Használati útmutató Vango Flux 300
Olvassa el alább 📖 a magyar nyelvű használati útmutatót Vango Flux 300 (1 oldal) a Tent kategóriában. Ezt az útmutatót 5 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra
Oldal 1/1
Flux
IF YOU HAVE ANY PROBLEMS PLEASE CONTACT YOUR LOCAL RETAILER or
AMG Group Ltd., Kelburn Business Park, Port Glasgow, Scotland. PA14 6TD.
UK Consumer Hotline: 0844 811 0535 E-Mail: info@vango.co.uk
Calls to our Customer Hotline cost 5p per minute. Calls from mobile phones, cable networks or public payphones will generally cost more.
INNER ATTACHMENT
• Open out inner tents inside ysheet and position
doorway to correspond with the living area.
• Starting from the rear corners of the tent, attach the
hooks on the inner groundsheet to
corresponding rings on the tent groundsheet.
• Suspend the inner by attaching toggles of inner tent
through rings on inside of ysheet. Do the rear rst
and work forward.
TENSION BAND SYSTEM
• When required, remove Tension Band System from
pockets and clip into the buckles in the ceiling of the
tent.
• Adjust the straps until they are taut but do not over-
tension.
TO DEFLATE THE AIRBEAM TENT
• Unscrew the valve fully from the beam, taking care as the
valve will be under pressure from the air inside the tube.
IN THE UNLIKELY EVENT OF A PUNCTURE
• Note: Most apparent punctures are a result of the valve
not being screwed in correctly. Please check valves
before changing AirBeam tube.
• eate the AirBeam. Unzip the internal ysheet sleeve D
which contains the aected beam.
• Remove the tube and its protective outer.
• The zips for the protective outer are cable tied together
to prevent accidental access. Cut the cable tie and open
the zip. DO NOT open these zips when tube is inated.
• Remove the clear rubberised tube from the protective
sleeve taking care when removing the valve from the
sleeve.
• Partially inate the tube and pass through a bucket or
basin of water, looking for air bubbles. This will indicate
location of puncture.
• Use the repair patch provided and cover hole, using
instructions on patch. Re-insert tube into protective
outer, closing zip from both ends, so that zip pullers are
in the centre of the sleeve, and then replace into the
ysheet sleeve. (This may be easier with the tube
partially inated)
FLYSHEET FIRST PITCHING/COMBINED PITCHING
• Unpack and position the tent in the required direction.
• Peg out the 4 corners using the pegs supplied.
• Locate inating points at the base of each beam.
• Access the beams through the zipped entry points and
through the side door.
• For the rst use of the tent, fully unscrew all valves from
the AirBeams and screw back in carefully - this ensures
that the valve is not cross-threaded.
• Remove smaller screw-cap on valve and insert largest
pump nozzle of the Vango AirBeam™ pump supplied.
• Inate all tubes to 7psi. The tubes MUST be guided into
an arch as they are inated.
• Final tube pressure MUST NOT exceed 8psi.
DO NOT OVER-INFLATE THE BEAMS
• Start with the centre tube and guide the beam into an
upright position while it is inating.
• Inate the other beams.
• Remove pump and tighten screw-cap. Ensure both parts
of valve are well tted so it is air tight but do not over
tighten.
• Ensure the tent is in a straight line. The groundsheet
should be at and wrinkle free.
• Secure the tent by pegging out the sides using all the
pegging points available.
• Peg out ALL the guy lines, ensuring that they are in line
with the beam or seam they are attached to.
• Re-position and adjust tensioning where necessary.
CORRECT PUMP SETUP
Pump Body -> Pressure Valve -> Pressure Gauge -> Hose
(Ensure Valve/Gauge/Hose are connected to Ination
port of pump)
CORRECT AIRBEAM VALVE SETUP
Ination Deation
Termékspecifikációk
Márka: | Vango |
Kategória: | Tent |
Modell: | Flux 300 |
Szüksége van segítségre?
Ha segítségre van szüksége Vango Flux 300, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek
Útmutatók Tent Vango
13 Szeptember 2024
30 Augusztus 2024
30 Augusztus 2024
30 Augusztus 2024
30 Augusztus 2024
30 Augusztus 2024
30 Augusztus 2024
30 Augusztus 2024
30 Augusztus 2024
30 Augusztus 2024
Útmutatók Tent
- Tent Ikea
- Tent Dometic
- Tent Bestway
- Tent Crivit
- Tent Hilleberg
- Tent Rollei
- Tent Gazebo Penguin
- Tent Wood's
- Tent Rocktrail
- Tent Thule
- Tent Babymoov
- Tent Outwell
- Tent SereneLife
- Tent Sojag
- Tent Wechsel
- Tent Eureka
- Tent Walker
- Tent De Waard
- Tent Obelink
- Tent Easy Camp
- Tent Ventura
- Tent Big Agnes
- Tent Vaude
- Tent Nomad
- Tent Perel
- Tent Skandika
- Tent Black Diamond
- Tent OZtrail
- Tent Chinook
- Tent Jamet
- Tent Asaklitt
- Tent Kayoba
- Tent Camp Master
- Tent Sierra Designs
- Tent Zempire
- Tent Trigano
- Tent Mx Onda
- Tent Isabella
- Tent Wynnster
- Tent Robens
- Tent Cabanon
- Tent Aart Kok
- Tent Coleman
- Tent Raclet
- Tent Goldcamp
- Tent Kelty
- Tent Vrijbuiter
- Tent Trimm
- Tent Brunner
- Tent MSR
- Tent Dwt-Zelte
- Tent Holtkamper
- Tent LECO
- Tent Robinhood
- Tent Gerjak
- Tent Camp Trails
- Tent Hamron
- Tent Khyam
- Tent Black Wolf
- Tent Nordisk
- Tent Grand Canyon
- Tent San Hima
- Tent Mountain Hardwear
- Tent Calima
Legújabb útmutatók Tent
8 Október 2024
8 Október 2024
7 Október 2024
5 Október 2024
2 Október 2024
1 Október 2024
1 Október 2024
1 Október 2024
1 Október 2024
1 Október 2024