
-Pressingandholdingdownthebutton :Decreasebrightness
In normal operation (that is when the commands are sent over the bus) pressing the buttons
for the outputs is ignored.
• Protectionagainstshort-circuitingwhenturningonwithflashingblow-outindicator.
• Thermalprotectionwithflashingblow-outindicator.
• MASTER-SLAVE function: paying attention not to exceed maximum power controllable by
each dimmer. A MASTER device can have up to 3 SLAVE dimmers (art. 01986.120) for a
maximumtotalload of2000W(VA)correspondingto500W/VAmax connectedtoeachof
the 4 devices.
• InstallationonDINrails(60715TH35),occupies4modulesof17.5mm.
CONFIGURATION.
FOR THE OPERATIONS OF INSTALLATION AND CONFIGURATION, SEE THE BY-ME
SYSTEM INSTRUCTIONS MANUAL ATTACHED TO THE CONTROL PANEL.
Functionalunits:1;theunitcanbelongtoatmost4differentgroups.
• Selecting the functional unit (configuration): during group creation, when the control panel
requirespressingthedevicebutton:
-ItisrecommendedtoconfigurethedevicewiththeloadOFF;
-PresstheCONFbutton,theredLEDwilllightup;
- With the red LED on, the control panel will configure the functional unit; at the end of this
operation the red LED will go out.
Controllable loads LE TE
40 to 500 W 40 to 300 W
10 to 100 W 10 to 200 W(Max5lamps) (Max 10 lamps)
3 to 100 W 3 to 200 W(Max5lamps) (Max 10 lamps)
Electronic transformers
for halogen lamps
40 to 300 W
(Max 3 transformers type
L
)
40 to 300 W
(Max5transformerstype
C
)
Dimmering with Leading Edge mode Dimmering with Trailing Edge mode
INSTALLATION RULES.
Installation should be carried out in compliance with the current regulations regarding the instal-
lation of electrical systems in the country where the products are installed.
• Itshouldbeusedinplacesatatemperatureofbetween-5°Cand+45°C.
• Thelampsconnectedtothemasterorslavemustallbethesame.
• Notsuitableforcontrollingmotors(e.g.fans,ventilators).
Theratedpowerlevelshouldneverbeexceeded.
• Overloading, power surges and short-circuits may irreparably damage dimmers. Before
installation check the circuit carefully and eliminate any of the above causes.
• The dimmer does not have a mechanical circuit breaker in the main circuit and so is not
galvanically separated. The circuit load should be considered always powered.
For further instructions see the manual enclosed with the control panel.
CONFORMITY TO STANDARDS.
For MARINE use,thisdevicehasbeensubmittedtothefollowingtests:
IEC60068-2-52-TestKb:Saltmist,cyclic(sodium,chloridesolution),
IEC60068-2-6-TestFc:Vibration(sinusoidal)
Thisdevicecomplieswithpart15oftheFCC Rules (with the limits for a Class B digital device).
Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference
that may cause undesidered operation.
FRONT VIEW
CONNECTIONS
MaximumlengthofcablesconnectinguniversalMASTERdimmeranduniversalSLAVEdimmer:100m
Connect at least the minimum load required to the universal master dimmer.
A:IndicatorLED
B:Switchingonandincreasingbrightness
C:Switchingoffanddecreasingbrightness
D:LEDandconfigurationbutton
CHANGING FUSE
OFF
1.
01985.120
MASTER DIMMER
120V~
60Hz
40-50 0W LE
40-300W T E
CONF.
NLS
By-me
NLS
BUS
NLS
2.
01986.12001985.120 01986.120
N L S
TE Flash
Soft
LE
01986.120
SLAVE
DIMMER
40-500W LE
40-300W TE
120 V~ 60 Hz
N L S
TE Flash
Soft
LE
01986.120
SLAVE
DIMMER
40-500W LE
40-300W TE
120 V~ 60 Hz
N L S
01985.120
MASTER DIMMER
120 V~ 60 Hz
40-500W LE
40-300W TE
L
N
Bus
MASTER SLAVE SLAVE
A
B
C
D
BUS TP
LN
S
N L S
01985.120
MASTER DIMMER
120 V~ 60 Hz
40-500W LE
40-300W TE
01985.120
49400502A0011309
VIMAR - Marostica - Italy

Termékspecifikációk

Márka: Vimar
Kategória: Dimmer
Modell: 01985.120

Szüksége van segítségre?

Ha segítségre van szüksége Vimar 01985.120, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók Dimmer Vimar

Vimar

Vimar 20175 Útmutató

16 December 2024
Vimar

Vimar 19147 Útmutató

16 December 2024
Vimar

Vimar 19595.0 Útmutató

16 December 2024
Vimar

Vimar 16603.120.B Útmutató

16 December 2024
Vimar

Vimar 16604 Útmutató

16 December 2024
Vimar

Vimar 16609 Útmutató

16 December 2024
Vimar

Vimar 16625.B Útmutató

16 December 2024
Vimar

Vimar 16604.120.B Útmutató

16 December 2024
Vimar

Vimar 16601.B Útmutató

16 December 2024
Vimar

Vimar 16604.B Útmutató

16 December 2024

Útmutatók Dimmer

Legújabb útmutatók Dimmer

Hager

Hager TYA662AN Útmutató

13 December 2024
American DJ

American DJ DP-415R Útmutató

30 Szeptember 2024
ABB

ABB 2210UJ-214 Útmutató

15 Szeptember 2024
TP-Link

TP-Link HS200 Útmutató

14 Szeptember 2024
DiO

DiO 54767 Útmutató

12 Szeptember 2024
Sonoro

Sonoro Light Útmutató

5 Szeptember 2024
Ltech

Ltech CHLSC52 Útmutató

3 Szeptember 2024
Ltech

Ltech CHLSC39TX Útmutató

3 Szeptember 2024
Ltech

Ltech CHLSC41TX Útmutató

3 Szeptember 2024