Használati útmutató Velleman WS1070

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Velleman WS1070 (32 oldal) a Időjárás állomás kategóriában. Ezt az útmutatót 11 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/32
W
S1070
WIRELESS WEATHER STATION + DCF CLOCK AND OUTDOOR SENSOR
DRAADLOOS WEERSTATION + DCF-KLOK EN BUITENSENSOR
STATION MÉTÉO SANS FIL + HORLOGE DCF ET CAPTEUR EXTÉRIEUR
ESTACIÓN METEOROLÓGICA INALÁMBRICA CON RELOJ DCF Y SENSOR EXTERIOR
DRAHTLOSE WETTERSTATION MIT DCF-UHR UND AUßENSENSOR
USER MANUAL
GEBRUIKERSHANDLEIDING
NOTICE D’EMPLOI
MANUAL DEL USUARIO
BEDIENUNGSANLEITUNG
WS1070_v4 VELLEMAN 2
WS1070 WIRELESS WEATHER STATION + DCF CLOCK AND OUTDOOR SENSOR
1. Introduction & Features
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialized
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying the WS1070! This is a wireless weather station with DCF clock and outdoor sensor. Please read
the manual thoroughly before bringing this device into service. If the device was damaged in transit, don't install or use it
and contact your dealer. Note that damage caused by disregard of certain guidelines in this manual is not covered by
the warranty and the dealer will not accept responsibility for any ensuing defects or problems. Contents: 1 x base
station, 1 x remote outdoor sensor (including a thermo-hygro, rain and wind sensor), 2 x adjustable hoops, 2 plastic
arms and this manual.
2. Setting up Your Weather Station
Open the housing of the remote sensor to reveal the two sockets (wind and rain sensor).
Connect the cables of the wind and the rain sensor to the corresponding sockets.
Open the battery compartment of the outdoor sensor and insert 2 x AA alkaline batteries. Mind the polarity.
Open the battery compartment of the weather station and insert 3 x AA alkaline batteries. Mind the polarity.
Every time the outdoor sensor is powered up (after e.g. a battery replacement), the LED indicator will light for 4
seconds (if no LED lights, make sure the batteries are correctly inserted). The sensor will transmit data every 24
seconds after which it will start radio-controlled time reception. After the RCC time reception (± 5 minutes) no
data will be transmitted. The LED will blink 5x once the RCC signal is synchronized. Regular RF link will be
established once the RCC reception routine is finished.
When the weather station is powered up, a short beep will sound and all LCD segments will light for 3 seconds
before the station enters into the learning mode.
Do not press any key during the learning period (± 10 minutes). After both indoor and outdoor data is
displayed you can install the remote outdoor sensor and set the time (if no RCC reception is available). If there is
no temperature reading on the outdoor station make sure both units are within transmission range or check the
batteries. If you press a key before the weather station receives the temperature signal, take out the batteries and
reinstall them after ± 10 seconds.
Time and date are provided by a highly accurate atomic clock. Note that, whenever reception is possible, the
weather station will scan for the DCF radio signal and overwrite a manually set time and date.
3. Mounting the Units
a. The Base Station
Place the base station onto a flat surf the back of the unit. The unit can ace by deploying the foldable legs at
also be wall-mounted. It is important to check that the radio signal can be received before permanently
mounting both units.
WS1070_v4 VELLEMAN 3
b. The Outdoor Station
To achieve accurate results, the mast must be securely mounted onto a horizontal surface and in an open
area away from trees or other shelters. Check that the anemometer can rotate freely and that the wind can
reach the meter from all sides. Mount the sensors according to the pictures.
The Wind Sensor (fig. 1)
The Rain Sensor (fig. 2)
The Thermo-Hygro Sensor (fig. 3)

Termékspecifikációk

Márka: Velleman
Kategória: Időjárás állomás
Modell: WS1070

Szüksége van segítségre?

Ha segítségre van szüksége Velleman WS1070, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók Időjárás állomás Velleman

Velleman

Velleman WS9245 Útmutató

3 Szeptember 2024
Velleman

Velleman WS8707 Útmutató

11 Augusztus 2024
Velleman

Velleman WS8737 Útmutató

3 Augusztus 2024
Velleman

Velleman DVM8010 Útmutató

3 Augusztus 2024
Velleman

Velleman WS8472 Útmutató

1 Augusztus 2024
Velleman

Velleman WS1060 Útmutató

26 Július 2024
Velleman

Velleman WS2801 Útmutató

24 Július 2024
Velleman

Velleman WS3080 Útmutató

22 Július 2024
Velleman

Velleman DVM8020 Útmutató

21 Július 2024
Velleman

Velleman WS8471 Útmutató

19 Július 2024

Útmutatók Időjárás állomás

Legújabb útmutatók Időjárás állomás