Használati útmutató SPL Crescendo duo

SPL Vevő Crescendo duo

Olvassa el alább 📖 a magyar nyelvű használati útmutatót SPL Crescendo duo (6 oldal) a Vevő kategóriában. Ezt az útmutatót 6 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/6
Crescendoduo
120V Two Channel Microphone Preamplier
EN
Manual
Find more information: spl.audio
DE
Crescendo – Manualduo
Crescendo duo
Two-Channel Microphone Preamplier with
V Technology
The Crescendo features a fully balanced signal flow. The input stage uses duo
 pairs of matched PNP Transistors (Dierential Input Transistors) for extremely
low noise and a very high common mode rejection.
Both input stages have six th generation V SPL SUPRA Operation Ampliers
each.
The transformerless design of the input/output stages guarantees highly linear
amplifying.
The output stages operate as current ampliers and therefore provide Class-A
operation with more than 6mA quiescent current.
Start up
Read the security advices on page .
Make sure that the selected mains voltage of the Crescendo is according to duo
the mains voltage of your region.
Make sure that the mains switch on the rear of the Crescendo duo is set to O
(O = O / ON = I).
Connect the supplied power cord to the Crescendo and an appropriate duo
mains socket outlet.
If the supplied power cord does not match your mains socket outlet, please contact your dealer.
Please connect the outputs of the Crescendo to the inputs of your audio duo
interface or mixing console.
Connect your microphones to the inputs  and  of the Crescendo with duo
high-quality microphone cables.
Microphone cables not included in the scope of delivery.
Switch on mains on the rear of the Crescendo (On = I).duo
The VU meter light up.
1
2
3
4
5
6
7
Crescendo – Manualduo
Specications
Frequency range
-kHz (dB Gain) -dB
Mic pre amp gain
dB (in   dB steps) to
Output gain
+/ dB
Input impedance
 kOhm
Output impedance
<  Ohm
Noise (A-weighted)
(dB Gain) -. dBu
(dB Gain) - dBu
Noise FFT
(dB Gain) -dBu
(dB Gain) -dBu
CMRR
(dB Gain) > dBu/kHz
(dB Gain) > dBu/kHz
THD/N
(dB Gain) .%
(dB Gain) .%
(dB Gain) .%
E.I.N
(dB Gain)  Ohm -. dBu
(dB Gain)  Ohm -.dBu
Power consumption
 .V: W
 V: W
Fuses
 mA (Fast)V
 mA (Fast)V
The phantom power required for condenser microphones can be activated with
the V switch.
If phantom power is on, the V LED lights up blue.
IMPORTANT:
Use phantom power only for condenser microphones. For all other microphone types – especially
ribbon micorphones – switch o the phantom power!
Use the Mic Gain switch to adjust the preamplication gain in  dB steps.to
The Output Gain controls the output level from -  to + dB.
With the OUTPUT switch the signal can be completely switched o.
The polarity of a microphone signal can be inversed (°) with the Polarity
Inversal switch.
The High Pass switch activates a high pass lter with dB per ocatve at  Hz.
If the input signal is too hot, switch on PAD. This reduces the level by dB.
You can make the VU Meters less sensitive by activating the VU-dB switch.
Power down
Switch omains on the back of the Crescendo (O = O).duo
The VU Meter no longer light up.
8
9
10
11
12
13
14
15

Termékspecifikációk

Márka: SPL
Kategória: Vevő
Modell: Crescendo duo

Szüksége van segítségre?

Ha segítségre van szüksége SPL Crescendo duo, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók Vevő SPL

SPL

SPL Phonitor 2730 Útmutató

3 Szeptember 2024
SPL

SPL Director Útmutató

3 Szeptember 2024
SPL

SPL Crescendo 8 Útmutató

3 Szeptember 2024
SPL

SPL HPm Útmutató

3 Szeptember 2024
SPL

SPL Phonitor e Útmutató

3 Szeptember 2024
SPL

SPL Auditor Útmutató

3 Szeptember 2024
SPL

SPL HeadAmp 4 Útmutató

3 Szeptember 2024
SPL

SPL GainStation 1 Útmutató

15 Augusztus 2024

Útmutatók Vevő

Legújabb útmutatók Vevő